High Rate of Obstetric Complications in Patients With Essential Thrombocythemia

Key Points Treatment with PEG-IFN-α-2a in PV and ET results in a high rate of complete hematologic and molecular responses. Patients failing to achieve complete molecular remission tended to have higher frequencies of mutations in genes other than JAK2.

Download Full-text

Essential thrombocythemia with portal vein thrombosis and splenic infarction successfully treated with platelet apheresis

BMJ Case Reports ◽

10.1136/bcr-2021-245267 ◽

2021 ◽

Vol 14 (9) ◽

pp. e245267

Author(s):

Ami Mehul Mehta ◽

Shubha Seshadri ◽

Seemitr Verma ◽

Sharath P Madhyastha

Keyword(s):

Portal Vein ◽

Portal Vein Thrombosis ◽

Essential Thrombocythemia ◽

Splenic Infarction ◽

High Rate ◽

Diabetic Woman ◽

Complete Evaluation ◽

Vein Thrombosis ◽

History Of ◽

High Platelet Count

A 63-year-old diabetic woman presented to the outpatient clinic with a 1-week history of abdominal pain. On complete evaluation, she was diagnosed to have essential thrombocythemia. Abdominal imaging revealed portal vein thrombosis with a large splenic infarct. The patient was started on anticoagulant, antiplatelet and cytoreductive therapy. In view of persistent high platelet count, plasma apheresis was done, following which the patient’s platelet counts were reduced. Essential thrombocythemia has a high rate of complications, resulting in significant morbidity and mortality. Few cases of this disease and its treatment have been described in the literature, especially pertaining to the Indian scenario. Further studies are needed to establish a multidisciplinary algorithm for its diagnosis and to elucidate the guidelines for the successful treatment of the condition.

Download Full-text

Structure of Palladium Single-Crystal Films Prepared by Flash Evaporation onto (001) NaCl Substrates

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100069272 ◽

1970 ◽

Vol 28 ◽

pp. 456-457

Author(s):

L. E. Murr ◽

G. Wong

Keyword(s):

Single Crystal ◽

High Vacuum ◽

Ultra High Vacuum ◽

High Rate ◽

Flash Evaporation ◽

Optimum Load ◽

Single Crystal Films ◽

Crystal Films ◽

A Current

Palladium single-crystal films have been prepared by Matthews in ultra-high vacuum by evaporation onto (001) NaCl substrates cleaved in-situ, and maintained at ∼ 350° C. Murr has also produced large-grained and single-crystal Pd films by high-rate evaporation onto (001) NaCl air-cleaved substrates at 350°C. In the present work, very large (∼ 3cm2), continuous single-crystal films of Pd have been prepared by flash evaporation onto air-cleaved (001) NaCl substrates at temperatures at or below 250°C. Evaporation rates estimated to be ≧ 2000 Å/sec, were obtained by effectively short-circuiting 1 mil tungsten evaporation boats in a self-regulating system which maintained an optimum load current of approximately 90 amperes; corresponding to a current density through the boat of ∼ 4 × 104 amperes/cm2.

Download Full-text

Rapid Freezing of Freeze-Etch Specimens

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s1431927600003275 ◽

1980 ◽

Vol 38 ◽

pp. 752-755

Author(s):

A. Elgsaeter ◽

T. Espevik ◽

G. Kopstad

Keyword(s):

Low Temperature ◽

Metal Surface ◽

Relative Velocity ◽

Thermal Contact ◽

High Rate ◽

Rapid Freezing ◽

Temperature Decrease ◽

Freeze Etching

The importance of a high rate of temperature decrease (“rapid freezing”) when freezing specimens for freeze-etching has long been recognized1. The two basic methods for achieving rapid freezing are: 1) dropping the specimen onto a metal surface at low temperature, 2) bringing the specimen instantaneously into thermal contact with a liquid at low temperature and subsequently maintaining a high relative velocity between the liquid and the specimen. Over the last couple of years the first method has received strong renewed interest, particularily as the result of a series of important studies by Heuser and coworkers 2,3. In this paper we will compare these two freezing methods theoretically and experimentally.

Download Full-text