Defect Density Control Using an Intrinsic Layer to Enhance Conversion Efficiency in an Optimized SnS Solar Cell

2021 ◽  
Author(s):  
M. T. Islam ◽  
Atul Kumar ◽  
A. K. Thakur
Keyword(s):  
Solar Cell ◽  
Conversion Efficiency ◽  
Defect Density ◽  
Density Control

Hydrogenated Amorphous Silicon Germanium Alloy for Stable Solar Cells

1994 ◽  
Vol 336 ◽  
Author(s):  
A. Terakawa ◽  
M. Shima ◽  
K. Sayama ◽  
H. Tarui ◽  
H. Nishiwaki ◽  
...  
Keyword(s):  
Solar Cell ◽  
Conversion Efficiency ◽  
Silicon Germanium ◽  
Defect Density ◽  
Characteristic Energy ◽  
Solar Cell Performance ◽  
Germanium Content ◽  
Junction Solar Cell ◽  
Degradation Ratio ◽  
Double Junction

ABSTRACTThe film properties and solar cell performance of a-SiGe:H samples with the same optical gap and different combinations of hydrogen content (CH) and germanium content (CGe) have been compared. The optimum composition for the initial properties, such as the tail characteristic energy, defect density and conversion efficiency of the solar cell, was determined, and the differences could be explained by the difference in H bonding configuration. The degradation ratio of the conversion efficiency becomes larger in higher CH samples. This suggests that hydrogen or Si-H2 participates in light-induced degradation. As a result, the optimum CH for an efficient solar cell is believed to shift to the lower CH region after light soaking. Based on these findings, the stabilized conversion efficiency of 3.3% under red light (γ>650nm) for an a-SiGe:H single-junction solar cell (1cm2) and 10.6% under lsun light for an a-Si/a-SiGe double-junction stacked solar cell (1cm2) have been achieved. The degradation ratio is only 8.6% for the double-junction solar cell.

Retraction Notice: A Kind of Effective Method to Improve the Conversion Efficiency of the Solar Cell

2017 ◽  
Vol 10 (1) ◽  
pp. 35-35
Author(s):  
Xing-Fang Jiang ◽  
Xiang-Min Kong ◽  
Xin-Lu Li ◽  
Hong Jiang ◽  
Dong-Dong Chen
Keyword(s):  
Solar Cell ◽  
Conversion Efficiency ◽  
Retraction Notice

scholarly journals Antireflection Improvement and Junction Quality Optimization of Si/PEDOT:PSS Solar Cell with the Introduction of Dopamine@Graphene

Energies ◽  
2020 ◽  
Vol 13 (22) ◽  
pp. 5986
Author(s):  
Tao Chen ◽  
Hao Guo ◽  
Leiming Yu ◽  
Tao Sun ◽  
Anran Chen ◽  
...  
Keyword(s):  
Solar Cell ◽  
Conversion Efficiency ◽  
High Performance ◽  
Electrochemical Impedance ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Electrochemical Impedance Spectra ◽  
Solar Cell Performance ◽  
Photovoltaic Conversion ◽  
Photovoltaic Conversion Efficiency

Si/PEDOT: PSS solar cell is an optional photovoltaic device owing to its promising high photovoltaic conversion efficiency (PCE) and economic manufacture process. In this work, dopamine@graphene was firstly introduced between the silicon substrate and PEDOT:PSS film for Si/PEDOT: PSS solar cell. The dopamine@graphene was proved to be effective in improving the PCE, and the influence of mechanical properties of dopamine@graphene on solar cell performance was revealed. When dopamine@graphene was incorporated into the cell preparation, the antireflection ability of the cell was enhanced within the wavelength range of 300~450 and 650~1100 nm. The enhanced antireflection ability would benefit amount of the photon-generated carriers. The electrochemical impedance spectra test revealed that the introduction of dopamine@graphene could facilitate the separation of carriers and improve the junction quality. Thus, the short-circuit current density and fill factor were both promoted, which led to the improved PCE. Meanwhile, the influence of graphene concentration on device performances was also investigated. The photovoltaic conversion efficiency would be promoted from 11.06% to 13.15% when dopamine@graphene solution with concentration 1.5 mg/mL was applied. The achievements of this study showed that the dopamine@graphene composites could be an useful materials for high-performance Si/PEDOT:PSS solar cells.

scholarly journals Digital printing of a novel electrode for stable flexible organic solar cells with a power conversion efficiency of 8.5%

