scholarly journals Dynamic Analysis for VSG-Based Power Flow Control Applied to DG Systems

2021 ◽  
Author(s):  
THIAGO FIGUEIREDO DO NASCIMENTO ◽  
ANDRES ORTIZ SALAZAR
Keyword(s):  
Power Systems ◽  
Dynamic Analysis ◽  
Power Flow ◽  
Control Strategies ◽  
Renewable Energy Sources ◽  
Dynamic Performance ◽  
Synchronous Generator ◽  
Power Flow Control ◽  
Grid Impedance ◽  
Impedance Parameters

The integration of distributed generation (DG) systems based on renewable energy sources (RES) by using power converters is an emerging technology in modern power systems. Among the control strategies applied to this new configuration, the virtual synchronous generator (VSG) approach has proven to be an attractive solution due providing suitable dynamic performance. Thus, this paper presents a dynamic analysis of gridtied converters controlled by using VSG concept. This analysis is based on a dynamic model that describes the DG power flow transient characteristics. Based on this model, the grid impedance parameters variation effects on the VSG controllers dynamic performance are discussed. Simulation results are presented to evaluate the effectiveness of the theoretical analysis performed.

Parameters Design and Performance Analysis for Grid-tied VSG-Controlled Converters

2020 ◽  
Author(s):  
Thiago F. do Nascimento ◽  
Luciano S. Barros ◽  
Flavio B. Costa
Keyword(s):  
Power Flow ◽  
Design Method ◽  
Renewable Energy Sources ◽  
Dynamic Performance ◽  
Synchronous Generator ◽  
Locus Method ◽  
High Penetration ◽  
Impedance Variation ◽  
Impedance Parameters ◽  
And Performance

Because of the high penetration of distributed generation (DG) systems based on renewable energy sources (RES), it is necessary to develop control techniques for improving support to grid frequency and voltage from this kind of generation. Among the solutions proposed in the literature, the virtual synchronous generator (VSG) concept has proven to be an attractive solution to interconnect DG units to the power grid. However, the dynamic behavior of the VSG has not yet been discussed for cases in which line impedance parameters varies in relation to their rated values. To evaluate this issue, in this work a dynamic model of VSG power flow has been derived and its dynamic characteristics discussed. Based on this model, the parameters for VSG controllers are designed by using root-locus method (RLM) in order to realize desired dynamic performance. Then the VSG dynamic performance under line impedance variation eect is assessed. Finally, simulation results demonstrated theoretical analysis and parameters design method.

scholarly journals Comprehensive Power Flow Analyses and Novel Feedforward Coordination Control Strategy for MMC-Based UPFC

Energies ◽  
2019 ◽  
Vol 12 (5) ◽  
pp. 824 ◽  
Author(s):  
Jinlian Liu ◽  
Zheng Xu ◽  
Liang Xiao
Keyword(s):  
Power Systems ◽  
Control Strategy ◽  
Computer Aided Design ◽  
Power Flow ◽  
Feedforward Control ◽  
Control Strategies ◽  
Dynamic Performance ◽  
Unified Power Flow Controller ◽  
3 Dimensional ◽  
Steady State Operation

This paper aims to discover the general steady-state operation characteristics, as well as improving the dynamic performance, of the modular multilevel converter (MMC)-based unified power flow controller (UPFC). To achieve this, first, we established a detailed power flow model for MMC-based UPFC containing each critical part and made qualitative and graphical analyses combining 2-dimensional operation planes and 3-dimensional spatial curve surfaces comprehensively to derive general power flow principles and offer necessary references for regulating UPFC. Furthermore, to achieve better performance, we designed a feedforward control strategy for the shunt and series converters of UPFC, both comprising two feedforward control blocks with the introduction of necessary compensating branches, and analyzed the performance in complex and time domain, respectively. The proposed power flow principles and control strategies were validated by a (power systems computer aided design) PSCAD model of 220 kV double-end system; the results reveal the MMC-based UPFC can realize the power flow principles and improve the control speed, stability, and precision of the power flow regulations under various conditions.

scholarly journals Transmission system regularization with 5-level cascaded IPFC

2019 ◽  
Vol 10 (3) ◽  
pp. 1437
Author(s):  
Sridhar Babu Gurijala ◽  
K S Srikanth ◽  
Ramchandra Nittala ◽  
G. Rohit Reddy
Keyword(s):  
Power Systems ◽  
Power Flow ◽  
Dynamic Performance ◽  
Vital Role ◽  
Transmission System ◽  
Power Flow Control ◽  
Control Techniques ◽  
Flexible Ac Transmission ◽  
Flexible Ac Transmission System ◽  
Ac Transmission

