scholarly journals Nonlinear controls on evapotranspiration in arctic coastal wetlands

2011 ◽  
Vol 8 (11) ◽  
pp. 3375-3389 ◽  
Author(s):  
A. K. Liljedahl ◽  
L. D. Hinzman ◽  
Y. Harazono ◽  
D. Zona ◽  
C. E. Tweedie ◽  
...  
Keyword(s):  
Heat Flux ◽  
Vapor Pressure ◽  
Coastal Wetlands ◽  
Surface Resistance ◽  
Surface Soil ◽  
Surface Soil Moisture ◽  
Near Surface ◽  
Limited Ability ◽  
Bulk Surface ◽  
Evapotranspiration Rate

Abstract. Projected increases in air temperature and precipitation due to climate change in Arctic wetlands could dramatically affect ecosystem function. As a consequence, it is important to define controls on evapotranspiration, the major pathway of water loss from these systems. We quantified the multi-year controls on midday Arctic coastal wetland evapotranspiration, measured with the eddy covariance method at two vegetated, drained thaw lake basins near Barrow, Alaska. Variations in near-surface soil moisture and atmospheric vapor pressure deficits were found to have nonlinear effects on midday evapotranspiration rates. Vapor pressure deficits (VPD) near 0.3 kPa appeared to be an important hydrological threshold, allowing latent heat flux to persistently exceed sensible heat flux. Dry (compared to wet) soils increased bulk surface resistance (water-limited). Wet soils favored ground heat flux and therefore limited the energy available to sensible and latent heat flux (energy-limited). Thus, midday evapotranspiration was suppressed from both dry and wet soils but through different mechanisms. We also found that wet soils (ponding excluded) combined with large VPD, resulted in an increased bulk surface resistance and therefore suppressing evapotranspiration below its potential rate (Priestley-Taylor α < 1.26). This was likely caused by the limited ability of mosses to transfer moisture during large atmospheric demands. Ultimately, in addition to net radiation, the various controlling factors on midday evapotranspiration (i.e., near-surface soil moisture, atmospheric vapor pressure, and the limited ability of saturated mosses to transfer water during high VPD) resulted in an average evapotranspiration rate of up to 75% of the potential evapotranspiration rate. These multiple limitations on midday evapotranspiration rates have the potential to moderate interannual variation of total evapotranspiration and reduce excessive water loss in a warmer climate. Combined with the prevailing maritime winds and projected increases in precipitation, these curbing mechanisms will likely prevent extensive future soil drying and hence maintain the presence of coastal wetlands.

scholarly journals Nonlinear controls on evapotranspiration in Arctic coastal wetlands

2011 ◽  
Vol 8 (4) ◽  
pp. 6307-6344 ◽  
Author(s):  
A. K. Liljedahl ◽  
L. D. Hinzman ◽  
Y. Harazono ◽  
D. Zona ◽  
C. E. Tweedie ◽  
...  
Keyword(s):  
Vapor Pressure ◽  
Coastal Wetlands ◽  
Surface Resistance ◽  
Surface Soil ◽  
Heat Fluxes ◽  
Surface Soil Moisture ◽  
Near Surface ◽  
Limited Ability ◽  
Bulk Surface ◽  
Evapotranspiration Rate

Abstract. Projected increases in air temperature and precipitation due to climate change in Arctic wetlands could dramatically affect ecosystem functioning. As a consequence, it is important to define the controls on evapotranspiration, which is the major pathway of water loss from these systems. We quantified the multi-year controls on midday arctic coastal wetland evapotranspiration measured with the eddy covariance method at two vegetated drained thaw lake basins near Barrow, Alaska. Variations in near-surface soil moisture and atmospheric vapor pressure deficits were found to have nonlinear effects on midday evapotranspiration rates. Vapor pressure deficits near and above 0.3 kPa appeared to be an important hydrological threshold, allowing latent heat fluxes to persistently exceed sensible heat fluxes. Dry soils increased the bulk surface resistance (water-limited). Wet soils favored ground heat flux and therefore limited the energy available to sensible and latent heat fluxes (energy-limited). Thus, midday evapotranspiration was suppressed on both dry and wet soils through different mechanisms. We also found that wet soils (ponding excluded) combined with large atmospheric demands resulted in an increased bulk surface resistance and therefore suppressing the evapotranspiration to below its potential rate (Priestley-Taylor α < 1.26). This is likely caused by the limited ability of mosses to transfer moisture during large atmospheric demands. Ultimately, in addition to net radiation, the various controlling factors on midday evapotranspiration (near-surface soil moisture, atmospheric vapor pressure, and the limited ability of mosses that are saturated at depth to transfer water during high atmospheric vapor demands) resulted in an average evapotranspiration rate of up to 75 % of the potential evapotranspiration rate. The multiple limitations on midday evapotranspiration rates have the potential to moderate interannual variation of total evapotranspiration and dampen excessive water loss during a warmer climate. Combined with the prevailing maritime winds and the projected increase in precipitation, these dampening mechanisms will likely prevent extensive future soil drying and hence maintain the presence of coastal wetlands.