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
S. Wageh ◽  
Mahfoudh Raïssi ◽  
Thomas Berthelot ◽  
Matthieu Laurent ◽  
Didier Rousseau ◽  
...  
Keyword(s):  
Solar Cells ◽  
Solar Cell ◽  
Power Conversion Efficiency ◽  
Conversion Efficiency ◽  
Organic Solar Cells ◽  
Power Conversion ◽  
Transport Layer ◽  
Electron Transport Layer ◽  
Solution Processed ◽  
Transparent Conducting

AbstractPoly(3,4-ethylenedioxythiophene) polystyrene sulfonate (PEDOT:PSS) mixed with single-wall nanotubes (SWNTs) (10:1) and doped with (0.1 M) perchloric acid (HClO4) in a solution-processed film, working as an excellent thin transparent conducting film (TCF) in organic solar cells, was investigated. This new electrode structure can be an outstanding substitute for conventional indium tin oxide (ITO) for applications in flexible solar cells due to the potential of attaining high transparency with enhanced conductivity, good flexibility, and good durability via a low-cost process over a large area. In addition, solution-processed vanadium oxide (VOx) doped with a small amount of PEDOT-PSS(PH1000) can be applied as a hole transport layer (HTL) for achieving high efficiency and stability. From these viewpoints, we investigate the benefit of using printed SWNTs-PEDOT-PSS doped with HClO4 as a transparent conducting electrode in a flexible organic solar cell. Additionally, we applied a VOx-PEDOT-PSS thin film as a hole transporting layer and a blend of PTB7 (polythieno[3,4-b] thiophene/benzodithiophene): PC71BM (phenyl-C71-butyric acid methyl ester) as an active layer in devices. Zinc oxide (ZnO) nanoparticles were applied as an electron transport layer and Ag was used as the top electrode. The proposed solar cell structure showed an enhancement in short-circuit current, power conversion efficiency, and stability relative to a conventional cell based on ITO. This result suggests a great carrier injection throughout the interfacial layer, high conductivity and transparency, as well as firm adherence for the new electrode.

Mechanism of Enhanced Power Conversion Efficiency of Cu2ZnSn(S, Se)4 Solar Cell by Cadmium Surface Diffusion Doping

2021 ◽  
pp. 160160
Author(s):  
Hongmei Luan ◽  
Bin Yao ◽  
Yongfeng Li ◽  
Ruijian Liu ◽  
Zhanhui Ding ◽  
...  
Keyword(s):  
Solar Cell ◽  
Power Conversion Efficiency ◽  
Surface Diffusion ◽  
Conversion Efficiency ◽  
Power Conversion

scholarly journals Over 30% efficiency bifacial 4-terminal perovskite-heterojunction silicon tandem solar cells with spectral albedo

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Sangho Kim ◽  
Thanh Thuy Trinh ◽  
Jinjoo Park ◽  
Duy Phong Pham ◽  
Sunhwa Lee ◽  
...  
Keyword(s):  
Solar Cell ◽  
Conversion Efficiency ◽  
Crystalline Silicon ◽  
Short Circuit ◽  
Solar Spectrum ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Production Costs ◽  
White Sand ◽  
Reflected Light

AbstractWe developed and designed a bifacial four-terminal perovskite (PVK)/crystalline silicon (c-Si) heterojunction (HJ) tandem solar cell configuration albedo reflection in which the c-Si HJ bottom sub-cell absorbs the solar spectrum from both the front and rear sides (reflected light from the background such as green grass, white sand, red brick, roofing shingle, snow, etc.). Using the albedo reflection and the subsequent short-circuit current density, the conversion efficiency of the PVK-filtered c-Si HJ bottom sub-cell was improved regardless of the PVK top sub-cell properties. This approach achieved a conversion efficiency exceeding 30%, which is higher than those of both the top and bottom sub-cells. Notably, this efficiency is also greater than the Schockley–Quiesser limit of the c-Si solar cell (approximately 29.43%). The proposed approach has the potential to lower industrial solar cell production costs in the near future.

Characterization of the defect density states in MoOx for c-Si solar cell applications

2021 ◽  
pp. 108135
Author(s):  
D. Scirè ◽  
R. Macaluso ◽  
M. Mosca ◽  
S. Mirabella ◽  
A. Gulino ◽  
...  
Keyword(s):  
Solar Cell ◽  
Defect Density ◽  
Si Solar Cell
Sign in / Sign up

Export Citation Format

Share Document