<p class="JESAbstract">In recent years, there is an immensely huge demand to power due to industrialization and modernization, butcorrespondingly the amplification of generation and transmission has not been done due to constrained resources and environmental limitations. The huge growth in demand leads to various problems in power systems. Heavy growth in semiconductor technology made power electronics plays a key role in solving these problems. Flexible AC transmission system (FACTS) devices are used for fixing various problems in power system. They are used for enhancing the existing transmission capabilities and improving the system dynamic performance so that to make transmission system flexible and efficient in operation. Inter line power flow controller (IPFC) is a latest generation series connected FACTS device, having capability of controlling power flow among multi line in a transmission network. In this paper cascaded 5 level inverter is used as the inverter module for IPFC. Control techniques play a vital role in power flow control in the system, with the main objective of minimization of harmonics and obtaining a variable output with maximum fundamental component. This paper discusses various comparative case studies on IPFC with cascaded 5 level inverter using SPWM and SVM control techniques.</p>

scholarly journals Dynamic grid fault analysis in wind power plant with DFIG by using supervisory control and data acquisition (SCADA) viewer

2020 ◽  
Vol 181 ◽  
pp. 03006
Author(s):  
Nduwamungu Aphrodis ◽  
Ntagwirumugara Etienne ◽  
Utetiwabo Wellars ◽  
Mulolani Francis
Keyword(s):  
Power Systems ◽  
Power Flow ◽  
Control Strategies ◽  
Electrical Power ◽  
Fault Analysis ◽  
Operational Mode ◽  
Electrical Power Systems ◽  
Fault Ride Through ◽  
Before And After ◽  
Clearing Time

Faults in electrical power systems are among the key factors and sources to network disturbances, however control strategies are among key faults clearing techniques for the sake of safe operational mode of the system.Some researchers have shown various limitations of control strategies such as slow dynamic response,inability to switch Off and On network remotely and fault clearing time. For a system with wind energy technologies, if the power flow of a wind turbine is interrupted by a fault, the intermediate-circuit voltage between the machine-side converter and line-side converter will fall in unacceptably high values.To overcome the aforementioned issues, this paper used a Matlab simulations and experiments in order to analyze and validate the results.The results showed that fault ride through (FRT) with SCADA Viewer software are more adaptable to the variations of voltage and wind speed in order to avoid loss of synchronism. Therefore at the speed of 12.5m/s a wind produced a rated power of 750W and remained in synchronization before and after a fault created and cleared but worked as generator meanwhile at speed of 3.4m/s wind disconnected from grid and started working as a motor and consumed active power (P=-25watts) and voltage dip at 100% .For the protection purpose, the DC chopper and crowbar should be integrated towards management of excess energy during faults cases.

scholarly journals A Full-Newton AC-DC Power Flow Methodology for HVDC Multi-Terminal Systems and Generic DC Network Representation

Energies ◽  
2021 ◽  
Vol 14 (6) ◽  
pp. 1658
Author(s):  
Leandro Almeida Vasconcelos ◽  
João Alberto Passos Filho ◽  
André Luis Marques Marcato ◽  
Giovani Santiago Junqueira
Keyword(s):  
Power Systems ◽  
Direct Current ◽  
Power Flow ◽  
Large Scale ◽  
Flow Problem ◽  
Control Strategies ◽  
Problem Formulation ◽  
Expansion Planning ◽  
Dc Power ◽  
Power Flow Problem

The use of Direct Current (DC) transmission links in power systems is increasing continuously. Thus, it is important to develop new techniques to model the inclusion of these devices in network analysis, in order to allow studies of the operation and expansion planning of large-scale electric power systems. In this context, the main objective of this paper is to present a new methodology for a simultaneous AC-DC power flow for a multi-terminal High Voltage Direct Current (HVDC) system with a generic representation of the DC network. The proposed methodology is based on a full Newton formulation for solving the AC-DC power flow problem. Equations representing the converters and steady-state control strategies are included in a power flow problem formulation, resulting in an expanded Jacobian matrix of the Newton method. Some results are presented based on HVDC test systems to confirm the effectiveness of the proposed approach.

scholarly journals Predicting AC Optimal Power Flows: Combining Deep Learning and Lagrangian Dual Methods

