scholarly journals Over 30% efficiency bifacial 4-terminal perovskite-heterojunction silicon tandem solar cells with spectral albedo

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Sangho Kim ◽  
Thanh Thuy Trinh ◽  
Jinjoo Park ◽  
Duy Phong Pham ◽  
Sunhwa Lee ◽  
...  
Keyword(s):  
Solar Cell ◽  
Conversion Efficiency ◽  
Crystalline Silicon ◽  
Short Circuit ◽  
Solar Spectrum ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Production Costs ◽  
White Sand ◽  
Reflected Light

AbstractWe developed and designed a bifacial four-terminal perovskite (PVK)/crystalline silicon (c-Si) heterojunction (HJ) tandem solar cell configuration albedo reflection in which the c-Si HJ bottom sub-cell absorbs the solar spectrum from both the front and rear sides (reflected light from the background such as green grass, white sand, red brick, roofing shingle, snow, etc.). Using the albedo reflection and the subsequent short-circuit current density, the conversion efficiency of the PVK-filtered c-Si HJ bottom sub-cell was improved regardless of the PVK top sub-cell properties. This approach achieved a conversion efficiency exceeding 30%, which is higher than those of both the top and bottom sub-cells. Notably, this efficiency is also greater than the Schockley–Quiesser limit of the c-Si solar cell (approximately 29.43%). The proposed approach has the potential to lower industrial solar cell production costs in the near future.

scholarly journals Simulation of a perovskite sandwich solar cell with the p-CZTS / p-CH3NH3PbCI3 / p-CZTS absorber layers

2021 ◽  
Vol 877 (1) ◽  
pp. 012001
Author(s):  
Marwah S Mahmood ◽  
N K Hassan
Keyword(s):  
Solar Cell ◽  
Conversion Efficiency ◽  
Current Density ◽  
Short Circuit ◽  
Perovskite Solar Cells ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Open Circuit ◽  
Current Voltage ◽  
Cell Capacitance

Abstract Perovskite solar cells attract the attention because of their unique properties in photovoltaic cells. Numerical simulation to the structure of Perovskite on p-CZTS/p-CH3NH3PbCI3/p-CZTS absorber layers is performed by using a program solar cell capacitance simulator (SCAPS-1D), with changing absorber layer thickness. The effect of thickness p-CZTS/p-CH3NH3PbCI3/p-CZTS, layers at (3.2μm, 1.8 μm, 1.1 μm) respectively are studied. The obtained results are short circuit current density (Jsc ), open circuit voltage (V oc), fill factor (F. F) and power conversion efficiency (PCE) equal to (28 mA/cm2, 0.83 v, 60.58 % and 14.25 %) respectively at 1.1 μm thickness. Our findings revealed that the dependence of current - voltage characteristics on the thickness of the absorbing layers, an increase in the amount of short circuit current density with an increase in the thickness of the absorption layers and thus led to an increase in the conversion efficiency and improvement of the cell by increasing the thickness of the absorption layers.

Design and modeling of an SJ infrared solar cell approaching upper limit of theoretical efficiency

2018 ◽  
Vol 32 (02) ◽  
pp. 1850014 ◽  
Author(s):  
G. S. Sahoo ◽  
G. P. Mishra
Keyword(s):  
Solar Cell ◽  
Quantum Efficiency ◽  
Conversion Efficiency ◽  
Internal Quantum Efficiency ◽  
Spectral Response ◽  
Short Circuit ◽  
Cost Effective ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Open Circuit

Recent trends of photovoltaics account for the conversion efficiency limit making them more cost effective. To achieve this we have to leave the golden era of silicon cell and make a path towards III–V compound semiconductor groups to take advantages like bandgap engineering by alloying these compounds. In this work we have used a low bandgap GaSb material and designed a single junction (SJ) cell with a conversion efficiency of 32.98%. SILVACO ATLAS TCAD simulator has been used to simulate the proposed model using both Ray Tracing and Transfer Matrix Method (under 1 sun and 1000 sun of AM1.5G spectrum). A detailed analyses of photogeneration rate, spectral response, potential developed, external quantum efficiency (EQE), internal quantum efficiency (IQE), short-circuit current density (J[Formula: see text]), open-circuit voltage (V[Formula: see text]), fill factor (FF) and conversion efficiency ([Formula: see text]) are discussed. The obtained results are compared with previously reported SJ solar cell reports.

