Experimental Evaluation of Thermal and Combustion Performance of a DI Diesel Engine Using Waste Cooking Oil Methyl Ester and Diesel Fuel Blends

2020 ◽  
pp. 551-559
Author(s):  
Prabhakar Sharma ◽  
Avdhesh Kr. Sharma
Keyword(s):  
Diesel Engine ◽  
Methyl Ester ◽  
Diesel Fuel ◽  
Experimental Evaluation ◽  
Waste Cooking Oil ◽  
Combustion Performance ◽  
Cooking Oil ◽  
Fuel Blends ◽  
Di Diesel Engine

Impact of Diesel-Butanol-Waste Cooking Oil Biodiesel Blends on Stationary Diesel Engine Performance and Emission Characteristics

2020 ◽  
pp. 173-192
Author(s):  
H. Sharon ◽  
Joel Jackson R. ◽  
Prabha C.
Keyword(s):  
Diesel Engine ◽  
Diesel Fuel ◽  
Specific Energy Consumption ◽  
Waste Cooking Oil ◽  
Nox Emission ◽  
Performance And Emission ◽  
Cooking Oil ◽  
Fuel Blends ◽  
Hydrocarbon Emission ◽  
Smoke Opacity

Feed stock cost and NOX emission are the major barriers for commercialization of biodiesel. Waste cooking oil is well identified as one of the cheapest feed stocks for biodiesel production. This chapter reduces NOX emission of waste cooking oil biodiesel. Test fuel blends are prepared by mixing diesel (20 to 50 v/v%), butanol (5 v/v%), and waste cooking oil biodiesel (45 to 75 v/v%). Fuel properties of waste cooking oil biodiesel are enhanced due to addition of diesel and butanol. Brake specific energy consumption of the blends is higher than diesel fuel. Harmful emissions like carbon monoxide, nitrous oxide, and smoke opacity are lower for blends than diesel fuel. Increasing biodiesel concentration in blend also reduces hydrocarbon emission to a significant extent. The obtained results justify the suitability of proposed cheap blends for diesel engine emission reduction.

A Study of the Performance Emission and Combustion Characteristics of a DI Diesel Engine Using Waste Cooking Oil Methyl Ester-Ethanol Blends

2012 ◽  
Author(s):  
R. Anand ◽  
G. R. Kannan ◽  
P. Karthikeyan
Keyword(s):  
Diesel Engine ◽  
Methyl Ester ◽  
Alternative Fuels ◽  
Direct Injection ◽  
Specific Energy Consumption ◽  
Load Condition ◽  
Waste Cooking Oil ◽  
Cooking Oil ◽  
Di Diesel Engine ◽  
Ethanol Blends

The growing environmental concerns and the depletion of petroleum reserves have caused the development of alternative fuels. Biodiesel and alcohols are receiving increasing attention as alternative fuels for diesel engines due to well oxygenated, renewable fuels. In this study, a single cylinder, naturally aspirated, direct injection diesel engine has been experimentally investigated using ethanol-blended waste cooking oil methyl ester. Various proportion of biodiesel-ethanol blends were used in stability test at the different temperatures from 10 °C to 40 °C in the increment of 10°C. Based on the stability tests and improvement in fuel properties, B90E10 (90% biodiesel and 10% ethanol) and B80E20 (80% biodiesel and 20% ethanol) were selected for this investigation. Test results revealed that the improved engine characteristics with the use of B9E10 especially in comparison with B80E20. Reduction in brake thermal efficiency by 3.8% and slightly higher brake specific energy consumption of 15.1% were observed with B90E10 when compared to diesel at 100% load condition. Carbon monoxide, unburnt hydrocarbon, nitric oxide and smoke emission of B90E10 were reduced by 0.09% by vol., 10 ppm, 187 ppm and 12.9%, respectively compared to diesel. B90E10 exhibited lower peak pressure of 70.5 bar, slightly longer ignition delay of 14.2 °CA, and combustion duration of 43.3 °CA was also observed at 100% load condition.

Effect of compression ratio variation and waste cooking oil methyl ester on the combustion and emission characteristics of an engine

2019 ◽  
Vol 31 (7) ◽  
pp. 1257-1280 ◽  
Author(s):  
Abbas Hojati ◽  
Alireza Shirneshan
Keyword(s):  
Methyl Ester ◽  
Compression Ratio ◽  
Diesel Fuel ◽  
Release Rate ◽  
Experimental Tests ◽  
Waste Cooking Oil ◽  
Cylinder Pressure ◽  
Fuel Blend ◽  
Cooking Oil ◽  
Fuel Blends

In this research, a thermodynamic zero-dimensional model has been done to predict performance characteristics (in-cylinder pressure, heat released, and the thermal efficiency) of a diesel engine with the use of biodiesel–diesel fuel blends (B0, B20, B50, B80, and B100) at different compression ratios (14, 15, 16, 17, and 18). The corresponding mathematical and thermodynamic relationships have been solved in MATLAB. Based on the experimental tests, it was found that the developed model can predict the engine variables sufficiently. According to the results, the heat release rate and the cylinder pressure increased for all fuel blends by an increase in the compression ratio. Moreover, with the increasing biodiesel amount in the fuel blend (up to 50%) heat release rate and the cylinder pressure increased but these variables have a reduction when biodiesel percentage increases from 50 to 100 due to the lower heating value of waste cooking oil methyl ester in comparison with neat diesel fuel. Moreover, according to the experimental tests, carbon monoxide emission was reduced when biodiesel proportion increased in the fuel blend but the nitrogen oxides emitted from the engine enhanced when biodiesel amount in the fuel mixture increased. According to the results, it can be concluded that B50 has better combustion characteristics among all fuel blends.

Sign in / Sign up

Export Citation Format

Share Document