Driving Waveform Design with Rising Gradient and Sawtooth Wave of Electrowetting Displays for Ultra-Low Power Consumption

As a kind of paper-like display technology, power consumption is a very important index for electrowetting displays (EWDs). In this paper, the influence of driving waveforms on power consumption of the EWDs is analyzed, and a driving waveform with rising gradient and sawtooth wave is designed to reduce the power consumption. There are three stages in the proposed driving waveform. In the initial stage, the driving voltage is raised linearly from the threshold to the maximum value to reduce the invalid power consumption. At the same time, the oil breakup can be prohibited. And then, a section of sawtooth wave is added for suppressing oil backflow. Finally, there is a section of resetting wave to eliminate the influence of charge leakage. Experimental results show that the power consumption of the ultra-low power driving waveform is 1.85 mW, which is about 38.13% lower than that of the conventional used square wave (2.99 mW), when the aperture ratio is 65%.

PENGUAT KELAS D DENGAN METODE SUMMING INTEGRATOR

A class D amplifier is one in which the output transistors are operated as switches. When a transistor is off, the current through it is zero and when it is on, the voltage across it is small, ideally zero. Thus the power dissipation is very low, so it requires a smaller heat sink for the amplifier. Class D amplifier operation is based on analog principles and there is no digital encoding of the signal. Before the emergence of class D amplifiers, the standard classes were class A, class AB, class B, and class C. The classic method for generating signals driving a transistor MOSFET is to use a comparator. One input is driven by an incoming audio signal, and the other by a triangle wave or a sawtooth wave at the required switching frequency. The frequency of a triangular or sawtooth wave must be higher than the audio input. MOSFET transistors work in a complementary manner that operates as a switch. Triangle waves are usually generated by square waves fed to the integrator circuit. So the main part of processing audio signals into PWM (Pulse Width Modulation) is the integrator and comparator. In this paper, we will discuss the work of a class D amplifier system using the summing integrator method as its main part.