Longitudinal-optic-transverse-optic vibrational mode splittings in tetrahedral network glasses

1984 ◽  
Vol 68 (2-3) ◽  
pp. 351-360 ◽  
Author(s):  
M.C. Payne ◽  
J.C. Inkson
Molecules ◽  
2018 ◽  
Vol 23 (9) ◽  
pp. 2296 ◽  
Author(s):  
Yao Huang ◽  
Run Yang ◽  
Shijie Xiong ◽  
Jian Chen ◽  
Xinglong Wu

Silicon carbide (SiC) has a large number of polytypes of which 3C-, 4H-, 6H-SiC are most common. Since different polytypes have different energy gaps and electrical properties, it is important to identify and characterize various SiC polytypes. Here, Raman scattering is performed on 6H-SiC micro/nanocrystal (MNC) films to investigate all four folded transverse optic (TO) and longitudinal optic (LO) modes. With increasing film thickness, the four folded TO modes exhibit the same frequency downshift, whereas the four folded LO modes show a gradually-reduced downshift. For the same film thickness, all the folded modes show larger frequency downshifts with decreasing MNC size. Based on plasmons on MNCs, these folded modes can be attributed to strong coupling of the folded phonons with plasmons which show different strengths for the different folded modes while changing the film thickness and MNC size. This work provides a useful technique to identify SiC polytypes from Raman scattering.


1996 ◽  
Vol 50 (6) ◽  
pp. 759-763 ◽  
Author(s):  
Kiyoshi Yamamoto ◽  
Akio Masui

The importance of transverse optic-longitudinal optic (TO-LO) splitting in the interpretation of infrared spectra of thin films is experimentally presented. When infrared spectra are observed at oblique angles of incidence, the shifts in peak position and/or the changes in peak shape may be due to TO-LO splitting. Before one assigns the optical behavior to surface phenomena such as molecular orientation, proper care must be employed. The proposed technique includes optical calculation to extract surface phenomena from TO-LO splitting in the spectra, and it is applied to reflection absorption spectra of perfluoropolyether.


Clay Minerals ◽  
1999 ◽  
Vol 34 (4) ◽  
pp. 551-563 ◽  
Author(s):  
S. Shoval ◽  
S. Yariv ◽  
K. H. Michaelian ◽  
M. Boudeulle ◽  
G. Panczer

AbstractThe high frequency OH-stretching band in micro-Raman spectra of kaolinites consistently exhibits two partly overlapping components with varying relative intensities. These bands, labelled A and Z, are located at ~3700–3690 and 3690–3680 cm-1, respectively. Band Z displays greater intensity in Raman spectra of highly crystallized kaolinites which have large coherent domains. Both components are also observed in the curve fitted infrared (IR) spectra of kaolinites; band Z is stronger in IR spectra of highly crystallized samples. Data for kaolinites with different particle size support the idea that bands A and Z are the longitudinal optic and transverse optic modes of the high frequency OH-stretching band.


2021 ◽  
Vol 288 (1943) ◽  
pp. 20203051
Author(s):  
Emily Baird ◽  
Norbert Boeddeker ◽  
Mandyam V. Srinivasan

To minimize the risk of colliding with the ground or other obstacles, flying animals need to control both their ground speed and ground height. This task is particularly challenging in wind, where head winds require an animal to increase its airspeed to maintain a constant ground speed and tail winds may generate negative airspeeds, rendering flight more difficult to control. In this study, we investigate how head and tail winds affect flight control in the honeybee Apis mellifera , which is known to rely on the pattern of visual motion generated across the eye—known as optic flow—to maintain constant ground speeds and heights. We find that, when provided with both longitudinal and transverse optic flow cues (in or perpendicular to the direction of flight, respectively), honeybees maintain a constant ground speed but fly lower in head winds and higher in tail winds, a response that is also observed when longitudinal optic flow cues are minimized. When the transverse component of optic flow is minimized, or when all optic flow cues are minimized, the effect of wind on ground height is abolished. We propose that the regular sidewards oscillations that the bees make as they fly may be used to extract information about the distance to the ground, independently of the longitudinal optic flow that they use for ground speed control. This computationally simple strategy could have potential uses in the development of lightweight and robust systems for guiding autonomous flying vehicles in natural environments.


