Investigation of Kinetic and Microbiological Features of UASB-Reactor Performance Under Various Organic Loading Rates

Author(s):  
S. Kalyuzhnyi ◽  
V. Sklyar ◽  
J. Rodríguez
2001 ◽  
Vol 44 (4) ◽  
pp. 189-195 ◽  
Author(s):  
J. B. van Lier ◽  
P. N.L. Lens ◽  
L. W. Hulshoff Pol

Stringent environmental laws in Europe and Northern America lead to the development towards closure of the process water streams in pulp and paper mills. Application of a "zero-discharge" process is already a feasible option for the board and packaging paper industry, provided in-line treatment is applied. Concomitant energy conservation inside the mill results in process water temperatures of 50-60°C. Thermophilic anaerobic treatment complemented with appropriate post-treatment is considered as the most cost-effective solution to meet re-use criteria of the process water and to keep its temperature. In the proposed closed-cycle, the anaerobic treatment step removes the largest fraction of the biodegradable COD and eliminates “S” as H2S from the process stream, without the use of additional chemicals. The anaerobic step is regarded as the only possible location to bleed "S" from the process water cycle. In laboratory experiments, the effect of upward liquid velocity (Vupw) and the specific gas loading rate (Vgas) on the S removal capacity of thermophilic anaerobic bio-reactors was investigated. Acidifying, sulphate reducing sludge bed reactors were fed with partly acidified synthetic paper mill wastewater and were operated at 55°C and pH 6. The reactors were operated at organic loading rates up to 50 g COD.l−1.day−1 at COD/SO42- ratios of 10. The effect of Vupw was researched by comparing the performance of a UASB reactor operated at 1.0 m.h−1 and an EGSB reactor, operated at 6.8 m.h−1. The Vupw had a strong effect on the fermentation patterns. In the UASB reactor, acidification yielded H2, acetate and propionate, leading to an accumulation of reducing equivalents. These were partly disposed of by the production of n-butyrate and n-valerate from propionate. In the EGSB reactor net acetate consumption was observed as well as high volumetric gas (CO2 and CH4) production rates. The higher gas production rates in the EGSB reactor resulted in higher S-stripping efficiencies. The effect of Vgas was further researched by comparing 2 UASB reactors which were sparged with N2 gas at a specific gas loading rate of 30 m3.m−2.day−1. In contrast to the regular UASB reactors, the gas-supplied UASB showed a more stable performance when the organic loading rates were increased. Also, the H2S stripping efficiency was 3-4 times higher in the gas-supplied UASB, reaching values of 67%. Higher values were not obtained owing to the relatively poor sulphate reduction efficiencies.


2005 ◽  
Vol 52 (10-11) ◽  
pp. 273-280 ◽  
Author(s):  
S. Kalyuzhnyi ◽  
M. Gladchenko ◽  
E. Starostina ◽  
S. Shcherbakov ◽  
B. Versprille

The UASB reactor (35°C) was quite efficient for removal of bulk COD (52–74%) from simulated (on the basis of cultivation medium from the first separation process) general effluent of baker's yeast production (the average organic loading rates varied from 8.1 to 16g COD/l/d). The aerobic-anoxic biofilter (19–23°C) can be used for removal of remaining BOD and ammonia from anaerobic effluents; however, it suffered from COD-deficiency to fulfil denitrification requirements. To balance COD/N ratio, some bypass (∼10%) of anaerobically untreated general effluent should be added to the biofilter feed. The application of iron (III)-, aluminium- or calcium-induced coagulation for post-treatment of aerobic-anoxic effluents can fulfil the limits for discharge to sewerage (even for colour mainly exerted by hardly biodegradable melanoidins), however, the required amounts of coagulants were relatively high.


2004 ◽  
Vol 50 (5) ◽  
pp. 67-72 ◽  
Author(s):  
M. Gladchenko ◽  
E. Starostina ◽  
S. Shcherbakov ◽  
B. Versprille ◽  
S. Kalyuzhnyi

The UASB reactor (35°C) was quite efficient for removal of bulk COD (62-67%) even for such high strength and recalcitrant wastewater as the cultivation medium from the first separation process of baker's yeasts (the average organic loading rates varied from 3.7 to 10.3 g COD/l/d). The aerobic-anoxic biofilter (20°C) can be used for removal of remaining BOD and ammonia from strong nitrogenous anaerobic effluents; however, it suffered from COD-deficiency to fulfil denitrification requirements. To balance the COD/N ratio, some bypass of raw wastewater should be added to the biofilter feed. The application of iron chloride coagulation for post-treatment of aerobic effluents may fulfil the discharge limits (even for colour mainly exerted by hardly biodegradable melanoidins) under iron concentrations around 200 mg/l.


