Influence of pectin and glucose on growth and polygalacturonase production by Aspergillus niger in solid-state cultivation

2005 ◽  
Vol 32 (8) ◽  
pp. 371-377 ◽  
Author(s):  
Roselei Claudete Fontana ◽  
Suzielle Salvador ◽  
Mauricio Moura da Silveira
2018 ◽  
Vol 81 (1) ◽  
Author(s):  
Halifah Pagarra ◽  
Roshanida A. Rahman ◽  
Nur Izyan Wan Azelee ◽  
Rosli Md Illias

Polygalacturonases represent an important member of pectinases group of enzymes with immense industrial applications. The activity of exo-polygalacturonase produced by Aspergillus niger was studied in solid state fermentation (SSF) using Nephrolepis biserrata leaves as substrate. Central composite design (CCD) was used to optimize four significant variables resulted from the screening process that has been initially analyzed for the production of exo-polygalacturonase which are incubation time, temperature, concentration of pectin and moisture content. The optimum exo-polygalacturonase production obtained was 54.64 U/g at 120 hours of incubation time, temperature at 340C, 5.0 g/L of pectin concentration and 75.26% of moisture content. For partial characterization of exo-polygalacturonase, the optimum temperature and pH were obtained at 50°C and pH 4.0, respectively. SDS-PAGE analysis showed that molecular weight of exo-polygalacturonase were 35 and 71 kDa. This study has revealed a significant production of exo-polygalacturonase by A. niger under SSF using cheap and easily available substrate and thus could found immense potential application in industrial sectors and biotechnology


2007 ◽  
Vol 50 (5) ◽  
pp. 759-766 ◽  
Author(s):  
Jorge Alberto Vieira Costa ◽  
Eliane Colla ◽  
Glênio Magagnin ◽  
Lucielen Oliveria dos Santos ◽  
Mauricio Vendruscolo ◽  
...  

Amyloglucosidase (AMG) and exo-polygalacturonase (exo-PG) were simultaneously produced by two different strains of Aspergillus niger in solid-state fermentation (SSF) using defatted rice-bran as substrate. The effect of Aspergillus niger strain (t0005/007-2 and/or CCT 3312), inoculum type (spore suspension or fermented bran) and addition of inducers (pectin and/or starch) to the culture media was studied using a 3² x 2¹ factorial experimental design. The production of AMG and exo-PG was significantly affected by fungal strain and inoculum type but inducers had no effect. The maximum yields obtained were 1310 U/g dm for AMG using a spore suspension of A. niger CCT 3312 and 50.2 U/g dm for exo-PG production, using A. niger t0005/007-2 and fermented bran as inoculum. The yields obtained represented acceptable values in comparison with data available in the literature and indicated that defatted rice-bran was a good nutrient source.


2019 ◽  
pp. 1-3
Author(s):  
Madhuri B ◽  
Narasimha G ◽  
Balaji M*

Areca palm (ChrysalidoCarpus lutescenes) a widely used plant having feathery arching brands with 100 leaflets. All these plants produce much of waste in additions to greeny and nuts. This waste of spade is used for the production of various molecules that are used in industry and pharma sector. Fermentation techniques are used to generate economically important enzymes for industrial and pharmaceutical purposes. Cellulase enzyme degrades the cellulose in between β-1, 4 glucosidic link found in lignocellulosic complex which under physical treatment is slower to degrade. The present study of Aspergillus niger for cellulose production was carried in solid state (SS) and submerged (SM) fermentations for production of cellulase enzyme. Cellulase production in SSF after 72 h of fermentation was 8.02 and in SMF activity was 2.98 per ml of cultured broth at H 6 and temperature at 30°C. Both SMF and SSF were supplemented with lactose and lactobionic acid, which acted as cellulase P production inducers. The aim of the present work was to study the effect of Areca palm spade as substrate for Aspergillus niger and its cellulase production under SMF and SSF.


2021 ◽  
Vol 9 (5) ◽  
pp. 895
Author(s):  
Carlotta Alias ◽  
Daniela Bulgari ◽  
Fabjola Bilo ◽  
Laura Borgese ◽  
Alessandra Gianoncelli ◽  
...  

