A Parametric and Experimental Study of a Centrifugal Atomizer Fitted in an Industrial Shed Located in a Tropical Climate

2012 ◽  
Vol 37 (4) ◽  
pp. 1089-1100 ◽  
Author(s):  
K. Senthilkumar ◽  
P. S. S. Srinivasan
Author(s):  
Badrulzaman Jaafar ◽  
Ismail Said ◽  
Mohd Nadzri Md Reba ◽  
Mohd Hisham Rasidi

2021 ◽  
Vol 907 (1) ◽  
pp. 012015
Author(s):  
A Juniwati ◽  
D S Mintorogo ◽  
A E Abednego ◽  
S Kurnia ◽  
E A Handoyo

Abstract The main problem related to thermal condition in Surabaya as a second-largest city in Indonesia is humid and hot. It is a typical condition of tropical climate. Ventilation in the hot day will bring warm and humid outdoor air into a room. It will increase the temperature of air in the room. One of some efforts to reduce the outdoor air temperature is using an earth to air heat exchanger (EAHE) to transfer heat from the air to the earth or ground. This paper will discuss about research done to study the effect of EAHE to a room temperature. The study used two model rooms which are similar and a model EAHE. One room called condition room will receive air flowing from the EAHE pipe and the other room is called the referent room. From the research, it is found that the air in condition room with EAHE is cooler in the daytime compared to the referent room. The temperature of the condition room with EAHE is more stable.


2012 ◽  
Vol 622-623 ◽  
pp. 1570-1574
Author(s):  
W. Prasertsak ◽  
S. Wongkee ◽  
P. Chaiwiwatworakul ◽  
S. Chirarattananon

This paper presents an experimental study of radiant cooling for building air-conditioning in a tropical climate. To prevent condensation of moisture on the cooling panel, the temperature of chilled water supplied to the panel was limited to 25°C. This led to the limitations of heat extraction capacity at the panel and its application to only space with low thermal load and low metabolic rate activity of people in the space. A simple calculation of radiative and convective heat exchange between the interior room surfaces and the room air was applied to determine the rate of heat extraction by the panels. The calculation results can match well with the measurement results. Using a comfort index of predicted mean vote (PMV), the results from experiments show that thermal comfort could be achieved with the application of radiant cooling.


2018 ◽  
Vol 19 (2) ◽  
pp. 1-10
Author(s):  
Emmanuel Ouédraogo ◽  
Ousmane Coulibaly ◽  
B. Kossi Imbga ◽  
P. Florent Kiéno ◽  
Abdoulaye Ouédraogo

Urban Climate ◽  
2021 ◽  
Vol 40 ◽  
pp. 101024
Author(s):  
D.M. Senevirathne ◽  
V.M. Jayasooriya ◽  
S.M. Dassanayake ◽  
S. Muthukumaran

2020 ◽  
pp. 1-13
Author(s):  
Kashif Irshad ◽  
Abdulmohsen Almalawi ◽  
Khairul Habib ◽  
Md. Hasan Zahir ◽  
Amjad Ali ◽  
...  

Author(s):  
Norio Baba ◽  
Norihiko Ichise ◽  
Syunya Watanabe

The tilted beam illumination method is used to improve the resolution comparing with the axial illumination mode. Using this advantage, a restoration method of several tilted beam images covering the full azimuthal range was proposed by Saxton, and experimentally examined. To make this technique more reliable it seems that some practical problems still remain. In this report the restoration was attempted and the problems were considered. In our study, four problems were pointed out for the experiment of the restoration. (1) Accurate beam tilt adjustment to fit the incident beam to the coma-free axis for the symmetrical beam tilting over the full azimuthal range. (2) Accurate measurements of the optical parameters which are necessary to design the restoration filter. Even if the spherical aberration coefficient Cs is known with accuracy and the axial astigmatism is sufficiently compensated, at least the defocus value must be measured. (3) Accurate alignment of the tilt-azimuth series images.


Sign in / Sign up

Export Citation Format

Share Document