scholarly journals The impact of near-surface soil moisture assimilation at subseasonal, seasonal, and inter-annual timescales

2015 ◽  
Vol 19 (12) ◽  
pp. 4831-4844 ◽  
Author(s):  
C. Draper ◽  
R. Reichle
Keyword(s):  
Soil Moisture ◽  
Data Assimilation ◽  
Surface Soil ◽  
Root Zone ◽  
Surface Model ◽  
Surface Soil Moisture ◽  
Near Surface ◽  
In Situ Observations ◽  
The Impact

Abstract. A 9 year record of Advanced Microwave Scanning Radiometer – Earth Observing System (AMSR-E) soil moisture retrievals are assimilated into the Catchment land surface model at four locations in the US. The assimilation is evaluated using the unbiased mean square error (ubMSE) relative to watershed-scale in situ observations, with the ubMSE separated into contributions from the subseasonal (SMshort), mean seasonal (SMseas), and inter-annual (SMlong) soil moisture dynamics. For near-surface soil moisture, the average ubMSE for Catchment without assimilation was (1.8 × 10−3 m3 m−3)2, of which 19 % was in SMlong, 26 % in SMseas, and 55 % in SMshort. The AMSR-E assimilation significantly reduced the total ubMSE at every site, with an average reduction of 33 %. Of this ubMSE reduction, 37 % occurred in SMlong, 24 % in SMseas, and 38 % in SMshort. For root-zone soil moisture, in situ observations were available at one site only, and the near-surface and root-zone results were very similar at this site. These results suggest that, in addition to the well-reported improvements in SMshort, assimilating a sufficiently long soil moisture data record can also improve the model representation of important long-term events, such as droughts. The improved agreement between the modeled and in situ SMseas is harder to interpret, given that mean seasonal cycle errors are systematic, and systematic errors are not typically targeted by (bias-blind) data assimilation. Finally, the use of 1-year subsets of the AMSR-E and Catchment soil moisture for estimating the observation-bias correction (rescaling) parameters is investigated. It is concluded that when only 1 year of data are available, the associated uncertainty in the rescaling parameters should not greatly reduce the average benefit gained from data assimilation, although locally and in extreme years there is a risk of increased errors.

scholarly journals A Data-Driven Approach for Daily Real-Time Estimates and Forecasts of Near-Surface Soil Moisture

2017 ◽  
Vol 18 (3) ◽  
pp. 837-843 ◽  
Author(s):  
Randal D. Koster ◽  
Rolf H. Reichle ◽  
Sarith P. P. Mahanama
Keyword(s):  
United States ◽  
Soil Moisture ◽  
Real Time ◽  
Surface Soil ◽  
Data Driven ◽  
Surface Soil Moisture ◽  
Near Surface ◽  
Time Estimates ◽  
Data Driven Approach ◽  
Global Surface

Abstract NASA’s Soil Moisture Active Passive (SMAP) mission provides global surface soil moisture retrievals with a revisit time of 2–3 days and a latency of 24 h. Here, to enhance the utility of the SMAP data, an approach is presented for improving real-time soil moisture estimates (nowcasts) and for forecasting soil moisture several days into the future. The approach, which involves using an estimate of loss processes (evaporation and drainage) and precipitation to evolve the most recent SMAP retrieval forward in time, is evaluated against subsequent SMAP retrievals themselves. The nowcast accuracy over the continental United States is shown to be markedly higher than that achieved with the simple yet common persistence approach. The accuracy of soil moisture forecasts, which rely on precipitation forecasts rather than on precipitation measurements, is reduced relative to nowcast accuracy but is still significantly higher than that obtained through persistence.

scholarly journals Influence of cracking clays on satellite estimated and model simulated soil moisture

2010 ◽  
Vol 14 (6) ◽  
pp. 979-990 ◽  
Author(s):  
Y. Y. Liu ◽  
J. P. Evans ◽  
M. F. McCabe ◽  
R. A. M. de Jeu ◽  
A. I. J. M. van Dijk ◽  
...  
Keyword(s):  
Soil Moisture ◽  
Surface Temperature ◽  
Soil Properties ◽  
Surface Soil ◽  
Clay Soils ◽  
Soil Types ◽  
Soil Porosity ◽  
Surface Soil Moisture ◽  
Near Surface ◽  
Community Land Model