1984 ◽  
Vol 62 (8) ◽  
pp. 730-736 ◽  
Author(s):  
G. Saintonge ◽  
J. L. Brebner

Single crystals of GaxIn1−xSe have been grown in our laboratory by the Bridgman method for x ≤ 0.20 and x ≥ 0.75. Reflectivity measurements in the far infrared, with [Formula: see text], have shown that these alloys have a two-mode behaviour except for x = 0.982 where only the GaSe-like oscillator is visible. A Kramers–Kronig analysis enabled us to obtain a first evaluation of the transverse optic (TO) and longitudinal optic (LO) frequencies of the observed modes. Aχ2 fit of the reflectivity calculated from the factorized model of the dielectric constant produced a more accurate determination for these frequencies along with their respective damping constants and ε0 and εx. Reflectivity measurements for [Formula: see text] were made on indium-rich samples, but only in InSe were the results different from those for[Formula: see text]. These are interpreted as a contamination of the [Formula: see text] mode by the E′ modes, normally visible with [Formula: see text] A model proposed by Jahne for the behaviour of optical phonons in alloy systems is applied to this study and finally a review of the criteria for the one-mode and two-mode behaviour, applied to the GaxIn1−x Se system, is given.


2003 ◽  
Vol 798 ◽  
Author(s):  
Li-Lin Tay ◽  
David J. Lockwood ◽  
James A. Gupta ◽  
Zbig R. Wasilewski

ABSTRACTPseudomorphically strained epitaxial films of the ternary alloy GaNyAs1-y have been grown on GaAs(100) with y ranging from 0 to 0.05. The optical phonon Raman spectrum of the alloy displays a two-mode behavior. The GaAs-like first order modes are represented at y = 0.05 by the strong longitudinal optic (LO1) mode at 288.5 cm-1 and the weaker transverse optic (TO1) mode at 268.3 cm-1, while the GaN-like LO2 mode is observed at 474.8 cm-1. Two very broad disorder-induced acoustic bands are evident at 80 and 170 cm-1 due to atomic disorder within the crystalline network. Raman studies show that as the nitrogen concentration increases, the GaAs-like LO1 band shifts linearly towards lower wavenumber while the GaN-like LO2 phonon band displays a sub-linear increase in wavenumber. Raman results for the unstrained quaternary alloy In0.06Ga0.94N0.02As0.98 are compared with those of GaN0.02As0.98.


2004 ◽  
Vol 829 ◽  
Author(s):  
Li-Lin Tay ◽  
David J. Lockwood ◽  
James A. Gupta

ABSTRACTWe present a Raman study of pseudomorphically strained epitaxial films of the ternary alloy GaNyAs1-y grown on GaAs(100) with y ranging from 0 to 0.06. The optical phonon Raman spectrum of the alloy displays a two-mode behavior. The GaAs-like first order modes for y = 0.06 are represented by the strong longitudinal optic (LO1) mode at 287.4 cm-1 and the weaker transverse optic (TO1) mode at 269.0 cm-1, while the GaN-like LO2 mode is observed at 475.6 cm-1. Two very broad disorder-induced acoustic bands are evident at 80 and 170 cm-1 due to atomic disorder within the crystalline network. Raman studies show that as the nitrogen concentration in the alloy increases, the GaAs-like LO1 band shifts linearly towards lower wavenumber while the linearly increasing GaN-like LO2 phonon band deviates from linearity at higher nitrogen concentration (y ≥ 0.03). The reason for the deviation of the LO2 phonon from linearity is discussed.


2009 ◽  
Vol 404 (23-24) ◽  
pp. 4568-4571
Author(s):  
L.I. Murin ◽  
B.G. Svensson ◽  
J.L. Lindström ◽  
V.P. Markevich ◽  
C.A. Londos

Sign in / Sign up

Export Citation Format

Share Document