Adsorption and separation of Re(VII) using trimethylamine-functionalized strong base anion exchange resin

2020 ◽  
Vol 326 (1) ◽  
pp. 445-454
Author(s):  
Fuping Liu ◽  
Rong Hua ◽  
Feng Zhang ◽  
Heng Liu ◽  
Chuan-Pin Lee ◽  
...  
Keyword(s):  
Anion Exchange ◽  
Exchange Resin ◽  
Anion Exchange Resin ◽  
Strong Base

PEMODELAN MATEMATIS ADSORPSI CO2 DENGAN STRONG BASE ANION EXCHANGE RESIN SEBAGAI ADSORBEN UNTUK PURIFIKASI BIOGAS

2015 ◽  
Vol 5 (1) ◽  
pp. 11
Author(s):  
Anies Mutiari ◽  
Wiratni Wiratni ◽  
Aswati Mindaryani
Keyword(s):  
Anion Exchange ◽  
Pilot Plant ◽  
Exchange Resin ◽  
Anion Exchange Resin ◽  
Scale Up ◽  
Sum Of Squares ◽  
Strong Base ◽  
Model Transfer ◽  
Plant Parameter

Pemurnian biogas telah banyak dilakukan untuk menghilangkan kadar CO2  dan meningkatkan kandungan CH4  yang terkandung di dalamnya. Kandungan CH4 yang tinggi akan memberikan unjuk kerja yang lebih baik. Model  matematis proses adsorpsi CO2 disusun berdasarkan teori lapisan film antar fasa, dimana pada proses yang ditinjau terdapat tiga fase yaitu gas, cair dan padat. Model matematis dari data eksperimental   kecepatan dan kesetimbangan proses adsorpsi CO2 melalui mekanisme pertukaran ion di suatu kolom adsorpsi telah dibuat. Model ini dibuat untuk mencari konstanta yang dapat dipergunakan pada proses scale up data laboratorium ke skala pilot plant. Parameter proses kecepatan yang dicari nilainya adalah koefisien transfer massa massa volumetris CO2 pada fase cair (kLa), koefisien transfer massa volumetris CO2 pada fasegas (kGa) dan tetapan laju reaksi (k1 dan k2). Pada hasil penelitian ini ditunjukkan bahwa nilai parameter yang diperoleh sesuai hasil fitting data dengan model matematis yang digunakan, yaitu model transfer massa pada lapisan film antar fase secara seri: adalah kGa, kla, k1 dan k2  dengan nilai Sum of Squares Error (SSE) rata-rata 0,0431. Perbandingan nilai kGa hasil simulasi dan teoritisnya memberikan kesalahan rata-rata 18,79%. Perbandingan nilai kLa hasil simulasi dan teoritis memberikan kesalahan rata-rata 7,92%.Kata kunci: model matematis, adsorpsi CO2, pemurnian biogas

An Efficient and Environment Friendly Procedure for the Synthesis of Arylmethylenemalononitrile Catalyzed by Strong Base Anion‐Exchange Resin in Water

2004 ◽  
Vol 34 (14) ◽  
pp. 2611-2616 ◽  
Author(s):  
Tong‐Shou Jin ◽  
Jian‐She Zhang ◽  
Ai‐Qing Wang ◽  
Tong‐Shuang Li
Keyword(s):  
Anion Exchange ◽  
Exchange Resin ◽  
Anion Exchange Resin ◽  
Environment Friendly ◽  
Strong Base

scholarly journals Boron Removal from Aqueous Solutions by Strong Base Anion-exchange Resin Batch and Column Experiments

2021 ◽  
Author(s):  
György Pátzay ◽  
József Dobor ◽  
Emil Csonka ◽  
Gábor Lozsi ◽  
Ferenc Feil
Keyword(s):  
Ion Exchange ◽  
Acid Solution ◽  
Boric Acid ◽  
Anion Exchange ◽  
Exchange Resin ◽  
Anion Exchange Resin ◽  
Free Water ◽  
Sulfate Solution ◽  
Boric Acid Solution ◽  
Strong Base

Borate ion exchange capacity of Purolite NRW600 strong base anion resin in hydroxide form and mixed bed NRW600+NRW100 ion exchange was investigated with static experiments. Anion exchange resin was saturated with 0.1–45 g/dm3 concentration boric acid solution in a static mixer at 20, 30, 40 and 50 °C at 150 rpm for 24 hours. Remaining borate content of saturation solutions was deter-mined with ion chromatography and ICP-OES. The amount of fixed borate as borate anions increased with the saturation borate concentration as well as in case of simple anion exchange as in case of mixed bed.Column sorption-elution study was carried out by using strong base anion exchange resins (Purolite NRW600 and Amberlite IRN78). Resins in hydroxide and in chloride forms were saturated in column with 5–40 g/dm3 boric acid solution in excess. The resin was then eluted with 200 cm3 salt free water with 5 cm3/min at 25 °C and then eluted by 1 mol/dm3 sodium-sulfate solution with 5 cm3/min. The effluent was collected and analyzed for borate content by titrimetric method. In chloride form the resin adsorbed and released much less borate. Effective borate and polyborate sorption needs hydroxide ions in resin phase.

scholarly journals Enhanced Anaerobic Mixed Culture Fermentation with Anion-Exchange Resin for Caproate Production

