The challenge of monochromatization

The FCC-ee could measure the electron Yukawa coupling in a dedicated run at $$\sim $$ ∼ 125 GeV collision energy, provided that the center-of-mass (CM) energy spread can be reduced by means of monochromatization, e.g., through introducing nonzero horizontal dispersion of opposite sign at the interaction point (IP), for the two colliding beams. If the IP dispersion is nonzero, beamstrahlung blows up the horizontal emittance, and self-consistent IP parameters need to be determined. Two configurations are being studied. The first uses crab cavities to establish effective head-on collisions. The second configuration maintains the standard FCC-ee crossing angle, which, together with the IP dispersion, introduces a correlation between the local collision energy and the longitudinal location inside the detector, thereby allowing for an integrated scan of the Higgs resonance curve. We compare both approaches.

Modelling the volcanic ash plume from Eyjafjallajökull eruption (May 2010) over Europe: evaluation of the benefit of source term improvements and of the assimilation of aerosol measurements

Numerical dispersion models are used operationally worldwide to mitigate the effect of volcanic ash on aviation. In order to improve the representation of the horizontal dispersion of ash plumes and of the 3D concentration of ash, a study was conducted using the MOCAGE model during the European Natural Airborne Disaster Information and Coordination System for Aviation (EUNADICS-AV) project. Source term modelling and assimilation of different data were investigated. A sensitivity study of source term formulation showed that a resolved source term, using the FPLUME plume rise model in MOCAGE, instead of a parameterised source term, induces a more realistic representation of the horizontal dispersion of the ash plume. The FPLUME simulation provides more concentrated and focused ash concentrations in the horizontal and the vertical dimensions than the other source term. The assimilation of Moderate Resolution Imaging Spectroradiometer (MODIS) aerosol optical depth has an impact on the horizontal dispersion of the plume, but this effect is rather low and local compared to source term improvement. More promising results are obtained with the continuous assimilation of ground-based lidar profiles, which improves the vertical distribution of ash and helps in reaching realistic values of ash concentrations. Using this configuration, the effect of assimilation may last for several hours and it may propagate several hundred kilometres downstream of the lidar profiles.

Modelling the volcanic ash plume from Eyjafjallajökull eruption (May 2010) over Europe: evaluation of the benefit of source term improvements and of the assimilation of aerosol measurements

Numerical dispersion models are used operationally worldwide to mitigate the effect of volcanic ash on aviation. In order to improve the representation of the horizontal dispersion of ash plumes and of the 3D concentration of ash, a study was conducted using the MOCAGE model during the EUNADICS-AV project. Source term modelling and assimilation of different data were investigated. A sensitivity study to source term formulation showed that a resolved source term, using the FPLUME plume-rise model in MOCAGE, instead of a parameterised source term, induces a more realistic representation of the horizontal dispersion of the ash plume. The FPLUME simulation provides more concentrated and focused ash concentrations in the horizontal and the vertical dimensions than the other source term. The assimilation of MODIS Aerosol Optical Depth has an impact on the horizontal dispersion the plume, but this effect is rather low and local, compared to source term improvement. More promising results are obtained with the continuous assimilation of ground-based lidar profiles, which improves the vertical distribution of ash and helps to reach realistic values of ash concentrations. The improvement can remain several hours after and several hundred kilometers away downstream to the assimilated profiles.

