Polarization Agile Antenna for Underwater Communication Using Integrated Power Divider and Phase Shifter

Author(s):  
Badar Muneer ◽  
Bhawani Shankar Chowdhry ◽  
Hima Zafar ◽  
Zahid Ali ◽  
Faisal Karim Shaikh
Author(s):  
Aparna B. Barbadekar ◽  
Pradeep M. Patil

Abstract The paper proposes a system consisting of novel programmable system on chip (PSoC)-controlled phase shifters which in turn guides the beam of an antenna array attached to it. Four antennae forming an array receive individual inputs from the programmable phase shifters (IC 2484). The input to the PSoC-based phase shifter is provided from an optimized 1:4 Wilkinson power divider. The antenna consists of an inverted L-shaped dipole on the front and two mirrored inverted L-shaped dipoles mounted on a rectangular conductive structure on the back which resonates in the ISM/Wi-Fi band (2.40–2.48 GHz). The power divider is designed to provide the feed to the phase shifter using a beamforming network while ensuring good isolation among the ports. The power divider has measured S11, S21, S31, S41, and S51 to be −14, −6.25, −6.31, −6.28, and −6.31 dB, respectively at a frequency of 2.45 GHz. The ingenious controller is designed in-house using a PSoC microcontroller to regulate the control voltage of individual phase shifter IC and generate progressive phase shifts. To validate the calibration of the in-house designed control circuit, the phased array is simulated using $s_p^2$ touchstone file of IC 2484. This designed control circuit exhibits low insertion loss close to −8.5 dB, voltage standing wave ratio of 1.58:1, and reflection coefficient (S11) is −14.36 dB at 2.45 GHz. Low insertion loss variations confirm that the phased-array antenna gives equal amplitude and phase. The beamforming radiation patterns for different scan angles (30, 60, and 90°) for experimental and simulated phased-array antenna are matched accurately showing the accuracy of the control circuit designed. The average experimental and simulated gain is 13.03 and 13.48 dBi respectively. The in-house designed controller overcomes the primary limitations associated with the present electromechanical phased array such as cost weight, size, power consumption, and complexity in design which limits the use of a phased array to military applications only. The current study with novel design and enhanced performance makes the system worthy of the practical use of phased-array antennas for common society at large.


Photonics ◽  
2019 ◽  
Vol 6 (2) ◽  
pp. 63 ◽  
Author(s):  
Retno Wigajatri Purnamaningsih ◽  
Nji Raden Poespawati ◽  
Tomy Abuzairi ◽  
Elhadj Dogheche

This paper details the design of a 1 × 8 optical power divider, using a gallium nitride (GaN) semiconductor on sapphire, which can be applied to underwater optical wireless communication. The design consists of nine parallel rectangular waveguides which are based on mode coupling phenomena. Analysis of the design was performed using the beam propagation method (BPM). The optimization was conducted using the 3D finite difference (FD)-BPM method with an optical signal input at the wavelength required for maritime application of λ = 0.45 µm. The signal was injected into the central waveguide. The results showed that at a propagation length of 1480 µm the optical power is divided into eight output beams with an excess loss of 0.46 dB and imbalance of 0.51 dB. The proposed design can be further developed and applied in future underwater communication technology.


2019 ◽  
Vol 11 (10) ◽  
pp. 1017-1023 ◽  
Author(s):  
Dalia N. Elsheakh

AbstractA broadband linear polarized antenna is designed for radio frequency energy harvesting. The antenna covers the frequency range from 1 up to 6 GHz with relative impedance bandwidth of 126% at −6 dB reflection coefficient |S11| and extended from 1.1 to 3.3 GHz and from 4.2 to 5.6 GHz at |S11| ≤ −10 dB. A 2 × 2 dual linear polarized (DLP) antenna array is designed based on the antenna element by using equal phase and equal power divider 1-to-4 Wilkinson power divider with 180° phase shifter. The DLP antenna array covers the frequency band from 1.8 to 2.9 GHz. This frequency band covers a wide range of modern wireless communication standards, including GSM 1800, UMTS 2100, Wi-Fi 2.4, and most of LTE bands. The developed array prototype was then used to experimentally validate the simulation results. The horizontally and vertically polarized gain of the designed array were found to be quite similar across the 1.8–2.9 frequency band with an average gain value of 5.5 dBi.


2021 ◽  
Vol 1871 (1) ◽  
pp. 012056
Author(s):  
Liang Jin ◽  
Xiaojun Li ◽  
Zhongbo Zhu
Keyword(s):  

2021 ◽  
Author(s):  
monish gupta

Abstract Multiple input multiple output antenna is the key technology which enables the design of 5 G networks. In order to achieve desired beam forming and side lobe reduction capabilities, antennas used in MIMO technology are required to feed with signals having different phase and amplitude. It is possible to achieve variable phase shift and variable attenuation using phase shifter and amplitude limiters. However when these devices are used between source and antenna, they makes the system non planner and non-conformal. This research presents a 16 element, multiple user MIMO Patch antenna with conformal and planner power divider network to achieve electronically steered beam along with desired side lobe level reduction. Wilkinson power divider is used to achieve conformal and planner power divider for MIMO antenna. Desired beam forming capabilities are achieved by controlling the phase of input signal to antennas by controlling the length of microstripline and desired side lobe reduction capabilities are achieved by controlling the amplitude of input signal to antenna by controlling the width of microstrip line used in Wilkinson power divider. This provides an overall planner and conformal structure. In this research same antenna is used is generate two major beams by controlling the phase and amplitude of input signal. The achieved radiation pattern of designed antenna consists of one major beams having gain of 18 dB and located at theta equal to 100 and Phi equal to 1800. When phase of input signal to antennas are changed a major beam having gain of 18 dB and located at theta equal to 100 and Phi equal to 2700 is obtained. The side lobe level less than 13 dB of main beam is achieved using designed antenna. The designed structure is simulated and analyzed using HFSS. Simulated results for the designed MIMO antenna are verified by analyzing the fabricating structure using vector network analyzer and horn antenna.


Sign in / Sign up

Export Citation Format

Share Document