A low-energy paradigm was adopted for sustainable, affordable, and effective urban waste valorization. Here a new, eco-designed, solid-state fermentation process is presented to obtain some useful bio-products by recycling of different wastes. Urban food waste and scraps from trimmings were used as a substrate for the production of citric acid (CA) by solid state fermentation of Aspergillus niger NRRL 334, with a yield of 20.50 mg of CA per gram of substrate. The acid solution was used to extract metals from waste printed circuit boards (WPCBs), one of the most common electronic waste. The leaching activity of the biological solution is comparable to a commercial CA one. Sn and Fe were the most leached metals (404.09 and 67.99 mg/L, respectively), followed by Ni and Zn (4.55 and 1.92 mg/L) without any pre-treatments as usually performed. Commercial CA extracted Fe more efficiently than the organic one (123.46 vs. 67.99 mg/L); vice versa, biological organic CA recovered Ni better than commercial CA (4.55 vs. 1.54 mg/L). This is the first approach that allows the extraction of metals from WPCBs through CA produced by A. niger directly grown on waste material without any sugar supplement. This “green” process could be an alternative for the recovery of valuable metals such as Fe, Pb, and Ni from electronic waste.


2011 ◽  
Vol 165 (1) ◽  
pp. 382-395 ◽  
Author(s):  
Jaqueline Renovato ◽  
Gerardo Gutiérrez-Sánchez ◽  
Luis V. Rodríguez-Durán ◽  
Carl Bergman ◽  
Raúl Rodríguez ◽  
...  

2011 ◽  
Vol 54 (3) ◽  
pp. 559-568 ◽  
Author(s):  
Christiane Trevisan Slivinski ◽  
Alex Vinicius Lopes Machado ◽  
Jorge Iulek ◽  
Ricardo Antônio Ayub ◽  
Mareci Mendes de Almeida

BioResources ◽  
2014 ◽  
Vol 9 (4) ◽  
Author(s):  
Valesca Weingartner Montibeller ◽  
Luciana Porto de Souza Vandenberghe ◽  
Antonella Amore ◽  
Carlos Ricardo Soccol ◽  
Leila Birolo ◽  
...  

LWT ◽  
2018 ◽  
Vol 87 ◽  
pp. 241-249 ◽  
Author(s):  
Francisc Vasile Dulf ◽  
Dan Cristian Vodnar ◽  
Eva-Henrietta Dulf ◽  
Zoriţa Diaconeasa ◽  
Carmen Socaciu

2016 ◽  
Vol 29 (1) ◽  
pp. 222-233 ◽  
Author(s):  
TAMIRES CARVALHO DOS SANTOS ◽  
GEORGE ABREU FILHO ◽  
AILA RIANY DE BRITO ◽  
AURELIANO JOSÉ VIEIRA PIRES ◽  
RENATA CRISTINA FERREIRA BONOMO ◽  
...  

ABSTRACT: Prickly palm cactus husk was used as a solid-state fermentation support substrate for the production of cellulolytic enzymes using Aspergillus niger and Rhizopus sp. A Box-Behnken design was used to evaluate the effects of water activity, fermentation time and temperature on endoglucanase and total cellulase production. Response Surface Methodology showed that optimum conditions for endoglucanase production were achieved at after 70.35 h of fermentation at 29.56°C and a water activity of 0.875 for Aspergillus niger and after 68.12 h at 30.41°C for Rhizopus sp. Optimum conditions for total cellulase production were achieved after 74.27 h of fermentation at 31.22°C for Aspergillus niger and after 72.48 h and 27.86°C for Rhizopus sp. Water activity had a significant effect on Aspergillus niger endoglucanase production only. In industrial applications, enzymatic characterization is important for optimizing variables such as temperature and pH. In this study we showed that endoglucanase and total cellulase had a high level of thermostability and pH stability in all the enzymatic extracts. Enzymatic deactivation kinetic experiments indicated that the enzymes remained active after the freezing of the crude extract. Based on the results, bioconversion of cactus is an excellent alternative for the production of thermostable enzymes.


Sign in / Sign up

Export Citation Format

Share Document