CHARACTERISTICS OF PHOSPHORUS-DOPED AMORPHOUS CARBON FILMS GROWN BY R. F. PLASMA-ENHANCED CVD WITH A NOVEL PHOSPHORUS SOLID TARGET

2005 ◽  
Vol 12 (01) ◽  
pp. 19-25 ◽  
Author(s):  
M. RUSOP ◽  
M. ADACHI ◽  
T. SOGA ◽  
T. JIMBO
Keyword(s):  
Solar Cell ◽  
Conversion Efficiency ◽  
Amorphous Carbon ◽  
Current Density ◽  
Fill Factor ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Open Circuit ◽  
Phosphorus Doped

Phosphorus-doped amorphous carbon (n-C:P) films were grown by r. f.-power-assisted plasma-enhanced chemical vapor deposition at room temperature using a novel solid red phosphorus target. The influence of phosphorus doping on material properties of n-C:P based on the results of simultaneous characterization are reported. Moreover, the solar cell properties such as series resistance, short circuit current density, open circuit current voltage, fill factor and conversion efficiency along with the spectral response are reported for the fabricated carbon-based n-C:P/p-Si heterojunction solar cell that was measured by standard measurement technique. The cells performances have been given in the dark I–V rectifying curve and I–V working curve under illumination when exposed to AM 1.5 illumination condition (100 mW/cm 2, 25°C). The maximum of open-circuit voltage (V oc ) and short-circuit current density (J sc ) for the cells are observed to be approximately 236 V and 7.34, mAcm 2 respectively for the n-C:P/p-Si cell grown at lower r. f. power of 100 W. The highest energy conversion efficiency (η) and fill factor (FF) were found to be approximately 0.84% and 49%, respectively. We have observed that the rectifying nature of the heterojunction structures is due to the nature of n-C:P films.

scholarly journals Novel Photonic Crystal Based Polycrystalline CdTe/Silicon Solar Cells

2020 ◽  
Keyword(s):  
Solar Cells ◽  
Solar Cell ◽  
Photonic Crystal ◽  
Conversion Efficiency ◽  
Current Density ◽  
Cell Structure ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Silicon Solar Cells

In this paper, a novel photonic crystal (PhC) polycrystalline CdTe/Silicon solar cells are theoretically explained that increase their short circuit current density and conversion efficiency. The proposed structure consist of a polycrystalline CdTe/Silicon solar cell that a photonic crystal is formed in the upper cell. The optical confinement is achieved by means of photonic crystal that can adjust the propagation and distribution of photons in solar cells. For validation of modeling, the electrical properties of the experimentally-fabricated based CdS/CdTe solar cell is modeled and compared that there is good agreement between the modeling results and experimental results from the litterature. The results of this study showed that the solar cell efficiency is increased by about 25% compared to the reference cell by using photonic crystal. The open circuit voltage, short circuit current density, fill factor and conversion efficiency of proposed solar cell structure are 1.01 V, 40.7 mA/cm2, 0.95 and 27% under global AM 1.5 conditions, respectively. Furthermore, the influence of carrier lifetime variation in the absorber layer of proposed solar cell on the electrical characteristics was theoretically considered and investigated.

A Study on Optical and Electrical Properties of Solar Cells of a-Si1-XGeX:H

2011 ◽  
Vol 347-353 ◽  
pp. 3666-3669
Author(s):  
Ming Biao Li ◽  
Li Bin Shi
Keyword(s):  
Solar Cell ◽  
Electrical Properties ◽  
Conversion Efficiency ◽  
Fill Factor ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Open Circuit ◽  
Optical And Electrical Properties

The AMPS-ID program is used to investigate optical and electrical properties of the solar cell of a-SiC:H/a-Si1-xGex:H/a-Si:H thin films. The short circuit current density, open circuit voltage, fill factor and conversion efficiency of the solar cell are investigated. For x=0.1, the conversion efficiency of the solar cell achieve maximum 9.19 % at the a-Si1-xGex:H thickness of 340 nm.

scholarly journals Enhanced Conversion Efficiency of a-Si:H Thin-Film Solar Cell Using ZnO Nanorods