2005 ◽  
Vol 52 (1-2) ◽  
pp. 167-173 ◽  
Author(s):  
G.O. Sigge ◽  
T.J. Britz ◽  
P.C. Fourie ◽  
C.A. Barnardt

The efficiency of ozone as a pre- and post-treatment to UASB treatment was investigated, followed by a study into UASB reactor performance with ozonated wastewater as substrate. Combinations of pre- and/or post-ozonation with UASB treatment gave better results than ozonation or UASB alone and COD reductions of 53.0–98.9% were achieved for treatment of canning and winery wastewaters. A UASB reactor was fed with pre-ozonated cannery wastewater for over 70 d. COD removal improved from between 58.8 and 64.4% to between 85.3 and 91.8% after pre-ozonated substrate feed commenced. Subsequent increases in organic loading rate (OLR) from 2.4 to 3.4 kgCOD m−3.d−1 did not affect reactor performance. By including a final post-ozonation treatment to this UASB effluent a total COD reduction of 99.2% was achieved.


2019 ◽  
Vol 79 (12) ◽  
pp. 2251-2259 ◽  
Author(s):  
M. Esparza-Soto ◽  
A. Jacobo-López ◽  
M. Lucero-Chávez ◽  
C. Fall

Abstract The objective of the present study was to determine the optimum operating temperature of laboratory-scale upflow anaerobic sludge blanket (UASB) reactors during the treatment of a chocolate-processing industry wastewater at medium applied organic loading rates (OLRappl). Four UASB reactors were operated at different temperature (15, 20, 25 and 30 °C) and three OLRappl (2, 4 and 6 kg soluble chemical oxygen demand (CODs)/(m3 d)). The flowrate and the hydraulic retention time were constant (11.5 L/d and 6 h, respectively). The monitored parameters were pH, temperature, CODs, and total and volatile suspended solids. The CODs removal efficiency (RE) and biogas production rate (BPR) were calculated. The 15 °C UASB reactor had the lowest RE (39 to 78%) due to the low operating temperature. Regardless of the OLRappl, the RE of the 20, 25 and 30 °C reactors was high and similar to each other (between 88 and 94%). The BPR of the four UASB reactors had the same behaviour as the RE (BPR of 15 °C: 0.3 to 0.5 Lbiogas/(Lreactor d) (Lb/(Lr d)) and BPR of 20, 25 and 30 °C: 0.5 to 1.9 Lb/(Lr d)).


2011 ◽  
Vol 64 (11) ◽  
pp. 2265-2273 ◽  
Author(s):  
E. Castelló ◽  
V. Perna ◽  
J. Wenzel ◽  
L. Borzacconi ◽  
C. Etchebehere

This study investigated the microbial community developed in a UASB reactor for hydrogen production and correlated it to reactor performance. The reactor was inoculated with kitchen waste compost and fed with raw cheese whey at two organic loading rates, 20 gCOD/Ld and 30 gCOD/Ld. Hydrogen production was very variable, using an OLR of 30 gCOD/Ld averaged 1.0 LH2/Ld with no methane produced under these conditions. The hydrogen yield was also very variable and far from the theoretical. This low yield could be explained by selection of a mixed fermentative population with presence of hydrogen producing organisms (Clostridium, Ruminococcus and Enterobacter) and other non-hydrogen producing fermenters (Lactobacillus, Dialister and Prevotella). The molecular analysis of the raw cheese whey used for feeding revealed the presence of three predominant organisms that are affiliated with the genera Buttiauxella (a low-yield hydrogen producer) and Streptococcus (a lactic acid-producing fermenter). Although these organisms did not persist in the reactor, the continuous addition of these fermenters could decrease the reactor's hydrogen yield.


1992 ◽  
Vol 25 (7) ◽  
pp. 103-111 ◽  
Author(s):  
D. R. Paula ◽  
E. Foresti

This paper shows the response of a UASB reactor subjected to increasing influent COD concentrations. The study was carried out using a 10.5 1 UASB reactor continuously operated during ten months, and fed with synthetic wastes prepared daily using glucose, ammonium acetate, methanol and nutrient solution. The. flow rate of 16 l.d−1 was held constant throughout the experiment, corresponding to a hydraulic retention time (θ) of 15.6 h. Four intermediate sampling ports besides the influent and effluent ones allowed a study of the reactor behaviour along its vertical profile. For average values of the initial COD concentrations ranging from 1780 to 9700 mg.l−1, corresponding to volumetric loading rates (BV) of 2.7 to 14.8 kg COD.m−3. d−1, COD removal efficiencies varying from 98 to 80% were achieved. It could be concluded that the step-increase of the influent COD affected the reactor performance in two different ways. First, the reactor could assimilate the shock loads due to the step-increase of the influent COD and BV beyond the transient periods following changes in the operation parameters. Second, the overall efficiency decreased gradually with the step-increase of the initial COD and BV. Kinetic studies indicate that the overall kinetic parameters are probably affected by the step-increase of influent COD concentrations.


1996 ◽  
Vol 55 (1) ◽  
pp. 47-54 ◽  
Author(s):  
S.V. Kalyuzhnyi ◽  
V.I. Sklyar ◽  
M.A. Davlyatshina ◽  
S.N. Parshina ◽  
M.V. Simankova ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document