scholarly journals Discussion on the Factors Affecting the Stability of Microgrid Based on Distributed Power Supply

2013 ◽  
Vol 05 (04) ◽  
pp. 1344-1346 ◽  
Author(s):  
Ye Xu ◽  
Zhao-hong Shi ◽  
Jin-quan Wang ◽  
Peng-fei Hou
Keyword(s):  
Power Supply ◽  
Distributed Power ◽  
Factors Affecting ◽  
The Stability

Logic Design of Improved Backup Power Automatic Switching Considering the Influence of Small Hydropower Stations

2012 ◽  
Vol 463-464 ◽  
pp. 1638-1642
Author(s):  
Chen Jie Zhou ◽  
Yi Xiong ◽  
Liang Qin ◽  
Xiao Ming Zha
Keyword(s):  
Power Supply ◽  
Power Grid ◽  
Logic Design ◽  
Small Hydropower ◽  
Distributed Power ◽  
The Stability ◽  
Reliable Power Supply ◽  
Hydropower Stations ◽  
Small Capacity ◽  
Automatic Switching

The correct and quick operation of backup power automatic switching（BPAS）devices is an effective guarantee of reliable power supply to the system. However, when transformer substations are connected to small-capacity distributed power like the local small hydropower stations, the conventional BPAS devices usually fail to get into operation, which leads to the loss of power in some parts of the system. To solve this shortage，this article comes up with an improved scheme of BPAS, which has been proved through PSCAD simulation to be effective in enhancing the stability and reliability of the power grid

Study on Selective Leakage Protection System of Mine High Voltage Grid Based on Harmonic Phase Comparison

2015 ◽  
Vol 9 (1) ◽  
pp. 253-262
Author(s):  
Liu Zhongfu ◽  
Zhang Junxing ◽  
Shi Lixin ◽  
Yang Yaning
Keyword(s):  
High Voltage ◽  
Power Supply ◽  
Power Supply System ◽  
Supply System ◽  
Neutral Point ◽  
Arc Suppression Coil ◽  
Zero Sequence ◽  
Harmonic Extraction ◽  
Power Direction ◽  
The Stability

As for the wide application of arc suppression coil to the grounding in neutral point of mine high voltage grid, grid leakage fault rules and harmonic characteristics of the neutral point grounding system through arc suppression coil are analyzed, the selective leakage protection program “zero-sequence voltage starts, fifth harmonics of grid zerosequence voltage and zero-sequence current are extracted for phase comparison” is proposed, and corresponding fifth harmonic extraction circuit and power direction discrimination circuit are designed. The experimental results show that the protective principle applies not only to the neutral point insulated power supply system, but also to the power supply system in which neutral point passes arc suppression coil, which can solve selective leakage protection problems under different neutral grounding ways, improving the reliability of selective leakage and guaranteeing the stability of the action value.

Influence of distributed power supply in distributed power distribution network

2021 ◽  
pp. 1-8
Author(s):  
Xin Shen ◽  
Hongchun Shu ◽  
Min Cao ◽  
Nan Pan ◽  
Junbin Qian
Keyword(s):  
Power Supply ◽  
Power Distribution ◽  
Short Circuit ◽  
Power Grid ◽  
Distribution Network ◽  
Distribution Networks ◽  
Power Supplies ◽  
Power Distribution Network ◽  
Power Sources ◽  
Distributed Power

In distribution networks with distributed power supplies, distributed power supplies can also be used as backup power sources to support the grid. If a distribution network contains multiple distributed power sources, the distribution network becomes a complex power grid with multiple power supplies. When a short-circuit fault occurs at a certain point on the power distribution network, the size, direction and duration of the short-circuit current are no longer single due to the existence of distributed power, and will vary with the location and capacity of the distributed power supply system. The change, in turn, affects the current in the grid, resulting in the generation and propagation of additional current. This power grid of power electronics will cause problems such as excessive standard mis-operation, abnormal heating of the converter and component burnout, and communication system failure. It is of great and practical significance to study the influence of distributed power in distributed power distribution networks.

