Exciterless and brushless DC self-excited three-phase synchronous generator

1985 ◽  
Vol 105 (5) ◽  
pp. 58-66 ◽  
Author(s):  
Fukuo Shibata ◽  
Toshio Kohrin
2020 ◽  
pp. 0309524X2098177
Author(s):  
Mohamed Metwally Mahmoud ◽  
Hossam S Salama ◽  
Mohamed M Aly ◽  
Abdel-Moamen M Abdel-Rahim

Fault ride-through (FRT) capability enhancement for the growth of renewable energy generators has become a crucial issue for their incorporation into the electricity grid to provide secure, reliable, and efficient electricity. This paper presents a new FRT capability scheme for a permanent magnet synchronous generator (PMSG)-based wind energy generation system using a hybrid solution. The hybrid solution is a combination of a braking chopper (BC) and a fuzzy logic controller (FLC). All proportional-integral (PI) controllers which control the generator and grid side converters are replaced with FLC. Moreover, a BC system is connected to the dc link to improve the dynamic response of the PMSG during fault conditions. The PMSG was evaluated on a three-phase fault that occurs on an electrical network in three scenarios. In the first two scenarios, a BC is used with a PI controller and FLC respectively. While the third scenario uses only FLC without a BC. The obtained results showed that the suggested solution can not only enhance the FRT capability of the PMSG but also can diminish the occurrence of hardware systems and reduce their impact on the PMSG system. The simulation tests are performed using MATLAB/SIMULINK software.


Author(s):  
Minal A Bodkhe ◽  
Vaishali Nandanwar

In this paper ,a new approach is presented aim at improving the power factor of three phase bridge inverter that equip with permanent Magnet Brushless DC motor(PMBLDCM)drive through microcontroller. Power factor correction converter is used for feeding a three phase bridge inverter based PMBLDC motor drive. The front end of PFC converter is a diode bridge rectifier fed from a step down transformer. In this three phase bridge inverter is operated as electronic commutator of the PMBLDCM .Nearly sinusoidal input current is achieved using. The proposed PMBLDCM drive with PFC converter is designed to run the motor to desired speed. This scheme improves an efficiency of proposed drive system with PFC feature in wide range of the speed and an input AC voltage.


Sign in / Sign up

Export Citation Format

Share Document