Imaging and Quantifying the Dynamics of γ-Tubulin at Microtubule Minus Ends in Mitotic Spindles

2016 ◽  
pp. 63-75 ◽  
Author(s):  
Nicolas Lecland ◽  
Jens Lüders
Keyword(s):  
Mitotic Spindles

3-D reconstruction and analysis of mammalian mitotic spindle structure

1992 ◽  
Vol 50 (1) ◽  
pp. 578-579
Author(s):  
Kent McDonald ◽  
David Mastronarde ◽  
Rubai Ding ◽  
Eileen O'Toole ◽  
J. Richard McIntosh
Keyword(s):  
Cross Sections ◽  
Mitotic Spindle ◽  
Experimental Studies ◽  
Video Camera ◽  
Three Dimensions ◽  
Mitotic Spindles ◽  
Black And White ◽  
Reconstruction Methods ◽  
Spindle Structure ◽  
Tissue Culture Line

Mammalian spindles are generally large and may contain over a thousand microtubules (MTs). For this reason they are difficult to reconstruct in three dimensions and many researchers have chosen to study the smaller and simpler spindles of lower eukaryotes. Nevertheless, the mammalian spindle is used for many experimental studies and it would be useful to know its detailed structure.We have been using serial cross sections and computer reconstruction methods to analyze MT distributions in mitotic spindles of PtK cells, a mammalian tissue culture line. Images from EM negatives are digtized on a light box by a Dage MTI video camera containing a black and white Saticon tube. The signal is digitized by a Parallax 1280 graphics device in a MicroVax III computer. Microtubules are digitized at a magnification such that each is 10-12 pixels in diameter.

Laser Scanning Confocal Microscopy and Three-Dimesnsional Reconstruction of the Mitotic Spindles of Unequally Dividing Embryonic Cells

1990 ◽  
Vol 48 (3) ◽  
pp. 166-167
Author(s):  
J. Holy ◽  
G. Schatten
Keyword(s):  
Confocal Microscopy ◽  
Mitotic Spindle ◽  
Laser Scanning ◽  
Three Dimensional ◽  
Laser Scanning Confocal Microscopy ◽  
Two Dimensions ◽  
Embryonic Cells ◽  
Mitotic Spindles ◽  
Cleavage Division ◽  
Scanning Confocal Microscopy

One of the classic limitations of light microscopy has been the fact that three dimensional biological events could only be visualized in two dimensions. Recently, this shortcoming has been overcome by combining the technologies of laser scanning confocal microscopy (LSCM) and computer processing of microscopical data by volume rendering methods. We have employed these techniques to examine morphogenetic events characterizing early development of sea urchin embryos. Specifically, the fourth cleavage division was examined because it is at this point that the first morphological signs of cell differentiation appear, manifested in the production of macromeres and micromeres by unequally dividing vegetal blastomeres.The mitotic spindle within vegetal blastomeres undergoing unequal cleavage are highly polarized and develop specialized, flattened asters toward the micromere pole. In order to reconstruct the three-dimensional features of these spindles, both isolated spindles and intact, extracted embryos were fluorescently labeled with antibodies directed against either centrosomes or tubulin.

280: Primary Cilia and Fluid Flow Establish the Orientation of Mitotic Spindles

2010 ◽  
Vol 55 (4) ◽  
pp. B101
Author(s):  
Neeraj Sharma ◽  
Bradley K. Yoder
Keyword(s):  
Fluid Flow ◽  
Primary Cilia ◽  
Mitotic Spindles

scholarly journals Microtubule Flux and Sliding in Mitotic Spindles ofDrosophila Embryos

2002 ◽  
Vol 13 (11) ◽  
pp. 3967-3975 ◽  
Author(s):  
Ingrid Brust-Mascher ◽  
Jonathan M. Scholey
Keyword(s):  
Mitotic Spindles ◽  
Pole Motion ◽  
Spindle Poles ◽  
Balance Of Forces ◽  
Anaphase B

We proposed that spindle morphogenesis in Drosophilaembryos involves progression through four transient isometric structures in which a constant spacing of the spindle poles is maintained by a balance of forces generated by multiple microtubule (MT) motors and that tipping this balance drives pole-pole separation. Here we used fluorescent speckle microscopy to evaluate the influence of MT dynamics on the isometric state that persists through metaphase and anaphase A and on pole-pole separation in anaphase B. During metaphase and anaphase A, fluorescent punctae on kinetochore and interpolar MTs flux toward the poles at 0.03 μm/s, too slow to drive chromatid-to-pole motion at 0.11 μm/s, and during anaphase B, fluorescent punctae on interpolar MTs move away from the spindle equator at the same rate as the poles, consistent with MT-MT sliding. Loss of Ncd, a candidate flux motor or brake, did not affect flux in the metaphase/anaphase A isometric state or MT sliding in anaphase B but decreased the duration of the isometric state. Our results suggest that, throughout this isometric state, an outward force exerted on the spindle poles by MT sliding motors is balanced by flux, and that suppression of flux could tip the balance of forces at the onset of anaphase B, allowing MT sliding and polymerization to push the poles apart.

scholarly journals Microtubule organization within mitotic spindles revealed by serial block face scanning electron microscopy and image analysis

2017 ◽  
Vol 130 (10) ◽  
pp. 1845-1855 ◽  
Author(s):  
Faye M. Nixon ◽  
Thomas R. Honnor ◽  
Nicholas I. Clarke ◽  
Georgina P. Starling ◽  
Alison J. Beckett ◽  
...  
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
Image Analysis ◽  
Mitotic Spindles ◽  
Microtubule Organization ◽  
Face Scanning ◽  
Block Face ◽  
Scanning Electron

scholarly journals Interaction between Poly(ADP-ribose) and NuMA Contributes to Mitotic Spindle Pole Assembly

2009 ◽  
Vol 20 (21) ◽  
pp. 4575-4585 ◽  
Author(s):  
Paul Chang ◽  
Margaret Coughlin ◽  
Timothy J. Mitchison
Keyword(s):  
Binding Proteins ◽  
Magnetic Beads ◽  
Spindle Pole ◽  
Covalent Modification ◽  
Mitotic Spindles ◽  
Spindle Poles ◽  
Tankyrase 1 ◽  
Mitotic Spindle Pole

Poly(ADP-ribose) (pADPr), made by PARP-5a/tankyrase-1, localizes to the poles of mitotic spindles and is required for bipolar spindle assembly, but its molecular function in the spindle is poorly understood. To investigate this, we localized pADPr at spindle poles by immuno-EM. We then developed a concentrated mitotic lysate system from HeLa cells to probe spindle pole assembly in vitro. Microtubule asters assembled in response to centrosomes and Ran-GTP in this system. Magnetic beads coated with pADPr, extended from PARP-5a, also triggered aster assembly, suggesting a functional role of the pADPr in spindle pole assembly. We found that PARP-5a is much more active in mitosis than interphase. We used mitotic PARP-5a, self-modified with pADPr chains, to capture mitosis-specific pADPr-binding proteins. Candidate binding proteins included the spindle pole protein NuMA previously shown to bind to PARP-5a directly. The rod domain of NuMA, expressed in bacteria, bound directly to pADPr. We propose that pADPr provides a dynamic cross-linking function at spindle poles by extending from covalent modification sites on PARP-5a and NuMA and binding noncovalently to NuMA and that this function helps promote assembly of exactly two poles.

Sign in / Sign up

Export Citation Format

Share Document