scholarly journals Comparison of quality characteristics of tomato paste produced under ohmic-vacuum combination heating and conventional heating

2021 ◽  
pp. 100014
Author(s):  
Zina.T. Alkanan ◽  
Asaad.R.S. Al-Hilphy ◽  
Ammar B. Altemimi ◽  
Ronit Mandal ◽  
Anubhav Pratap-Singh
2021 ◽  
Vol 93 (1) ◽  
Author(s):  
ESRA DEVSEREN ◽  
DILARA OKUT ◽  
MEHMET KOÇ ◽  
HALUK KARATAŞ ◽  
FIGEN KAYMAK-ERTEKIN

2010 ◽  
Vol 9 (3) ◽  
pp. 265-268 ◽  
Author(s):  
Muhammad Naeem Safd ◽  
Amer Mumtaz ◽  
Muhammad Amjad ◽  
Nouman Siddiqui ◽  
Tabassum Hameed

Foods ◽  
2021 ◽  
Vol 10 (12) ◽  
pp. 2920
Author(s):  
Zina T. Alkanan ◽  
Ammar B. Altemimi ◽  
Asaad R. S. Al-Hilphy ◽  
Francesco Cacciola ◽  
Salam A. Ibrahim

Ohmic-vacuum combination heating is a common method used in the food industry as a concentration process. In the present study, an OH-VC combination heating system was developed for producing tomato paste at temperatures of 70, 80, and 90 °C and pressure of 0.3, 0.5, and 0.7 bar and electric field of 1.82, 2.73, and 3.64 V/cm using a central composite design. The effects of heating conditions on the quality and sensory evaluation of tomato paste were also evaluated. Each combination of temperature, pressure, and the electric field was quantified for specific energy consumption, energy efficiency, and productivity. A decrease of 35.08% in the amount of acid ascorbic and lycopene content 19.01%, using conventional heating compared to ohmic-vacuum heating under optimized conditions, was attained. The results also highlighted an increase in the amount of HMF (69.79%) and PME (24.33%) using conventional heating compared to ohmic-vacuum heating under optimized conditions. Ascorbic acid, lycopene, titratable acidity, productivity, energy efficiency was higher than conventional heating; on the other hand, HMF, PME, pH, SEC were lower than conventional heating at the applied OH-VC process. No significant effects between OH-VC and conventional heating on the TSS were observed. In addition, OH-VC heating was highly efficient in the inhibition of bacterial growth. Further, a minor effect on the sensory properties of tomato paste with OH-VC heating compared to the conventional treatment. The obtained results indicate a strong potential for an OH-VC combination heating system as a rapid-heating, high-efficiency alternative for saving electrical energy consumption and preserving nutritional value.


Meat Science ◽  
2014 ◽  
Vol 97 (1) ◽  
pp. 54-61 ◽  
Author(s):  
M. Valenzuela Melendres ◽  
J.P. Camou ◽  
N.G. Torrentera Olivera ◽  
E. Álvarez Almora ◽  
D. González Mendoza ◽  
...  

2010 ◽  
Vol 13 (3) ◽  
pp. 29-38
Author(s):  
Ha Bich Phan ◽  
Thach Ngoc Le

Coriandrum sativum L. belongs to the Apiaceae family, which is cultivated in Dong Nai province, in this paper its seed oil of was studied. The essential oil was extracted by hydrodistillation. We used two methods for activating of hydrodistillation: conventional heating and microwave irradiating. Its physical and chemical indexes were measured. The chemical composition of this oil was identified by GC/MS and quantified by GC/FID. Linalool (75.51-77.21 %), and geranyl acetate (15.64-12.79 %) were the main constituents of the oil which were obtained in 0,32-0.39 % yield. The biological activity of this oil was reported.


2013 ◽  
Vol 58 (3) ◽  
pp. 659-662 ◽  
Author(s):  
K. Gawdzińska

Abstract In this paper it is stated, that a set of quality features of metal matrix composite castings differs from the same set for castings of classic materials, although some features are common for both of these material groups. These features (pertaining to a set of quality characteristics of composite castings) have been named as specific, they have not been determined yet and a description of material quality should be performed (according to the qualitology) on a principle of description of quality characteristics of this product. Therefore, this set of features has been determined. It was proposed to add the following characteristics to the set of specific features of composite castings quality: matrix material, reinforcement material, binding between components and porosity of the composite casting. In this set a sub-set of quality characteristics of composite castings was also determined.


2020 ◽  
Vol 21 (1) ◽  
pp. 15-23
Author(s):  
Sang-Guen Oh ◽  
Jae-Young Lee ◽  
Jae-Woon Jung ◽  
Ju-Tae Song ◽  
Sang-Yun You ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document