Abstract. Vertisols are clay soils that are common in the monsoonal and dry warm regions of the world. One of the characteristics of these soil types is to form deep cracks during periods of extended dry, resulting in significant variation of the soil and hydrologic properties. Understanding the influence of these varying soil properties on the hydrological behavior of the system is of considerable interest, particularly in the retrieval or simulation of soil moisture. In this study we compare surface soil moisture (θ in m3 m−3) retrievals from AMSR-E using the VUA-NASA (Vrije Universiteit Amsterdam in collaboration with NASA) algorithm with simulations from the Community Land Model (CLM) over vertisol regions of mainland Australia. For the three-year period examined here (2003–2005), both products display reasonable agreement during wet periods. During dry periods however, AMSR-E retrieved near surface soil moisture falls below values for surrounding non-clay soils, while CLM simulations are higher. CLM θ are also higher than AMSR-E and their difference keeps increasing throughout these dry periods. To identify the possible causes for these discrepancies, the impacts of land use, topography, soil properties and surface temperature used in the AMSR-E algorithm, together with vegetation density and rainfall patterns, were investigated. However these do not explain the observed θ responses. Qualitative analysis of the retrieval model suggests that the most likely reason for the low AMSR-E θ is the increase in soil porosity and surface roughness resulting from cracking of the soil. To quantitatively identify the role of each factor, more in situ measurements of soil properties that can represent different stages of cracking need to be collected. CLM does not simulate the behavior of cracking soils, including the additional loss of moisture from the soil continuum during drying and the infiltration into cracks during rainfall events, which results in overestimated θ when cracks are present. The hydrological influence of soil physical changes are expected to propagate through the modeled system, such that modeled infiltration, evaporation, surface temperature, surface runoff and groundwater recharge should be interpreted with caution over these soil types when cracks might be present. Introducing temporally dynamic roughness and soil porosity into retrieval algorithms and adding a "cracking clay" module into models are expected to improve the representation of vertisol hydrology.

Ground heat flux determination based on near-surface soil hydro-thermodynamics

2020 ◽  
Vol 591 ◽  
pp. 125578
Author(s):  
Baoqiang Wu ◽  
Steven P. Oncley ◽  
Huiling Yuan ◽  
Fei Chen
Keyword(s):  
Heat Flux ◽  
Surface Soil ◽  
Near Surface ◽  
Ground Heat Flux ◽  
Flux Determination

scholarly journals Assimilation of Disaggregated Microwave Soil Moisture into a Hydrologic Model Using Coarse-Scale Meteorological Data

2006 ◽  
Vol 7 (6) ◽  
pp. 1308-1322 ◽  
Author(s):  
O. Merlin ◽  
A. Chehbouni ◽  
G. Boulet ◽  
Y. Kerr
Keyword(s):  
Soil Moisture ◽  
Surface Soil ◽  
Meteorological Data ◽  
Microwave Radiometer ◽  
Hydrologic Model ◽  
Observation Time ◽  
Coupling Scheme ◽  
Surface Soil Moisture ◽  
Coarse Scale ◽  
Near Surface

Abstract Near-surface soil moisture retrieved from Soil Moisture and Ocean Salinity (SMOS)-type data is downscaled and assimilated into a distributed soil–vegetation–atmosphere transfer (SVAT) model with the ensemble Kalman filter. Because satellite-based meteorological data (notably rainfall) are not currently available at finescale, coarse-scale data are used as forcing in both the disaggregation and the assimilation. Synthetic coarse-scale observations are generated from the Monsoon ‘90 data by aggregating the Push Broom Microwave Radiometer (PBMR) pixels covering the eight meteorological and flux (METFLUX) stations and by averaging the meteorological measurements. The performance of the disaggregation/assimilation coupling scheme is then assessed in terms of surface soil moisture and latent heat flux predictions over the 19-day period of METFLUX measurements. It is found that the disaggregation improves the assimilation results, and vice versa, the assimilation of the disaggregated microwave soil moisture improves the spatial distribution of surface soil moisture at the observation time. These results are obtainable regardless of the spatial scale at which solar radiation, air temperature, wind speed, and air humidity are available within the microwave pixel and for an assimilation frequency varying from 1/1 day to 1/5 days.

Sign in / Sign up

Export Citation Format

Share Document