Characterization of a Ti64Ni20Pd16 thin film by transmission electron microscopy

Author(s):  
R. Zarnetta ◽  
E. Zelaya ◽  
G. Eggeler ◽  
A. Ludwig
2012 ◽  
Vol 725 ◽  
pp. 75-78
Author(s):  
Noriko Ohmori ◽  
Tomonori Uchimaru ◽  
Hiroyuki Fujimori ◽  
Jun Komiyama ◽  
Yoshihisa Abe ◽  
...  

The dislocations in GaN thin film with GaN/AlN multilayer (ML) as the buffer layer were evaluated using transmission electron microscopy. A high density of dislocations parallel to the GaN/ML interface and a sudden decrease in the dislocation density at the GaN/ML interface were found. Dislocation propagation in the direction parallel to the GaN/ML interface by turning horizontally on the GaN/ML interface is considered to be effective in decreasing the dislocation density at the top layer of GaN.


2009 ◽  
Vol 15 (S2) ◽  
pp. 148-149
Author(s):  
U Sharma ◽  
D Susnitzky

Extended abstract of a paper presented at Microscopy and Microanalysis 2009 in Richmond, Virginia, USA, July 26 – July 30, 2009


Author(s):  
T. P. Nolan

Thin film magnetic media are being used as low cost, high density forms of information storage. The development of this technology requires the study, at the sub-micron level, of morphological, crystallographic, and magnetic properties, throughout the depth of the deposited films. As the microstructure becomes increasingly fine, widi grain sizes approaching 100Å, the unique characterization capabilities of transmission electron microscopy (TEM) have become indispensable to the analysis of such thin film magnetic media.Films were deposited at 225°C, on two NiP plated Al substrates, one polished, and one circumferentially textured with a mean roughness of 55Å. Three layers, a 750Å chromium underlayer, a 600Å layer of magnetic alloy of composition Co84Cr14Ta2, and a 300Å amorphous carbon overcoat were then sputter deposited using a dc magnetron system at a power of 1kW, in a chamber evacuated below 10-6 torr and filled to 12μm Ar pressure. The textured medium is presently used in industry owing to its high coercivity, Hc, and relatively low noise. One important feature is that the coercivity in the circumferential read/write direction is significandy higher than that in the radial direction.


Author(s):  
George Guthrie ◽  
David Veblen

The nature of a geologic fluid can often be inferred from fluid-filled cavities (generally <100 μm in size) that are trapped during the growth of a mineral. A variety of techniques enables the fluids and daughter crystals (any solid precipitated from the trapped fluid) to be identified from cavities greater than a few micrometers. Many minerals, however, contain fluid inclusions smaller than a micrometer. Though inclusions this small are difficult or impossible to study by conventional techniques, they are ideally suited for study by analytical/ transmission electron microscopy (A/TEM) and electron diffraction. We have used this technique to study fluid inclusions and daughter crystals in diamond and feldspar.Inclusion-rich samples of diamond and feldspar were ion-thinned to electron transparency and examined with a Philips 420T electron microscope (120 keV) equipped with an EDAX beryllium-windowed energy dispersive spectrometer. Thin edges of the sample were perforated in areas that appeared in light microscopy to be populated densely with inclusions. In a few cases, the perforations were bound polygonal sides to which crystals (structurally and compositionally different from the host mineral) were attached (Figure 1).


Sign in / Sign up

Export Citation Format

Share Document