ChemInform Abstract: Nucleosides. Part 61. A Simple Procedure for the Monomethylation of Protected and Unprotected Ribonucleosides in the 2′-O- and 3′-O- Position Using Diazomethane and the Catalyst Stannous Chloride.

ChemInform ◽  
2010 ◽  
Vol 28 (11) ◽  
pp. no-no
Author(s):  
H. CRAMER ◽  
W. PFLEIDERER
2019 ◽  
Vol 35 (6) ◽  
pp. 1718-1721
Author(s):  
Shawnam Omar Abdullah ◽  
Qasim Yahya Mohammed

Trace levels of mercury in soil, environmental water (portable and polluted) and plant specimens (cucumber and pepper) at Koya area – Kurdistan region – Iraq was described by simple procedure, where, no further solvent purification or pre-concentration required steps. The method based on soxhelt extraction with oxalic acid and stannous chloride in acidic media for about 2.5 h, followed by spectrophotometric measurement at λmax of 300 nm. The results show different mercury levels, water samples show (3-215) ppm, while soil samples (5 -150) ppm. Also, some agricultural products show (23 -80) ppm mercury level.


1995 ◽  
Vol 73 (03) ◽  
pp. 535-542 ◽  
Author(s):  
N Crawford ◽  
A Chajara ◽  
G Pfliegler ◽  
B EI Gamal ◽  
L Brewer ◽  
...  

SummaryDrugs can be electro-encapsulated within platelets and targeted to damaged blood vessels by exploiting the platelet’s natural haemostatic properties to adhere to collagen and other vessel wall constituents revealed by injury. A rat aorta balloon angioplasty model has been used to study the effect on platelet deposition of giving iloprost loaded platelets i.v. during the balloon injury. After labelling the circulating platelets with 111-Indium before balloon injury, time course studies showed maximum platelet deposition on the injured aorta occurred at about 1 h post-injury and the deposition remained stable over the next 2-3 h. When iloprost-loaded platelets were given i.v. during injury and the circulating platelet pool labelled with 111-Indium 30 min later, platelet deposition, measured at 2 h postinjury, was substantially and significantly reduced compared with control platelet treatment. Some antiproliferative effects of iloprost-loaded platelets given i.v. during injury have also been observed. Whereas the incorporation of [3H]-thymidine into aorta intima-media DNA at 3 days post injury was 62-fold higher in balloon injured rats than in control sham operated rats, thymidine incorporation into intima/media of rats which had received iloprost loaded platelets during injury was reduced as compared with rats subjected only to the injury procedure. The reduction was only of near significance, however, but at 14 days after injury the total DNA content of the aorta intima/media of rats given iloprost loaded platelets during injury was significantly reduced. Although iloprost loaded platelets can clearly inhibit excessive platelet deposition, other encapsulated agents may have greater anti-proliferative effects. These studies have shown that drug loaded platelets can be targeted to injured arteries, where they may be retained as depots for local release. We believe this novel drug delivery protocol may have therapeutic potential in reducing the incidence of occlusion and restenosis after angioplasty and thrombolysis treatment. Electro-encapsulation of drugs into platelets is a simple procedure and, using autologous and fully biocompatible and biodegradable platelets as delivery vehicles, might overcome some of the immunological and toxicological problems which have been encountered with other delivery vectors such as liposomes, microbeads, synthetic microcapsules and antibodies.


2019 ◽  
Author(s):  
Kristina Eriksen ◽  
Bjarne Nielsen ◽  
Michael Pittelkow

<p>We present a simple procedure to make an augmented reality app to visualize any 3D chemical model. The molecular structure may be based on data from crystallographic data or from computer modelling. This guide is made in such a way, that no programming skills are needed and the procedure uses free software and is a way to visualize 3D structures that are normally difficult to comprehend in the 2D space of paper. The process can be applied to make 3D representation of any 2D object, and we envisage the app to be useful when visualizing simple stereochemical problems, when presenting a complex 3D structure on a poster presentation or even in audio-visual presentations. The method works for all molecules including small molecules, supramolecular structures, MOFs and biomacromolecules.</p>


1989 ◽  
Vol 21 (2) ◽  
pp. 93-97 ◽  
Author(s):  
R. Sadler

The suitability of sedimentary urease activity as a potential tracer for sewage outfall plumes has been examined. Enzyme activity is readily measured in the sediments by a relatively simple procedure and results may be obtained within a few hours of sampling. The results of urease measurements in areas around point source discharges were compared with bacteriological data for the same areas. Three areas were selected for study: a discharge of untreated sewage into a harbour, a discharge from a sewage treatment plant to a river and a discharge from a contaminated drain to a small beach. In all cases, positive correlation between the distribution of the two parameters was observed. Urease activity probably reflects the movement of soluble products from the outfall whereas E.coli represents the particulate phase of the discharge. Although further work will be required, urease activity does offer a potential alternative to E.coli for tracing plumes of faecal pollution.


Sign in / Sign up

Export Citation Format

Share Document