scholarly journals Carbon Dioxide Emission Analysis of Chilled Water Production by Using Gas Turbine Exhaust Heat

Author(s):  
Adzuieen Nordin ◽  
Mohd Amin Abd Majid
Author(s):  
W. V. Hambleton

This paper represents a study of the overall problems encountered in large gas turbine exhaust heat recovery systems. A number of specific installations are described, including systems recovering heat in other than the conventional form of steam generation.


Author(s):  
Akber Pasha

The design of a gas turbine exhaust heat recovery system (HRS) depends upon evaluating various parameters. Basically for an unfired heat recovery system the heat contained in the gas turbine exhaust is fixed and output is determined based on the system’s effectiveness. One of the design objectives is to maximize the output and thus maximize the effectiveness. However, increase in effectiveness will increase required heat transfer surface and thus the cost of the HRS. The increased cost (and benefits) must be evaluated to establish whether the higher effective system is economically justifiable. The evaluation criteria of a heat recovery system involves analysis of various design parameters. This paper presents the general design procedure, the effect of each parameter on the design and basic criteria used to develop the HRS design.


1975 ◽  
Author(s):  
D. A. Leonard ◽  
P. M. Rubins

The problems of gas turbine exhaust gas sampling by presently approved methods make an optical method attractive. Because of this, the Air Force has sponsored the development of laser. Raman for exhaust emissions measurement. Laser induced Raman and fluorescent measurements were made in the exhaust of a T53-L-13A gas turbine engine with a new field-portable instrument devised specifically for gas turbine exhaust emission measurements. The gas turbine exhaust was analyzed by conventional instruments for CO, CO2, NO, NOx total hydrocarbons, smoke, and temperature, and these data were used as a comparative standard for the evaluation of the laser Raman instrument. Results thus far indicate good to excellent correlations for CO2, O2, smoke, hydrocarbons, and temperature. NO detection was not sensitive enough, but the data analysis indicates that 100 ppm or less may be detectable with instrument improvements. Further NO sensitivity is possible with continued development of the method. CO analysis was not attempted, but it is expected that CO could be detected with further research. NO2 was not attempted because theoretical and experimental laboratory analysis indicated severe interferences with CO2. Temperature profiles from laser Raman were also compared with thermocouple data in the exhaust stream, and showed agreement within the radiation error of the thermocouples. With further development, laser Raman shows a good potential for an optical method of aircraft gas turbine emission analysis.


1982 ◽  
Vol 104 (1) ◽  
pp. 77-83
Author(s):  
B. M. Burnside

A dual pressure steam/immiscible liquid cycle gas turbine bottoming plant is described. Three variants of the cycle are analysed. It is shown that under typical conditions one of these shows a 5 percent higher output than the conventional steam/steam cycle with only a 5 percent increase in heat extraction from the gas turbine exhaust. A larger LP preheater and condenser are required. Attention is drawn to the flexibility this type of cycle brings to the task of matching bottoming plant to gas turbine exhaust of combined cycles.


Author(s):  
Anthony J. B. Jackson ◽  
Alcides Codeceira Neto ◽  
Matthew W. Whellens ◽  
Harry Audus

The world’s main atmospheric “greenhouse gas” is carbon dioxide (CO2). The CO2 content of the atmosphere continues to rise due to increasing world demand for energy, and thus further means are needed to achieve its abatement. Most gas turbine powered electricity generating plants use hydro-carbon fuels and this inevitably produces CO2 in the engine exhaust. This paper discusses a scheme for concentrating the gas turbine exhaust CO2, thus facilitating its extraction. The scheme is a gas turbine operating synchronously in closed cycle, with CO2 as the working fluid. The additional CO2 and water produced in the combustion process are removed continuously. CO2 and air have substantially different gas properties. This significantly affects the performance of the gas turbine. It is shown that any gas turbine designed to use air, and operating synchronously, would need considerable modifications to its compressor and combustion systems to use carbon dioxide as its working fluid.


1995 ◽  
Vol 36 (6-9) ◽  
pp. 393-396 ◽  
Author(s):  
Olav Falk-Pedersen ◽  
Yngvil Bjerve ◽  
Geir Glittum ◽  
Svein Rønning

Sign in / Sign up

Export Citation Format

Share Document