Contribution of Hydrothermal Processes to the Enrichment of Lithium in Brines: Evidence from Water–Rock Interacting Experiments

Author(s):  
Xueyin Yuan ◽  
Yufei Hu ◽  
Yanjun Zhao ◽  
Qiang Li ◽  
Chenglin liu
2010 ◽  
Vol 1247 ◽  
Author(s):  
Rocío Calderón-Villajos ◽  
Carlos Zaldo ◽  
Concepción Cascales

AbstractControlled reaction conditions in simple, template-free hydrothermal processes yield Tm-Lu2O3 and Tm-GdVO4 nanocrystals with well-defined specific morphologies and sizes. In both oxide families, nanocrystals prepared at pH 7 reaction media exhibit photoluminescence in ∼1.95 μm similar to bulk single crystals. For the lowest Tm3+ concentration (0.2 % mol) in GdVO4 measured 3H4 and 3F4 fluorescence lifetimes τ are very near to τrad.


Minerals ◽  
2021 ◽  
Vol 11 (4) ◽  
pp. 355
Author(s):  
Maria Rampilova ◽  
Anna Doroshkevich ◽  
Shrinivas Viladkar ◽  
Elizaveta Zubakova

The main mass of the Sevathur carbonatite complex (Tamil Nadu, India) consists of dolomite carbonatite with a small number of ankerite carbonatite dikes. Calcite carbonatite occurs in a very minor amount as thin veins within the dolomite carbonatite. The age (207Pb/204Pb) of the Sevathur carbonatites is 801 ± 11 Ma, they are emplaced within the Precambrian granulite terrains along NE–SW trending fault systems. Minor minerals in dolomite carbonatite are fluorapatite, phlogopite (with a kinoshitalite component), amphibole and magnetite. Pyrochlore (rich in UO2), monazite-Ce, and barite are accessory minerals. Dolomite carbonatite at the Sevathur complex contains norsethite, calcioburbankite, and benstonite as inclusions in primary calcite and are interpreted as primary minerals. They are indicative of Na, Sr, Mg, Ba, and LREE enrichment in their parental carbonatitic magma. Norsethite, calcioburbankite, and benstonite have not been previously known at Sevathur. The hydrothermal processes at the Sevathur carbonatites lead to alteration of pyrochlore into hydropyrochlore, and Ba-enrichment. Also, it leads to formation of monazite-(Ce) and barite-II.


Author(s):  
Alejandro Ayala-Cortés ◽  
Pedro Arcelus-Arrillaga ◽  
Marcos Millan ◽  
Camilo A. Arancibia-Bulnes ◽  
Patricio J. Valadés-Pelayo ◽  
...  

2021 ◽  
Author(s):  
Giovanni Baccolo ◽  
Barbara Delmonte ◽  
Paul Niles ◽  
Giannantonio Cibin ◽  
Elena Di Stefano ◽  
...  

