H-bearing piles in limestone and clay shales. Discussion of paper by W.D. Ashton and P.H. Schwartz. J. Geotech. Engng Div. V.100, GT7, 1974

Keyword(s):  
2018 ◽  
Vol 52 (7) ◽  
pp. 2039-2052 ◽  
Author(s):  
Qiao Lyu ◽  
Jingqiang Tan ◽  
Jeffrey M. Dick ◽  
Qi Liu ◽  
Ranjith Pathegama Gamage ◽  
...  

2021 ◽  
pp. 16-21

The purpose of this study is study of the physical and chemical properties of the overburden of the Dzherdanak deposit. The chemical and mineralogical composition of the overburden of the Djerdanak deposit has been studied by the methods of X-ray and thermography, electron microscopy and infrared spectroscopy. The main phases are quartz, kaolinite and muscovite. The study of the fine structure of the rock under an electron microscope showed the homogeneity of the rock with pronounced uniform inclusions, which is preserved even after firing. Changes in the rock after firing at 1050 °C have been determined. The formation of mullite at this temperature has been established.


LITOSFERA ◽  
2019 ◽  
pp. 30-47
Author(s):  
A. M. Fazliakhmetov

Research subject.The West Magnitogorsk zone of the Southern Urals in the vicinity of the Ishkildino village features a subaerially exposed basaltic sequence superposed by cherts and siliceous-clay shales. The basalts and the overlying shales are assumed to have formed during the Ordovician and Silurian (?)–Early Devonian (up to the conodont zone excavates inclusive) periods, respectively. The aim of this research was to reconstruct, using geochemical data, the conditions under which the rocks present in this geological location were formed.Materials and methods. Five samples of the basalts (XRD and ICP-MS methods), 27 samples of the siliceous-clay shales and 10 samples of the cherts (XRD and ICP-AES methods) were analyzed.Results.According to the ratio of SiO2, Na2O and K2O, the volcanic rocks from the lower part of the section are represented by basalts and trachybasalts. Their geochemical composition corresponds to the N-MORB and is established to be similar to that of the basalts in the Polyakovskaya formation (the Middle–Upper Ordovician). In terms of main elements, the shales under study consist of quartz and illite with a slight admixture of organic matter, goethite, quartzfeldspar fragments, etc. The degree of the sedimentary material weathering according to the CIA, CIW and ICV index values is shown to be moderate. The values of Strakhov’s and Boström’s moduli correspond to sediments without the admixture of underwater hydrothermal vent products. The values of Cr/Al, V/Al and Zr/Al correspond to those characteristic of deposits in deep-water zones remote from the coasts of passive and active continental margins, basalt islands and areas adjacent to mid-ocean ridges. For most samples, the values of Ni/Co, V/Cr, Mo/Mn are typical of deposits formed under oxidative conditions. However, several samples from the upper part of the section, which is comparable to the kitabicus and excavatus conodont zones, demonstrate the Ni/Co, V/Cr, and Mo/Mn values corresponding to deposits formed under reducing atmospheres. An assumption is made that the existence of these deposits can be associated with the Bazal Zlichov event.Conclusion.The investigated pre-Emsian shales have shown no signs of volcanic activity in the adjacent areas. The studied deposits are established to correspond to the central part of the Ural Paleoocean.


1968 ◽  
Vol 5 (4) ◽  
pp. 256-264 ◽  
Author(s):  
E W Brooker ◽  
J. S Scott ◽  
Physool Ali
Keyword(s):  

2021 ◽  
pp. 1151-1158
Author(s):  
L. Picarelli ◽  
A. Mandolini ◽  
C. Russo
Keyword(s):  

2020 ◽  
Author(s):  
Nabe Konate ◽  
Musaab Magzoub ◽  
Saeed Salehi ◽  
Ali Ghalambor ◽  
Mehdi Mokhtari

2006 ◽  
Vol 6 (4) ◽  
pp. 529-539 ◽  
Author(s):  
L. Picarelli ◽  
G. Urciuoli ◽  
A. Mandolini ◽  
M. Ramondini

Abstract. Softening is often considered to be the main cause of first-time slides in OC clay, but so far the mechanics of softening has not been satisfactorily explained. Bearing on laboratory data and field observations about landslides in tectonized highly plastic clay shales of Italian Apennines, the paper describes a process of soil weakening that could explain some failures of natural slopes.


1927 ◽  
Vol 64 (7) ◽  
pp. 298-308
Author(s):  
George Sheppard

Gypsum or selenite is one of the commonest “decomposition” minerals found in connexion with the exposed surfaces of the Tertiary rocks in southern Ecuador. With the possible exception of the coarser grits and conglomerates, the normal sandstones are usually veined extensively by sheets of this mineral; it also occurs in a fibrous form (plates), in agglomerations of minute scalenohedrons, flake-like folia parallel to the bedding, and also in beautiful rosette-like or “stellate” groupings. In the typical clay shales or “gredas” the distribution of gypsum is not so general, though crystals or irregular groups of imperfectly shaped crystals occur on the weathered slopes or screes. In many localities, where a steep talus slope of shale forms the foot of a superimposing sandstone cliff, the scree itself is invariably covered with broken plates of gypsum in such profusion that from a distance it has the appearance of irregular masses of ice or glass. The platy form (which usually consists of parallel laminae with vertical fibres) is probably the most common and, in reality, each plate has been formed after the manner of a typical vein deposit.


Sign in / Sign up

Export Citation Format

Share Document