Crystals ◽  
2020 ◽  
Vol 10 (12) ◽  
pp. 1082
Author(s):  
Fang-I Lai ◽  
Jui-Fu Yang ◽  
Yu-Chao Hsu ◽  
Shou-Yi Kuo
Keyword(s):  
Solar Cell ◽  
Conversion Efficiency ◽  
Light Trapping ◽  
Short Circuit ◽  
Zno Nanorods ◽  
Optical Loss ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Zinc Oxide Nanorods ◽  
Surface Reflectivity

The surface reflectivity of a material will vary as light passes through interfaces with different refractive indices. Therefore, the optical loss and reflection of an optical-electronic component can be reduced by fabricating nanostructures on its surface. In the case of a solar cell, the presence of nanostructures can deliver many different advantages, such as decreasing the surface reflectivity, enhancing the light trapping, and increasing the efficiency of the carrier collection by providing a shorter diffusion distance for the photogenerated minority carriers. In this study, an approximately 50-nm thick seed layer was first prepared using spin coating. Zinc oxide nanorods (ZnO-NRs) were then grown using a chemical solution method (CSM). The ZnO-NRs were approximately 2 μm in height and 100 nm in diameter. After applying them to amorphous silicon (a-Si:H) solar cells, the short-circuit current density increased from 8.03 to 9.24 mA/cm2, and the photovoltaic conversion efficiency increased by 11.24%.

Two-Dimensional Modelling and Simulation of Crystalline Silicon n+pp+ Solar Cell

2012 ◽  
Vol 260-261 ◽  
pp. 154-162
Author(s):  
S. Tobbeche ◽  
M.N. Kateb
Keyword(s):  
Solar Cell ◽  
Open Circuit Voltage ◽  
Crystalline Silicon ◽  
Spectral Response ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Open Circuit ◽  
The Other ◽  
Electrical Characteristics

In this work, we present the simulation results of the technological parameters and the electrical characteristics of a crystalline silicon n+pp+ solar cell, using two-dimension (2D) software, namely TCAD Silvaco (Technology Computer Aided Design). TCAD Silvaco Athena is used to simulate various stages of the technology manufacturing, while TCAD Silvaco Atlas is used for the simulation of the electrical characteristics and the spectral response of the solar cell. The J-V characteristics and the external quantum efficiency (EQE) are simulated under AM 1.5 illumination. The conversion efficiency(η)of 16.06% is reached and the other characteristic parameters are simulated: the open circuit voltage (Voc) is of 0.63 V, the short circuit current density (Jsc) equals 30.54 mA/cm² and the form factor (FF) is of 0.83 for the n+pp+ solar cell with a silicon nitride antireflection layer (Si3N4). In order to highlight the importance of the back surface field (BSF), a comparison between two cells, one without BSF (structure n+p), the other with one BSF (structure n+pp+), was made. By creating a BSF on the rear face of the cell the short circuit current density increases from 28.55 to 30.54 mA/cm2, the open circuit voltage from 0.6 to 0.63 V and the conversion efficiency from 14.19 to 16.06%. A clear improvement of the spectral response is obtained in wavelengths ranging from 0.65 to 1.1 µm for the solar cell with BSF.

scholarly journals Effects of Intrinsic Layer Thickness on the Short-Circuit Current Density of Crystalline Silicon-Based Solar Cells

2019 ◽  
Vol 2 (2) ◽  
pp. 72
Author(s):  
Imroatus Soleha ◽  
Endhah Purwandari ◽  
Endang Haryati
Keyword(s):  
Solar Cell ◽  
Current Density ◽  
Crystalline Silicon ◽  
Short Circuit ◽  
Electrical Characterization ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Constant Thickness ◽  
Thickness Variation ◽  
Pure Silicon

The amount of short-circuits current density (Jsc) shown in the results of the electrical characterization of silicon (c:Si)-based solar cell diodes is one of the determinants of device performance. Efforts to increase Jsc are carried out by adding pure silicon to the diode junction, thereby increasing the magnitude of photoelectron generation in the material. In this paper, the insertion of an intrinsic semiconductor at various thicknesses will be analyzed for its effect on the characteristics of the resulting current-voltage density. By using a 2D simulation based on the finite element method, the solution to the equation of a solar cell semiconductor with a p-i-n junction structure becomes the basis for calculating the resulting electric current density. The thickness variation of the simulated layer i ranges from 1 μm to 15 μm, with a constant thickness of p and n layers of 0.4 m. The simulation results show that the reduced thickness of the intrinsic layer has a significant effect on the decrease in short-circuit current density.

Sign in / Sign up

Export Citation Format

Share Document