<p>On Earth, jarosite is a weathering product forming in acidic-oxidative environments from the alteration of iron-bearing minerals in presence of liquid water. Typical settings where this iron-potassium hydrated sulphate is found, are weathering zones of pyrite-rich deposits, evaporative basins and fumaroles. Jarosite is not only known on Earth, it also occurs on Mars, where it was firstly identified by the Opportunity rover. The mineral was in fact recognized in the finely layered formations outcropping at Meridiani Planum and that were accurately investigated by the rover (Klingelhöfer et al. 2004). Since jarosite requires liquid water to form, its occurrence on Mars has been regarded as an evidence for the presence of liquid water in the geologic past of Mars (Elwood-Madden et al., 2004). Since then, many models have been proposed to describe the environments where the precipitation of Martian jarosite took place. The most accepted ones deal with evaporative basins similar to Earth’s playas, others concern volcanic activity and hydrothermal processes. An alternative proposal predicted that jarosite may have formed as a consequence of weathering of mineral dust trapped in massive ice deposits, i.e. the ice-weathering model (Niles & Michalsky, 2009). The hypothesis that jarosite formed on Mars because of low-temperature, acidic and water limited weathering, is not new (Burns, 1987), but until now no direct evidences were available to support it.</p><p>A potential Earth analogue to investigate such processes is deep Antarctic ice. We present a first investigation of deep ice samples from the Talos Dome ice core (East Antarctica) aimed at the identification of englacial jarosite, so as to support the ice-weathering model. Evidences gathered through independent techniques showed that jarosite is actually present in deep Antarctic ice and results from the weathering of dust trapped into ice. The process is controlled by the re-crystallization of ice grains and the concurrent re-location of impurities at grain-junctions, which both depend on ice depth. This study demonstrates that the deep englacial environment is suitable for jarosite precipitation. Our findings support the hypothesis that, as originally predicted by the ice-weathering model, paleo ice-related processes have been important in the geologic and geochemical history of Mars.</p><p> </p><p><strong>References</strong></p><p>Burns, R. Ferric sulfates on Mars. <em>J. Geophys. Res.</em> <strong>92</strong>, E570-E574 (1987).</p><p>Elwood-Madden et al., 2004. Jarosite as an indicator of water-limited chemical weathering on Mars. <em>Nature</em> <strong>431</strong>, 821-823 (2004).</p><p>Klingelhöfer, G. et al. Jarosite and Hematite at Meridiani Planum from Opportunity's Mössbauer Spectrometer. <em>Science</em> <strong>306</strong>, 1740-1745 (2004).</p><p>Niles, P. B. & Michalski, J. M. Meridiani Planum sediments on Mars formed through weathering in massive ice deposits. <em>Nat. Geosci.</em> <strong>2</strong>, 215-220 (2009).</p>


2021 ◽  
pp. 1-16
Author(s):  
Stewart D Redwood ◽  
David M Buchs ◽  
David Edward Cavell

Abstract An extensive deposit of agate occurs in Pedro González Island in the Gulf of Panama. Previous archaeological research showed that the agate was exploited between 6200 and 5600 cal BP to make stone tools found at the oldest known Preceramic human settlement in the Pearl Island archipelago. We constrain here the origin and geological context of the agate through a geological and geochemical study of the island. We show that it includes primary volcanic breccias, lavas, and tuffaceous marine deposits with sedimentary conglomerates and debris flow deposits, which we define as the Pedro González Formation. This formation records submarine to subaerial volcanic activity along an island arc during the Oligo-Miocene, confirming previous regional models that favour progressive emergence of the isthmus in the early Miocene. The igneous rocks have an extreme tholeiitic character that is interpreted to reflect magmatic cessation in eastern Panama during the early Miocene. The agate is hosted in andesitic lavas in unusually large amygdales up to 20–40 cm in diameter, as well as small amygdales (0.1–1.0 cm) in a bimodal distribution, and in veins. The large size of the agates made them suitable for tool manufacture. Field evidence suggests that the formation of large amygdales resulted from subaqueous lava–sediment interaction, in which water released from unconsolidated tuffaceous deposits at the base of lava flows rose through the lavas, coalesced, and accumulated below the chilled lava top, with subsequent hydrothermal mineralization. These amygdales could therefore be regarded as an unusual result of combined peperitic and hydrothermal processes.


2015 ◽  
Vol 68 (1) ◽  
pp. 53-59 ◽  
Author(s):  
Gisele Tavares Marques ◽  
Marcondes Lima da Costa ◽  
Érico Rodrigues Gomes

Orange opals from Buriti dos Montes (Piauí, northeastern Brazil) have gemological properties that favor their use as jewelry; these characteristics include their colors, transparency, relatively high stability and hardness. The exotic content of solid inclusions provides greater beauty to the opals of this region. These opals originated from hydrothermal processes and are found mainly as veinlets and veins in the sandstones of the Serra Grande Group, sectioned by diabase dikes and sills of the Sardinha Formation. Solid inclusions, such as bubbles, botryoidal aggregates, dendrites, and nodules, among others, consist mainly of kaolinite, hematite/goethite and quartz and influence the chemical composition of opals. Intense zoning of quartz crystals and high values of Ba and Fe suggest that opal deposits were formed in a hydrothermal environment. Diabase dykes could have been responsible for heating the hydrothermal fluids. Sandstones, rich in aqueous solutions, also contributed to the available silica for the saturation of these solutions, and fractures enabled the migration and entrapment of hydrothermal fluids, resulting in the mineralized veins.


Sign in / Sign up

Export Citation Format

Share Document