Development of Longitudinal Splitting in CFRP under Static Tensile Loading

1991 ◽  
pp. 685-696
Author(s):  
M. S. Found ◽  
I. C. Howard ◽  
S. B. Kanyanga
Keyword(s):  
Tensile Loading ◽  
Longitudinal Splitting ◽  
Static Tensile Loading ◽  
Static Tensile

Damage Observation of Glass Fiber/Epoxy Composites Using Thermography and Supported by Acoustic Emission

2014 ◽  
Vol 627 ◽  
pp. 187-190 ◽  
Author(s):  
Jefri Bale ◽  
Emmanuel Valot ◽  
Martine Monin ◽  
Peggy Laloue ◽  
Olivier Polit ◽  
...  
Keyword(s):  
Acoustic Emission ◽  
Glass Fiber ◽  
Epoxy Composite ◽  
Thermal Response ◽  
Tensile Loading ◽  
Destructive Testing ◽  
Ir Camera ◽  
Damage Propagation ◽  
Static Tensile Loading ◽  
Static Tensile

This work presents an experimental study to monitor the damage propagation of composite material by non destructive testing (NDT) method. In order to achieve this, an open hole condition of glass fiber/epoxy composite has been used as the specimen test under static tensile loading and observed using two different real-time monitoring techniques of NDT namely infra-red (IR) camera and supported by Acoustic Emission. The results show that the thermal response and acoustic emission signals give a good detection on damage appearance and damage propagation of glass fiber/epoxy composite under static tensile loading conditions.

2143 Study on damage development for braided composites under static tensile loading

2007 ◽  
Vol 2007.1 (0) ◽  
pp. 223-224
Author(s):  
Kenta Hamada ◽  
Tetsusei KURASHIKI ◽  
Hiroaki NAKAI ◽  
Masaru ZAKO
Keyword(s):  
Tensile Loading ◽  
Braided Composites ◽  
Damage Development ◽  
Static Tensile Loading ◽  
Static Tensile

A Qualitative X-Ray Examination of the Structure of Fiberglass Under Static Tensile Loading

1963 ◽  
Vol 7 ◽  
pp. 182-194
Author(s):  
H. P. Materne
Keyword(s):  
Tensile Strength ◽  
Tensile Load ◽  
Incident Beam ◽  
Tensile Loading ◽  
X Ray ◽  
Average Tensile Strength ◽  
Static Tensile Loading ◽  
Static Tensile ◽  
Time Limitations

AbstractA series of four types of glasses was supplied for investigation. Six individual filaments of each glass (each filament ranged between 7 and 10 μ in diameter) were extracted and the ultimate tensile strength determined for each. The ultimate average tensile strength was then used in the determination of the tensile load applicable to the investigation.Two methods of examination were used—the Laue and a modified rotation camera. The results of the investigation seem to indicate that a reconstructive transformation in three of the four glasses studied was in process. These results have not been confirmed, due to time limitations. In the case of the E glass investigated, a series of rings were faintly produced after 15 days under 35% of the ultimate average tensile strength. These rings, actually egg-shaped ovals, appeared at 15, 20, and 30 mm from the point of contact of the incident beam. In the other modified E glass and in the YM-31A (BeO) glass, the egg-shaped configuration did not appear in the rotation camera, but did appear in the Laue examination as a semioriented series of spots.

Sign in / Sign up

Export Citation Format

Share Document