Fracture reactivation for permeability enhancement in geothermal systems

Author(s):  
Alexandra Kushnir ◽  
Michael Heap ◽  
Patrick Baud ◽  
Thierry Reuschlé

<p>While the deep granitic basement in the Upper Rhine Graben is currently being exploited as a geothermal reservoir at numerous geothermal sites, the Permo-Triassic sandstones that lie directly above the granite are critical to continued regional hydrothermal convection. Here we investigate the propensity for variably sealed fractures to be reactivated during deformation and the role this fracture reactivation plays on permeability enhancement in geothermal reservoirs. We source un-fractured, bedded sandstones and the same bedded sandstones containing a single, variably-sealed fracture from a 400 m-thick unit of Permo-Triassic sandstone sampled from the EPS-1 exploration well near Soultz-sous-Forêts (France) in the Upper Rhine Graben.</p><p>31 cylindrical samples (20 mm in diameter and 40 mm long) were cored such that their dominant structural feature (i.e. bedding or natural fracture) was oriented parallel, perpendicular, or at 30° to the sample axis. The initial permeability of the un-fractured samples ranged between 2.5×10<sup>-17</sup> and 5.6×10<sup>-16</sup> m<sup>2</sup> and between 3.6×10<sup>-16</sup> and 3.3×10<sup>-14</sup> m<sup>2</sup> for naturally fractured samples. In un-fractured samples, permeability decreases as a function of increased bedding angle; fracture orientation, however, does not appear to have a discernable influence on permeability. Samples were water-saturated and deformed until failure under pressure conditions appropriate to the Soultz-sous-Forêts geothermal system - P<sub>eff</sub> of 14.5 MPa - and at a strain rate of 10<sup>-6</sup> s<sup>-1</sup>. All samples developed through-going shear fractures, however, only in samples containing partially sealed fractures did the experimentally produced fractures take advantage of the pre-existing features. In samples containing a fully-sealed fracture, the experimentally induced fracture developed in a previously undeformed part of the sandstone matrix. Further, post-deformation permeability measurements indicate that while sample permeability increased by up to one order of magnitude for a given sample, this increase is generally independent of feature orientation.</p><p>Therefore, formations containing sealed fractures may not necessarily be weaker and, as a consequence, may not be more apt to significant permeability increases during stimulation than un-fractured formations. These data can contribute to the development and optimization of stimulation techniques used in the Upper Rhine Graben.</p>

Geosciences ◽  
2020 ◽  
Vol 10 (11) ◽  
pp. 459
Author(s):  
Béatrice A. Ledésert ◽  
Ronan L. Hébert

The Upper Rhine Graben (URG) hosts thermal anomalies that account for the development of oil fields. Recently, a geothermal power plant has been installed in this area. Data obtained in this framework provide an insight into the temperature distribution in the URG. The present thermal gradient at Soultz-sous-Forêts is not linear: nearly 90 °C/km down to 1400 m depth, then about 12 °C/km from that depth down to 5000 m. The combination of temperature conditions and natural fluid circulation in fracture networks has led to the hydrothermal alteration of the granite into mineral assemblages such as those including illite, quartz and calcite. Illite is locally impregnated with organic matter of two kinds: a mature type derived from oil source rocks and a less mature type derived from surficial sedimentary layers indicating the km-scale of transfer. Newly formed crystals of quartz and calcite from around 2000 m depth record a fluid temperature range of 130 to 170 °C, consistent with modelling and the temperatures measured at present in the drill-holes at this depth. In such hydrothermally altered zones, local variations of temperature are encountered indicating current fluid flows that are being sought for geothermal purposes.


2019 ◽  
Vol 7 (1) ◽  
Author(s):  
C. Aichholzer ◽  
Ph. Duringer ◽  
A. Genter

AbstractIn the 1950s, a petroleum well in Soultz-sous-Forêts (no 4589; Upper Rhine Graben, France) reached the Lettenkohle (Triassic) at 830 m depth. During the exploration phase at Soultz-sous-Forêts, the first enhanced geothermal system pilot project in the world, the well was core-deepened up to 2227 m into the granitic basement (then renamed EPS-1). The objectives of this deeper well were (i) to explore the granitic fractured reservoir and (ii) provide a precise geological characterization of the Soultz-sous-Forêts horst. This paper presents the first complete core analysis of the sedimentary formations observed in the EPS-1 cores (from the middle Muschelkalk to the Permian) in conjunction with the gamma-ray log description and field works. The detailed descriptions of the geological formations encountered in the well are presented with photo boards displaying the most characteristic facies of each formation, since the wells are rarely cored, especially in the Muschelkalk. This study also aims to describe the gamma-ray log to provide a strong baseline for future geothermal well exploration in this area (or old well reinterpretations). At this time, it is the only available reference for the complete section: Muschelkalk to Permian sedimentary formations.


2015 ◽  
Vol 203 (1) ◽  
pp. 614-631 ◽  
Author(s):  
T. Fuhrmann ◽  
M. Caro Cuenca ◽  
A. Knöpfler ◽  
F.J. van Leijen ◽  
M. Mayer ◽  
...  

PalZ ◽  
2007 ◽  
Vol 81 (4) ◽  
pp. 365-375 ◽  
Author(s):  
Bettina Reichenbacher München ◽  
Jean Gaudant Paris ◽  
Thomas W. Griessemer

Sign in / Sign up

Export Citation Format

Share Document