Rapid release of heavy metals and anions from polyethylene laminated paper cups into hot water

Author(s):  
Abdullah Akhdhar ◽  
Deia Abd El-Hady ◽  
Mohammed Almutairi ◽  
Khulood K. Alnabati ◽  
Abdullah Alowaifeer ◽  
...  
2005 ◽  
Vol 62 (6) ◽  
pp. 564-571 ◽  
Author(s):  
Cleide Aparecida de Abreu ◽  
Bernardo van Raij ◽  
Mônica Ferreira de Abreu ◽  
Antonio Paz González

Microelements are an important issue in agriculture, due to their need as micronutrients for plants and also to the possibility of the build-up of toxic levels for plants and animals. Five micronutrients (B, Cu, Fe, Mn, and Zn) are routinely determined in soil analysis for advisory purposes. Other four elements (Cd, Cr, Pb, and Ni) are considered environmentally important heavy metals in farmland soils. Thus high contents of these metals in cropland might go eventually unnoticed. In this paper we present an approach that can be used to monitor the contents of the nine elements in farmland soils using advisory soil testing. A total of 13,416 soil samples from 21 Brazilian states, 58% of them from the state of São Paulo, sent by farmers were analyzed. Boron was determined by hot water extraction and the other metals were determined by DTPA (pH 7.3) extraction. The ranges of content, given in mg dm-3 soil, were the following: B, 0.01-10.6; Cu, 0.1-56.2; Fe, 0.5-476; Mn, 1-325; Zn, 1-453; Cd, 0.00-3.43, Cr, 0.00-42.9; Ni, 0.00-65.1; Pb, 0.00-63.9. The respective average values for São Paulo were: B-0.32; Cu-2.5; Fe-36; Mn-16; Zn-4.8; Cd-0.02; Cr-0.03; Ni-0.18; Pb-0.85. For other states the results are in the same ranges. The higher values are indicative of anthropogenic inputs, either due to excess application of fertilizers or to industrial or mining activities. The conclusion is that massive chemical analysis of farmland soil samples could serve as a database for indicating potential micronutrient deficiency and excesses or heavy metal buil-up in croplands, allowing preventive actions to be taken.


Water ◽  
2019 ◽  
Vol 11 (12) ◽  
pp. 2519 ◽  
Author(s):  
Rafael Fernández-González ◽  
María Ángeles Martín-Lara ◽  
Gabriel Blázquez ◽  
Antonio Pérez ◽  
Mónica Calero

Olive cake obtained as a by-product from the olive oil industry has been evaluated as biosorbent of heavy metals from aqueous solutions in batch and continuous systems (fixed-bed columns). First, a complete study of effect of hydrothermal treatment with water on biosorption capacity of resulting solid was performed. Results showed that the values of biosorption capacity increased when the particle size of material decreased and the temperature of treatment increased. Then, hydrolyzed olive cake was treated by common chemicals (hot water, nitric acid, and sodium hydroxide) and the impact of chemical treatment was analyzed. The results were well reproduced by Langmuir and Freundlich isotherm models, getting maximum experimental biosorption capacities that changed between 42.34 mg/g obtained for the solid material modified by NaOH and 14.27 mg/g obtained for the solid material modified by nitric acid. Finally, laboratory tests in fixed-bed columns were performed with four different heavy metals and at three different inlet concentrations. The biosorption capacity increased from 2.83 mg/g (Cr), 4.51 mg/g (Cu), 12.30 mg/g (Pb), and 4.10 mg/g (Zn) to 3.08 mg/g (Cr), 5.17 mg/g (Cu), 13.21 mg/g (Pb), and 5.51 mg/g (Zn) when the concentration of metal ions increased, from 50 mg/L to 200 mg/L, respectively. Also, the experimental data obtained was successfully correlated with the Thomas, Yoon–Nelson, and dose–response models.


2002 ◽  
Vol 11 (4) ◽  
pp. 273-284 ◽  
Author(s):  
R. MÄKELÄ-KURTTO ◽  
J. SIPPOLA