Design and Implementation of Mid-Frequency Magnetron Sputtering Power Supply Based on TL494 and MCU

2013 ◽  
Vol 709 ◽  
pp. 408-412
Author(s):  
Yan Ling Zhao ◽  
Rong Xing Liu
Keyword(s):  
Magnetron Sputtering ◽  
Power Supply ◽  
Current Mode ◽  
Voltage Regulation ◽  
Control Circuit ◽  
Constant Current ◽  
Loop Control ◽  
Pulse Width Modulator ◽  
Digital Pulse ◽  
The Stability

Abstract. A mid-frequency magnetron sputtering (MFMS) power supply based on TL494 and MCU was introduced. A Buck Chopper and full bridge inverter were applied to the main circuit. The PWM controller TL494 was used in the Buck voltage-regulation control circuit to realize closed loop control. The drive signal of the IGBT in full bridge inverter was based on precise digital pulse width modulator (DPWM) signal produced by the MCU M30290. The DPWM can be set by potentiometer so the power supply can output the square wave with adjustable frequency and duty cycle. The power supply was operated in constant current mode. For micro or strong arcing of the target, different safeguards were adopted by the control circuit. At last, the system test and experimental results show that the stability, reliability and tuning range of the MFMS power supply can meet the requirements of the magnetron sputtering coating.

A 1 kW 500 kHz front-end converter for a distributed power supply system

1991 ◽  
Vol 6 (3) ◽  
pp. 398-407 ◽  
Author(s):  
L.H. Mweene ◽  
C.A. Wright ◽  
M.F. Schlecht
Keyword(s):  
Power Supply ◽  
Power Supply System ◽  
Supply System ◽  
Distributed Power ◽  
Front End

Design of Electrostatic Precipitator Power System Based on Auto Disturbance Rejection Controller

2013 ◽  
Vol 846-847 ◽  
pp. 190-194
Author(s):  
Shu Jun Yin ◽  
Xue Ren Li ◽  
Ji Geng Luo
Keyword(s):  
Power Supply ◽  
Disturbance Rejection ◽  
Power Supply System ◽  
Electrostatic Precipitator ◽  
Supply System ◽  
System Stability ◽  
Engineering Practice ◽  
Single Chip ◽  
High Voltage Power Supply ◽  
The Stability

The paper designs a three-phase high voltage power supply system based on active disturbance rejection controller which make single-chip microcomputer ATmega128 as the main control chip and the system improve the stability and control precision of dust removing power. Engineering practice shows that, the DC power supply system has the advantages of convenient operation, high work efficiency, system stability.

CRITICAL REVIEW OF EMULSION STABILITY AND CHARACTERIZATION TECHNIQUES IN OIL PROCESSING

2021 ◽  
pp. 1-36
Author(s):  
Vahideh Angardi ◽  
Ali Ettehadi ◽  
Özgün Yücel
Keyword(s):  
Separation Efficiency ◽  
Petroleum Industry ◽  
Cost Effective ◽  
Downstream Processing ◽  
Physical Factors ◽  
Comprehensive Review ◽  
Factors Affecting ◽  
Mathematical Explanations ◽  
The Stability ◽  
The Right

Abstract Effective separation of water and oil dispersions is considered a critical step in the determination of technical and economic success in the petroleum industry over the years. Moreover, a deeper understanding of the emulsification process and different affected parameters is essential for cost-effective oil production, transportation, and downstream processing. Numerous studies conducted on the concept of dispersion characterization indicate the importance of this concept, which deserves attention by the scientific community. Therefore, a comprehensive review study with critical analysis on significant concepts will help readers follow them easily. This study is a comprehensive review of the concept of dispersion characterization and conducted studies recently published. The main purposes of this review are to 1) Highlight flaws, 2) Outline gaps and weaknesses, 3) Address conflicts, 4) Prevent duplication of effort, 5) List factors affecting dispersion. It was found that the separation efficiency and stability of dispersions are affected by different chemical and physical factors. Factors affecting the stability of the emulsions have been studied in detail and will help to look for the right action to ensure stable emulsions. In addition, methods of ensuring stability, especially coalescence are highlighted, and coalescence mathematical explanations of phenomena are presented.

Sign in / Sign up

Export Citation Format

Share Document