Silicon Ribbon-Based Dual-Beam Optical Phased Array with Low Crosstalk and Large FoV

In this paper, a silicon ribbon (SR)-based microstructure is developed and added to a 32-channel optical phased array (OPA) to reduce the crosstalk between the antennas of grating waveguides. The spacing between the chirped grating antennas can be as close as 600 nm to effectively improve the field of view (FoV) of the OPA in the horizontal direction to 95 degrees. This SR-based approach substantially reduces the side lobe by 10 dB, effectively suppressing the noise and increasing the main lobe by 6 dB and considerably expanding the grating length with linear energy decay. The full width at the half maximum of the light spot reaches about 0.24 degrees. The antenna sites can simultaneously be scanned vertically by bi-directional inputs, effectively increasing the FoV to 30 degrees in the vertical direction.

Sample preparation induced phase transitions in solution deposited copper selenide thin films

Ion beam irradiation causes Klockmannite CuSe to lose Se and transform into β-Cu2Se. Caution must be taken when using the dual beam FIB for preparing TEM specimen.

Location of Semi-Rigid Connection Effect On The Seismic Performance of Steel Frame Structures

In design steel frames, combining semi-rigid and rigid connections can result in better structural performance, particularly in seismic locations. In this study, the effects of semi-rigid beam-to-column connections located on the seismic performance of steel frame structures are investigated. The analysis uses six and twelve-story moment resisting steel frames (MRSF) with rigid, semi-rigid, and dual beam-column connections. These frames are designed according to the Egyptian design codes. Drain-2Dx computer program and seven earthquake ground motions are used in the non-linear dynamic analysis. The rotational stiffness of beam-to-column connections is indicated through the end fixity factors with a value equal to 0.6. The performances of these frames are evaluated through the roof drift ratio (RDR), the maximum story drift ratios (SDR), and the maximum column axial compression force (MACF). The results indicated that the quantities of fundamental periods, roof drift ratio, the story drift ratio, and the column axial compression force are related to stiffness, rigidity, and the number of semi-rigid connections in steel frames.

Single-Wedge Lift-Out for Atom Probe Tomography Al/Ni Multilayers Specimen Preparation Based on Dual-Beam-FIB

Atomic probe tomography (APT) samples with Al/Ni multilayer structure were successfully prepared by using a focused ion beam (FIB), combining with a field emission scanning electron microscope, with a new single-wedge lift-out method and a reduced amorphous damage layer of Ga ions implantation. The optimum vertex angle and preparation parameters of APT sample were discussed. The double interdiffusion relationship of the multilayer films was successfully observed by the local electrode APT, which laid a foundation for further study of the interface composition and crystal structure of the two-phase composites.