Impacts of meso and submesoscale dynamics on the horizontal dispersion of sinking particles from the surface to the deep ocean

<p>Energetic eddy fields generated by meso and submesoscale dynamics induce tridimensional particle transport pathways, which complicate the interpretation of observed Particulate Organic Carbon (POC) fluxes using sediment traps. It is therefore of importance to understand how horizontal dispersion of particles is structured by these dynamics from surface to depth. In this modelling study, we use a Lagrangian method to backtrack sinking particles collected at various depths ranging from 500 m to 4700 m at the PAP (Porcupine Abyssal Plain) site. Particle trajectories are computed using high-resolution simulations of the Regional Ocean Modelling System (ROMS). Our results show that the horizontal distribution of particles with sinking velocities below 100 m d<sup>-1</sup> presents a large small-scale heterogeneity. Mesoscale eddies act to define the general structure of particle patches while submesoscale features shape particle distributions through convergence/divergence processes. Distribution patterns of particles tracked from different depths suggest regime shifts of particle dispersion between subsurface layers. To identify and quantify these regimes, we perform 2d experiments at specific depths from 100 m to 4000 m and relate the Lagrangian statistics to the characteristics of the different dynamical regimes identified using vertical profiles of eddy energy and Finite Size Lyapunov Exponents (FSLE) approach.                                                                                                                                                               </p>

Evaluation of the Ventilation Index in Complex Terrain: A Dispersion Modeling Study

In this study, the Flexible Particle (FLEXPART)-WRF, a Lagrangian particle dispersion model, is employed to simulate pollutant dispersion in and near the Lehigh Gap, a gap in a prominent ridgeline in eastern Pennsylvania. FLEXPART-WRF is used to evaluate the diagnostic value of the ventilation index (VI), an index that describes the potential for smoke or other pollutants to ventilate away from a source, for indicating dispersion potential in complex terrain. Little is known about the effectiveness of the ventilation index in diagnosing dispersion potential in complex terrain. The modeling approach used in this study is to release a dense cloud of particles across a portion of the model domain and evaluate particle behavior and VI diagnostic value in areas of the domain with differing terrain characteristics. Although both horizontal and vertical dispersion are examined, the study focuses primarily on horizontal dispersion, assessed quantitatively by calculating horizontal residence time (HRT) within a 1-km-radius circle surrounding the particle release point. Analysis of HRT across the domain reveals horizontal dispersion patterns that are influenced by the ridgeline and the Lehigh Gap. Comparison of VI and HRT in different areas of the domain reveals a robust relationship windward of the ridgeline and a weak relationship leeward of the ridgeline and in the vicinity of the Lehigh Gap. The results of this study suggest that VI users should consider whether they are windward or leeward of topographic features, and highlight the need for an alternative metric that better takes into account the influence of the terrain on dispersion.

Horizontal Dispersion of Buoyant Materials in the Ocean Surface Boundary Layer

ABSTRACTThe horizontal dispersion of materials with a constant rising speed under the exclusive influence of ocean surface boundary layer (OSBL) flows is investigated using both three-dimensional turbulence-resolving Lagrangian particle trajectories and the classical theory of dispersion in bounded shear currents generalized for buoyant materials. Dispersion in the OSBL is caused by the vertical shear of mean horizontal currents and by the turbulent velocity fluctuations. It reaches a diffusive regime when the equilibrium vertical material distribution is established. Diffusivity from the classical shear dispersion theory agrees reasonably well with that diagnosed using three-dimensional particle trajectories. For weakly buoyant materials that can be mixed into the boundary layer, shear dispersion dominates turbulent dispersion. For strongly buoyant materials that stay at the ocean surface, shear dispersion is negligible compared to turbulent dispersion. The effective horizontal diffusivity due to shear dispersion is controlled by multiple factors, including wind speed, wave conditions, vertical diffusivity, mixed layer depth, latitude, and buoyant rising speed. With all other meteorological and hydrographic conditions being equal, the effective horizontal diffusivity is larger in wind-driven Ekman flows than in wave-driven Ekman–Stokes flows for weakly buoyant materials and is smaller in Ekman flows than in Ekman–Stokes flows for strongly buoyant materials. The effective horizontal diffusivity is further reduced when enhanced mixing by breaking waves is included. Dispersion by OSBL flows is weaker than that by submesoscale currents at a scale larger than 100 m. The analytic framework will improve subgrid-scale modeling in realistic particle trajectory models using currents from operational ocean models.