Relative Performance of Limestone, Marble, and Basalt Powders in Replacement of a Recycled Fine Aggregate from Red Mud and Metakaolin-Based Geopolymer Mortar

2022 ◽  
Author(s):  
Ouiame Chakkor ◽  
Mehmet Fatih Altan ◽  
Orhan Canpolat ◽  
Hasan Dilbas ◽  
Mucteba Uysal
Keyword(s):  
Red Mud ◽  
Relative Performance ◽  
Fine Aggregate ◽  
Recycled Fine Aggregate

scholarly journals Engineering and Manufacturing Technology of Green Epoxy Resin Coatings Modified with Recycled Fine Aggregates

2021 ◽  
Author(s):  
Kamil Krzywiński ◽  
Łukasz Sadowski ◽  
Damian Stefaniuk ◽  
Aleksei Obrosov ◽  
Sabine Weiß
Keyword(s):  
Mechanical Properties ◽  
Epoxy Resin ◽  
Construction And Demolition Waste ◽  
Fine Aggregate ◽  
Micro Computed Tomography ◽  
Demolition Waste ◽  
Replacement Ratio ◽  
Recycled Fine Aggregate ◽  
Fine Aggregates ◽  
Computed Tomography Scanning

AbstractNowadays, the recycled fine aggregate sourced from construction and demolition waste is not frequently used in manufacturing of epoxy resin coatings. Therefore, the main novelty of the article is to prepare green epoxy resin coatings modified with recycled fine aggregate in a replacement ratio of natural fine aggregate ranged from 20 to 100%. The microstructural properties of the aggregates and epoxy resin were analyzed using micro-computed tomography, scanning electron microscopy and nanoindentation. The macroscopic mechanical properties were examined using pull-off strength tests. The highest improvement of the mechanical properties was observed for epoxy resin coatings modified with 20% of natural fine aggregate and 80% of recycled fine aggregate. It has been found that even 100% of natural fine aggregate can be successfully replaced using the recycled fine aggregate with consequent improvement of the pull-off strength of analyzed epoxy resin coatings. In order to confirm the assumptions resulting from the conducted research, an original analytical and numerical failure model proved the superior behavior of modified coating was developed.

Influence of recycled fine aggregate on microstructure and hardened properties of concrete

2017 ◽  
Vol 69 (24) ◽  
pp. 1288-1295 ◽  
Author(s):  
Ravi Kumar ◽  
Subash Chandra Bose Gurram ◽  
Ashwani Kumar Minocha
Keyword(s):  
Fine Aggregate ◽  
Recycled Fine Aggregate ◽  
Hardened Properties

The Study on the Impact of Recycled Fine Aggregate and Powder on the Mechanics and Thermal Performance of Recycled Concrete Hollow Blocks

2012 ◽  
Vol 509 ◽  
pp. 119-122
Author(s):  
Wei Zhou ◽  
Ling Huan Lu ◽  
Zhen Li
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Coefficient ◽  
Thermal Performance ◽  
High Strength ◽  
Recycled Concrete ◽  
Fine Aggregate ◽  
Ordinary Concrete ◽  
Recycled Fine Aggregate ◽  
The Impact ◽  
The Heat Transfer Coefficient

The impact of recycled fine aggregate and powder on the mechanics and thermal performance of recycled concrete hollow blocks was discussed in this paper. The results showed that 30% recycled fine aggregate and powder have slight affect on the strength of recycled concrete hollow blocks. But the strength reduced significantly when the replacement is above 50%. The impact of recycled fine aggregate and powder on the performance of concrete hollow blocks with high strength grade is notable . The heat transfer coefficient of recycled concrete hollow blocks with 30% recycled fine aggregate and powder was equivalently to ordinary concrete hollow blocks.

scholarly journals Analysis of the Impact on Axial Compression and Diametric tensile strength of concrete using recycled fine aggregate

2021 ◽  
Vol 8 (7) ◽  
pp. 155-163
Author(s):  
Eduardo Dalla Costa Silva ◽  
Dykenlove Marcelin ◽  
Douglas Guedes Batista Torres ◽  
Thiago Guerra
Keyword(s):  
Tensile Strength ◽  
Axial Compression ◽  
Fine Aggregate ◽  
Recycled Fine Aggregate ◽  
The Impact

Durability and Mechanical Properties of Self-Compacting Concrete Incorporating Recovered Filler from Hot Mix Asphalt Plants and Recycled Fine Aggregate

2021 ◽  
Vol 894 ◽  
pp. 95-101
Author(s):  
Sepehr Ghafari ◽  
Fereidoon Moghadas Nejad ◽  
Ofelia Corbu
Keyword(s):  
Compressive Strength ◽  
Hot Mix Asphalt ◽  
Mechanical Performance ◽  
Fine Fraction ◽  
Production Plant ◽  
Fine Aggregate ◽  
Self Compacting Concrete ◽  
Limestone Filler ◽  
Recycled Fine Aggregate ◽  
Maximum Particle

In this research, a sustainable approach is followed to develop efficient mixtures incorporating recycled fine aggregate (RFA) remained from structure demolition as well as limestone filler (LF) from production of hot mix asphalt (HMA). The LF is a byproduct of the drying process in HMA production plant which is not entirely consumed in the production of the HMA and must be hauled and disposed in landfills. The maximum particle size of the LF is approximately 40 µm. Self-Compacting Concrete (SCC) mixtures were designed replacing 5% and 10% of the cement with LF. Incorporation of 50%, and 100% RFA with the fines in the mixtures were considered with and without addition of the LF. Due to the formwork and prefabrication restrictions, the paste volume and the high range water reducer content were tuned in such a way that the slump flow of the mixtures remained between 660 mm to 700 mm without segregation. Durability and mechanical performance of the mixtures were evaluated by resistance against freeze-thaw scaling exposed to deicing agents and compressive strength. It was observed that the SCC mixtures containing 10% LF outperformed those without the use of LF while 5% SCC mixtures did not exhibit tangible superiority. Incorporation of RFA as the fine fraction degraded the durability of all the mixtures. While replacing all the fine fraction with RFA significantly impaired durability and compressive strength, 50% RF mixtures could be designed containing 10% LF that remained in the allowable limits.

Sign in / Sign up

Export Citation Format

Share Document