Processes ◽  
2019 ◽  
Vol 7 (7) ◽  
pp. 404 ◽  
Author(s):  
Jiangnan Yu ◽  
Jialin Liao ◽  
Zhenxing Huang ◽  
Peng Wu ◽  
Mingxing Zhao ◽  
...  
Keyword(s):  
Mixed Culture ◽  
Anion Exchange ◽  
Exchange Resin ◽  
Anion Exchange Resin ◽  
Feedback Inhibition ◽  
Control Group ◽  
Low Grade ◽  
Mixed Culture Fermentation ◽  
Strong Base ◽  
Desorption Efficiency

The bioproduction of caproate from organic waste by anaerobic mixed culture is a very attractive technology for upgrading low-grade biomass to a high-value resource. However, the caproate production process is markedly restricted by the feedback inhibition of caproate. In this study, four types of anion-exchange resin were investigated for their enhancing capability in caproate fermentation of anaerobic mixed culture. The strong base anion-exchange resin D201 showed the highest adsorption capacity (62 mg/g), selectivity (7.50), and desorption efficiency (88.2%) for caproate among the test resins. Subsequently, the optimal desorption temperature and NaOH concentration of eluent for D201 were determined. The adsorption and desorption efficiency of D201 remained stable during eight rounds of the adsorption–desorption cycle, indicating a satisfactory reusability of D201. Finally, performances of caproate fermentation with and without resin adsorption for carboxylate were evaluated. The results demonstrated that the final concentration of caproate was improved from 12.43 ± 0.29 g/L (without adsorption) to 17.30 ± 0.13 g/L (with adsorption) and the maximum caproate production rate was improved from 0.60 ± 0.01 g/L/d to 2.03 ± 0.02 g/L/d. In the group with adsorption, the cumulative caproate production was increased to 29.10 ± 0.33 g/L broth, which was 134% higher than that of the control group. Therefore, this study provides effective approaches to enhance caproate production.

scholarly journals The Quantitative Estimate of Bioavailable Inorganic Phosphorus Content in Forest Soils by the Modification of the Anion-Exchange Resin Method

2013 ◽  
Vol 1 (No. 4) ◽  
pp. 117-126
Author(s):  
Rejšek Klement
Keyword(s):  
Anion Exchange ◽  
Forest Soils ◽  
Exchange Resin ◽  
Anion Exchange Resin ◽  
Inorganic Phosphorus ◽  
Seasonal Effects ◽  
Available Phosphorus ◽  
Forest Environment ◽  
Strong Base ◽  
Distinctive Features

The anion-exchange resin (AER) method for the estimation of bioavailable phosphorus was slightly optimised for soils with high contents of readily soluble organic compounds as well as for those having very dif­ferent clay and sand contents. The method based on a strong base anion exchanger, the active group of trimethyl benzyl ammonium, the field moist soil, and the enclosure of resin beds in a bag was very different soils under relatively uniform outer conditions where the determination of the absorbance of (blue) phosphate-molybdate complex at 870 nm is used. The motivation of the proposed method comes from distinctive features of forest soils where marked differences are commonly encountered between clay/silt/sand contents, pH-values, and the contents of organic substances. A modestly new methodology was applied for the evaluation of seasonal phosphorus dynamics in a forest environment. The recommended rapid assay for available phosphorus was statistically compared with other procedures. Considerable seasonal effects on the bioavailable P contents were demonstrated.

Effects of pH and uranium concentration on the removal of uranium from drinking water by ion exchange

2000 ◽  
Vol 88 (12) ◽  
Author(s):  
K. Vaaramaa ◽  
Satu Pulli ◽  
Jukka Lehto
Keyword(s):  
Drinking Water ◽  
Ion Exchange ◽  
Anion Exchange ◽  
Exchange Resin ◽  
Uranium Concentration ◽  
Anion Exchange Resin ◽  
Column Experiments ◽  
Strong Base ◽  
Ph Values ◽  
Effects Of Ph

Effects of pH in the range of 5 to 8 and uranium concentration in the range of 0.02 mg/l to 25 mg/l on the removal of uranium with a strong base anion exchange resin (SBA) and a chelating aminophosphonate resin were studied. The results of the batch and column mode experiments clearly showed that the aminophosphonate resin was an efficient exchanger for the removal of uranium at pH values close to 5 and the SBA resin at higher pH values. In the column experiments, where altogether 2000 bed volumes of drinking water simulant were processed with these exchangers, the uptake of uranium was as high as 99.8% by the aminophosphonate resin at pH 5 and 99.7% by the SBA resin at pH 8.

scholarly journals Separation of Sulfuric Acid and Monosaccharides with a Strong-Base Anion Exchange Resin Containing Polystyrenesulfonate as Polymeric Counter Ion to Reduce Tailing of Sulfuric Acid

2014 ◽  
Vol 25 (4) ◽  
pp. 81-87 ◽  
Author(s):  
Hirotaka MATSUURA ◽  
Zhaoyong SUN ◽  
Masashi YANASE ◽  
Toshihiro IHARA ◽  
Kenji KIDA ◽  
...  
Keyword(s):  
Sulfuric Acid ◽  
Anion Exchange ◽  
Exchange Resin ◽  
Anion Exchange Resin ◽  
Strong Base ◽  
Counter Ion
Sign in / Sign up

Export Citation Format

Share Document