This study is part of the long-term monitoring of Finnish arable land and it is based on soil analyses of 705 monitoring sites sampled in 1998. The same sites were sampled twice previously,in 1974 and 1987. We describe here the state of the Finnish cultivated soils in 1998 and changes in soil quality since 1987. The samples were analysed for organic C, volume weight, pH, P, K, Ca, S, Mg, Al, B, Cd, Co, Cr, Cu, Fe, Mn, Mo, Se and Zn.Macronutrients were extracted with 0.5 M ammonium acetate + 0.5 M acetic acid (pH 4.65) and most micronutrients, Al and heavy metals with the same solution + 0.02 M Na 2 EDTA. Hot water was used to extract B and Se. From 1987 to 1998, soil P, Ca, Mg, S, Cr, Cu, Zn, volume weight and electrical conductivity increased and soil K, B, pH and organic C decreased. There was no change in soil Al, Cd, Mn and Ni. Between 1987 and 1998,the use of P,K,B and Cu in mineral fertilisers declined whereas that of Ca in liming agents and Zn in mineral fertilisers increased. With the exception of P and Cu,these changes affected the concentrations of easily soluble macro- and micronutrients in the soil accordingly. The slight decrease in soil pH might be due to the increase in the use of fertliser N. The finding that soil Cd and Ni ceased to increase and that soil Cr increased only slightly was attributed to the dramatic reduction in national emissions and bulk depositions of heavy metals.;


2021 ◽  
Vol 404 ◽  
pp. 124118
Author(s):  
Ved Prakash Ranjan ◽  
Anuja Joseph ◽  
Sudha Goel

Author(s):  
Shakhawat Chowdhury ◽  
Fayzul Kabir ◽  
Mohammad Abu Jafar Mazumder ◽  
Khalid Alhooshani ◽  
Amir Al-Ahmed ◽  
...  

Abstract Supply water is an important source of human exposure to heavy metals through the oral pathway. Due to stagnation of water in plumbing systems, exposure concentrations of heavy metals from tap water can be higher than water distribution systems (WDS), which is often ignored by the regulatory agencies. In this study, concentrations of a few heavy metals (arsenic (As), chromium (Cr), copper (Cu), mercury (Hg), manganese (Mn), magnesium (Mg), zinc (Zn) and iron (Fe)) and water quality parameters were monitored in WDS, plumbing pipe (PP) and hot water tanks (HWT). Multiple models were trained for predicting metal concentrations in PP and HWT, which were validated. Heavy metal concentrations in HWT were 1.2–8.1 and 1.4–6.7 times the concentrations in WDS and PP respectively. Concentrations of As, Cr, Cu, Hg and Zn were in the increasing order of WDS, PP and HWT. Concentrations of Cr and Fe were higher during summer while Cu and Zn were higher in winter. The models showed variable performances for PP and HWT (R2: PP = 0.61–0.99; HWT = 0.71–0.99). The validation data demonstrated variable correlation coefficients (r: PP = 0.45–0.99; HWT = 0.83–0.99). Few models can be used for predicting heavy metals in tap water to reduce the cost of expensive sampling and analysis.


Author(s):  
Randall W. Smith ◽  
John Dash

The structure of the air-water interface forms a boundary layer that involves biological ,chemical geological and physical processes in its formation. Freshwater and sea surface microlayers form at the air-water interface and include a diverse assemblage of organic matter, detritus, microorganisms, plankton and heavy metals. The sampling of microlayers and the examination of components is presently a significant area of study because of the input of anthropogenic materials and their accumulation at the air-water interface. The neustonic organisms present in this environment may be sensitive to the toxic components of these inputs. Hardy reports that over 20 different methods have been developed for sampling of microlayers, primarily for bulk chemical analysis. We report here the examination of microlayer films for the documentation of structure and composition.Baier and Gucinski reported the use of Langmuir-Blogett films obtained on germanium prisms for infrared spectroscopic analysis (IR-ATR) of components. The sampling of microlayers has been done by collecting fi1ms on glass plates and teflon drums, We found that microlayers could be collected on 11 mm glass cover slips by pulling a Langmuir-Blogett film from a surface microlayer. Comparative collections were made on methylcel1ulose filter pads. The films could be air-dried or preserved in Lugol's Iodine Several slicks or surface films were sampled in September, 1987 in Chesapeake Bay, Maryland and in August, 1988 in Sequim Bay, Washington, For glass coverslips the films were air-dried, mounted on SEM pegs, ringed with colloidal silver, and sputter coated with Au-Pd, The Langmuir-Blogett film technique maintained the structure of the microlayer intact for examination, SEM observation and EDS analysis were then used to determine organisms and relative concentrations of heavy metals, using a Link AN 10000 EDS system with an ISI SS40 SEM unit. Typical heavy microlayer films are shown in Figure 3.


1993 ◽  
Vol 88 (3) ◽  
pp. 522-529 ◽  
Author(s):  
Udo W. Stephan ◽  
Gunter Scholz
Keyword(s):  

2011 ◽  
Author(s):  
Parker Woody ◽  
Michael Zhang ◽  
Craig Pulsipher ◽  
Dawson Hedges ◽  
Bruce Brown

Sign in / Sign up

Export Citation Format

Share Document