2020 ◽  
Vol 34 (01) ◽  
pp. 630-637 ◽  
Author(s):  
Ferdinando Fioretto ◽  
Terrence W.K. Mak ◽  
Pascal Van Hentenryck
Keyword(s):  
Deep Learning ◽  
Power Systems ◽  
Power Flow ◽  
Optimal Power Flow ◽  
Large Scale ◽  
Renewable Energy Sources ◽  
Electrical Power ◽  
Practical Applications ◽  
Fundamental Building Block ◽  
Optimal Power

The Optimal Power Flow (OPF) problem is a fundamental building block for the optimization of electrical power systems. It is nonlinear and nonconvex and computes the generator setpoints for power and voltage, given a set of load demands. It is often solved repeatedly under various conditions, either in real-time or in large-scale studies. This need is further exacerbated by the increasing stochasticity of power systems due to renewable energy sources in front and behind the meter. To address these challenges, this paper presents a deep learning approach to the OPF. The learning model exploits the information available in the similar states of the system (which is commonly available in practical applications), as well as a dual Lagrangian method to satisfy the physical and engineering constraints present in the OPF. The proposed model is evaluated on a large collection of realistic medium-sized power systems. The experimental results show that its predictions are highly accurate with average errors as low as 0.2%. Additionally, the proposed approach is shown to improve the accuracy of the widely adopted linear DC approximation by at least two orders of magnitude.

Coordination of power flow control in large power systems

2001 ◽  
Vol 16 (4) ◽  
pp. 776-781
Author(s):  
Fan Li ◽  
Baohua Li ◽  
Xujun Zheng
Keyword(s):  
Power Systems ◽  
Flow Control ◽  
Power Flow ◽  
Large Power ◽  
Power Flow Control

scholarly journals Control Strategies of DC Microgrids Cluster: A Comprehensive Review

Energies ◽  
2021 ◽  
Vol 14 (22) ◽  
pp. 7569
Author(s):  
Zaid Hamid Abdulabbas Al-Tameemi ◽  
Tek Tjing Lie ◽  
Gilbert Foo ◽  
Frede Blaabjerg
Keyword(s):  
Power Flow ◽  
Control Strategies ◽  
Future Research ◽  
Consensus Protocol ◽  
Power Flow Control ◽  
Dc Microgrids ◽  
Significant Control ◽  
Comparative Review ◽  
Cluster A ◽  
Research Recommendations

Multiple microgrids (MGs) close to each other can be interconnected to construct a cluster to enhance reliability and flexibility. This paper presents a comprehensive and comparative review of recent studies on DC MG clusters’ control strategies. Different schemes regarding the two significant control aspects of networked DC MGs, namely DC-link voltage control and power flow control between MGs, are investigated. A discussion about the architecture configuration of DC MG clusters is also provided. All advantages and limitations of various control strategies of recent studies are discussed in this paper. Furthermore, this paper discusses three types of consensus protocol with different time boundaries, including linear, finite, and fixed. Based on the main findings from the reviewed studies, future research recommendations are proposed.

scholarly journals A Review of Virtual Inertia Techniques for Renewable Energy-Based Generators

2020 ◽  
Author(s):  
Ana Fernández-Guillamón ◽  
Emilio Gómez-Lázaro ◽  
Eduard Muljadi ◽  
Ángel Molina-Garcia
Keyword(s):  
Renewable Energy ◽  
Power Systems ◽  
Power System ◽  
Power Plants ◽  
Control Strategies ◽  
Renewable Energy Sources ◽  
Extensive Discussion ◽  
Renewable Sources ◽  
Virtual Inertia ◽  
Alternative Sources

Over recent decades, the penetration of renewable energy sources (RES), especially photovoltaic and wind power plants, has been promoted in most countries. However, as these both alternative sources have power electronics at the grid interface (inverters), they are electrically decoupled from the grid. Subsequently, stability and reliability of power systems are compromised. Inertia in power systems has been traditionally determined by considering all the rotating masses directly connected to the grid. Thus, as the penetration of renewable units increases, the inertia of the power system decreases due to the reduction of directly connected rotating machines. As a consequence, power systems require a new set of strategies to include these renewable sources. In fact, ‘hidden inertia,’ ‘synthetic inertia’ and ‘virtual inertia’ are terms currently used to represent an artificial inertia created by inverter control strategies of such renewable sources. This chapter reviews the inertia concept and proposes a method to estimate the rotational inertia in different parts of the world. In addition, an extensive discussion on wind and photovoltaic power plants and their contribution to inertia and power system stability is presented.

Sign in / Sign up

Export Citation Format

Share Document