Portland Cement Production from Fine Fractions of Concrete Waste

2020 ◽  
pp. 42-46
Author(s):  
S. Zhutovsky ◽  
A. Shishkin
Keyword(s):  
Portland Cement ◽  
Cement Production

scholarly journals Special Issue: Supplementary Cementitious Materials in Concrete, Part I

Materials ◽  
2021 ◽  
Vol 14 (9) ◽  
pp. 2291
Author(s):  
Alessandro P. Fantilli ◽  
Daria Jóźwiak-Niedźwiedzka
Keyword(s):  
Environmental Impact ◽  
Portland Cement ◽  
Building Materials ◽  
Cementitious Materials ◽  
Supplementary Cementitious Materials ◽  
Special Issue ◽  
Cement Production ◽  
Concrete Part

The environmental impact of the Portland cement production and the large use of cement-based building materials is a growing problem [...]

scholarly journals Volcanic Ash as a Sustainable Binder Material: An Extensive Review

Materials ◽  
2021 ◽  
Vol 14 (5) ◽  
pp. 1302
Author(s):  
Andrés Játiva ◽  
Evelyn Ruales ◽  
Miren Etxeberria
Keyword(s):  
Chemical Composition ◽  
Portland Cement ◽  
Urban Areas ◽  
Volcanic Ash ◽  
Mechanical Performance ◽  
Cement Clinker ◽  
Alkali Activation ◽  
Cement Production ◽  
Sustainable Solutions ◽  
Alkali Activated

The construction industry is affected by the constant growth in the populations of urban areas. The demand for cement production has an increasing environmental impact, and there are urgent demands for alternative sustainable solutions. Volcanic ash (VA) is an abundant low-cost material that, because of its chemical composition and amorphous atomic structure, has been considered as a suitable material to replace Portland cement clinker for use as a binder in cement production. In the last decade, there has been interest in using alkali-activated VA material as an alternative material to replace ordinary Portland cement. In this way, a valuable product may be derived from a currently under-utilized material. Additionally, alkali-activated VA-based materials may be suitable for building applications because of their good densification behaviour, mechanical properties and low porosity. This article describes the most relevant findings from researchers around the world on the role of the chemical composition and mineral contents of VA on reactivity during the alkali-activation reaction; the effect of synthesis factors, which include the concentration of the alkaline activator, the solution-to-binder ratio and the curing conditions, on the properties of alkali-activated VA-based materials; and the mechanical performance and durability properties of these materials.

EFFECT OF STYRENE-BUTADIENE COPOLYMER (SBR) LATEX ON MECHANICAL AND TRANSPORT PROPERTIES OF PORTLAND CEMENT MORTAR

2020 ◽  
Vol 15 (4) ◽  
pp. 185-197
Author(s):  
Daniel Hatungimana ◽  
Şemsi Yazici ◽  
Şevket Orhan ◽  
Ali Mardani-Aghabaglou
Keyword(s):  
Mechanical Properties ◽  
Portland Cement ◽  
Detrimental Effect ◽  
Cement Mortar ◽  
Styrene Butadiene Rubber ◽  
Butadiene Rubber ◽  
Replacement Level ◽  
Cement Production ◽  
Cement Ratio ◽  
Styrene Butadiene

ABSTRACT Portland cement is extensively used as a binder in concrete production. However, with Portland cement production, 5% of the natural resources used in this production are consumed, constituting 5–7% of the total CO2 emission. In order to mitigate the environmental problems associated with cement production, styrene-butadiene rubber latex was used as cement replacement up to 20%. In this study, compressive strength, flexural strength, unit weight, water absorption, open porosity, water sorptivity and the chloride ion permeability of Portland cement mortar mixtures modified by styrene-butadiene rubber (SBR) polymeric latex were investigated. For this purpose, the sand/cement ratio and the water/cement ratio were kept constant as 3/1 and 0.5, respectively. In addition to the control mixture containing no polymer, 1, 2, 3, 5, 10 and 20 wt.% of cement was replaced with SBR. In this way, seven mortar mixtures were prepared. Mixed curing (wet cure and dry cure) method was applied to the mortar specimens. Results showed that up to a 5% replacement level, it is possible to improve the mechanical properties of cement mortars with SBR latex addition. However, at a 10% and 20% replacement level, SBR had a significant detrimental effect on the mechanical properties of polymer modified mortars. However, the transport properties decreased with the incorporation rate of SBR latex and the detrimental effect of SBR replacement was more pronounced in 20% SBR mortar mixtures.

scholarly journals Scrap tire ashes in portland cement production

2009 ◽  
Vol 12 (4) ◽  
pp. 489-494 ◽  
Author(s):  
Mónica Adriana Trezza ◽  
Alberto Néstor Scian
Keyword(s):  
Portland Cement ◽  
Scrap Tire ◽  
Cement Production

Hydration Process of Portland Cement Blended with Silica Fume

2013 ◽  
Vol 699 ◽  
pp. 578-583 ◽  
Author(s):  
Neven Ukrainczyk ◽  
Jure Zlopasa ◽  
Eduard Koenders
Keyword(s):  
Portland Cement ◽  
Silica Fume ◽  
Isothermal Calorimetry ◽  
Construction Materials ◽  
Radical Change ◽  
Sustainable Construction ◽  
Hydration Kinetics ◽  
Replacement Ratio ◽  
Cement Production ◽  
Ultrasound Bath

The enormous carbon footprint associated with the global cement production (5-7%) asks for a radical change in the use of sustainable replacement materials in concrete. Replacement of cement by pozzolanic waste materials, being a by-product from industrial processes, has been widely recognized as the most promising route towards sustainable construction materials. This paper presents experimental study on hydration of commercial Portland cement blended with silica fume in replacement ratio of 15 mass %. Isothermal calorimetry was employed to monitor the hydration kinetics. Thermogravimetric analysis coupled by differential scanning calorimeter (TG/DSC) was used to investigate the formed hydration products at 1, 3, 7, and 28 days of hydration. Two different approaches for a dispersion of silica fume in cement paste were compared: ultrasound bath and addition of superplasticizer (polycarboxylic ether based).

Superplasticized portland cement: production and compressive strength of mortars and concrete

1998 ◽  
Vol 28 (12) ◽  
pp. 1783-1796 ◽  
Author(s):  
N Bouzoubaâ ◽  
M.H Zhang ◽  
V.M Malhotra
Keyword(s):  
Compressive Strength ◽  
Portland Cement ◽  
Cement Production

Utilisation of Fluidised Fly Ash for Reduction of CO2 Emissions at Portland Cement Production

2014 ◽  
Vol 1054 ◽  
pp. 168-172
Author(s):  
Marcela Fridrichová ◽  
Karel Kulísek ◽  
Oldřich Hoffmann ◽  
Karel Dvořák ◽  
Radek Magrla
Keyword(s):  
Fly Ash ◽  
Portland Cement ◽  
Raw Material ◽  
Technological Properties ◽  
Portland Cements ◽  
Cement Production ◽  
Material Powder

The article deals with preparation of Portland cements from raw material powder with reduced carbonated component. This component is replaced with fluidised fly ash. With prepared model cements tests of basic technological properties were carried out.

Sign in / Sign up

Export Citation Format

Share Document