A novel amperometric biosensor based on a co-crosslinked l-lysine-α-oxidase/overoxidized polypyrrole bilayer for the highly selective determination of l-lysine

2013 ◽  
Vol 795 ◽  
pp. 52-59 ◽  
Author(s):  
Antonio Guerrieri ◽  
Rosanna Ciriello ◽  
Tommaso R.I. Cataldi
Keyword(s):  
Amperometric Biosensor ◽  
Selective Determination ◽  
Overoxidized Polypyrrole

scholarly journals A Crosstalk- and Interferent-Free Dual Electrode Amperometric Biosensor for the Simultaneous Determination of Choline and Phosphocholine

Sensors ◽  
2021 ◽  
Vol 21 (10) ◽  
pp. 3545
Author(s):  
Rosanna Ciriello ◽  
Antonio Guerrieri
Keyword(s):  
Simultaneous Determination ◽  
High Resolution Mass Spectrometry ◽  
Limit Of Detection ◽  
Tissue Growth ◽  
Choline Oxidase ◽  
Amperometric Biosensor ◽  
Pt Electrode ◽  
Overoxidized Polypyrrole ◽  
Resolution Mass

Choline (Ch) and phosphocholine (PCh) levels in tissues are associated to tissue growth and so to carcinogenesis. Till now, only highly sophisticated and expensive techniques like those based on NMR spectroscopy or GC/LC- high resolution mass spectrometry permitted Ch and PCh analysis but very few of them were capable of a simultaneous determination of these analytes. Thus, a never reported before amperometric biosensor for PCh analysis based on choline oxidase and alkaline phosphatase co-immobilized onto a Pt electrode by co-crosslinking has been developed. Coupling the developed biosensor with a parallel sensor but specific to Ch, a crosstalk-free dual electrode biosensor was also developed, permitting the simultaneous determination of Ch and PCh in flow injection analysis. This novel sensing device performed remarkably in terms of sensitivity, linear range, and limit of detection so to exceed in most cases the more complex analytical instrumentations. Further, electrode modification by overoxidized polypyrrole permitted the development of a fouling- and interferent-free dual electrode biosensor which appeared promising for the simultaneous determination of Ch and PCh in a real sample.

Laser optoacoustic detection of trace concentration levels of ethylene, vinylchloride, and styrene in the atmosphere

1989 ◽  
Vol 54 (10) ◽  
pp. 2667-2673 ◽  
Author(s):  
Vojtěch Steiner ◽  
Pavel Engst ◽  
Zdeněk Zelinger ◽  
Milan Horák
Keyword(s):  
Detection Limit ◽  
Emission Line ◽  
Laser Line ◽  
Laser Source ◽  
Trace Concentration ◽  
Selective Determination ◽  
Hygienic Standard ◽  
Trace Concentrations ◽  
Concentration Levels

The optoacoustic analyzer with a tunable CO2 laser source employed in the present work permits a selective determination of ethylene in trace concentrations higher than 5 ppb (=detection limit for the 10P(14) emission line of the CO2 laser, ν = 949.5 cm-1) and of vinylchloride higher than 42 ppb (= detection limit for the 10P(22) CO2 laser line, ν= 942.4 cm-1). this method covers for both compounds the concentration range corresponding to the hygienic standard. It can be also used for the determination of styrene vapour with concentrations higher than 1.5 ppm.

Novel palladium(II) selective membrane electrode based on 4-[(5-mercapto-1,3,4-thiadiazol-2-ylimino)methyl]benzene-1,3-diol

2010 ◽  
Vol 75 (5) ◽  
pp. 563-575 ◽  
Author(s):  
Moslem Mohammadi ◽  
Mehdi Khodadadian ◽  
Mohammad K. Rofouei
Keyword(s):  
Limit Of Detection ◽  
Membrane Electrode ◽  
Aqueous Samples ◽  
Selective Determination ◽  
Poly Vinyl Chloride ◽  
Selective Membrane ◽  
Ph Range ◽  
Palladium Content ◽  
Methyl Benzene

A plasticized poly(vinyl chloride) membrane electrode based on 4-[(5-mercapto-1,3,4-thiadiazol-2-ylimino)methyl]benzene-1,3-diol (L) for highly selective determination of palladium(II) (in PdCl42– form) is developed. The electrode showed a good Nernstian response (29.6 ± 0.4 mV per decade) over a wide concentration range (3.1 × 10–7 to 1.0 × 10–2 mol l–1). The limit of detection was 1.5 × 10–7 mol l–1. The electrode has a response time of about 20 s, and it can be used for at least 2 months without observing any considerable deviation from Nernstian response. The proposed electrode could be used in the pH range of 2.5–5.5. The practical utility of the electrode has been demonstrated by its use for the estimation of palladium content in aqueous samples.

Sign in / Sign up

Export Citation Format

Share Document