Simplified cooling capacity estimation model for top insulated metal ceiling radiant cooling panels

2004 ◽  
Vol 24 (14-15) ◽  
pp. 2055-2072 ◽  
Author(s):  
Jae-Weon Jeong ◽  
Stanley A Mumma
2013 ◽  
Vol 300-301 ◽  
pp. 1048-1053 ◽  
Author(s):  
Yong Hong Wang

In this paper, the test methods of radiation laboratory and data analysis in detail were introduced. The impact of the capillary system with different parameters changing, such as water temperature or water flow the capillary cooling capacity changes, and the capillary cooling system when the initial radiation response time were specificially studied. Under different parameters while cooling capillary volume changes associated with the indoor temperature can be seen under certain conditions, the capillary cooling capacity and room temperature has a linear relationship.


2018 ◽  
Vol 210 ◽  
pp. 04037
Author(s):  
Stanislav Sehnalek ◽  
Martin Kolacek

In this article is covered measurements of radiant cooling ceilings (RCC) in Laboratory of Environmental Engineering at Faculty of applied informatics under Tomas Bata University in Zlin. This laboratory performing standardized tests of special HVAC equipments. Article validate measurements on newly made customization of laboratory for measurements of such RCC. Measurement was performed on RCC with application of PCMs material. This RCC was specially developed for purposes of validation and made in two dimensions. Specific application of PCMs allows achieving recovery of accumulation media in multiple cycles during one day. Outline of newly made RCC is described followed up by detail of set-up of experiment. In article is estimate cooling capacity of used RCC with applied PCMs. Discontinuous cooling cycles is covered as well with description of measured data.


2010 ◽  
Vol 160-162 ◽  
pp. 273-279
Author(s):  
Li Ma ◽  
Dai Xiao Wei

The main application problems of radiant panel in summer include lower cooling capacity owing to high temperature of water supply and condensation. A new radiant panel was developed. Water duct and panel are straight forming which eliminates the thermal contact resistance .The panel are installed in an angle in order to discharge condensate water. The guiding gutter in the face of panel and condensate pipe are to collect and outlet condensate water. The summer test was done. The results show that the new radiant panel has higher cooling efficiency compare with conventional panel .The cooling efficiency is above 1000w/m2, and condensate water can be discharged quickly. Although new Ceiling Radiant Cooling Panel is still not perfect, but it is provides us with more choice.


Author(s):  
Yi Zhao ◽  
Rachel M. James ◽  
Lin Xiao ◽  
Joe Bared

Alternative intersection designs are increasingly proposed and adopted by different agencies to meet the needs of growing traffic demand and constrained transportation resources. The left turn (LT) is one of the most critical movements at signalized intersections from both a safety and operations perspective. Heavy LT volumes are especially impactful to the operational efficiency of a signalized intersection and often result in queue spillback. A contraflow left-turn pocket lane (CLPL) is proposed to mitigate congestion caused by heavy LT demand and has been shown in simulation to greatly mitigate the impact of queue spillback. The CLPL dynamically uses the opposing through lane (OTL) as an additional LT lane within the signal cycle on a temporary basis when the OTL is not occupied by through traffic. While geometric design schematics and analytical procedures for estimating delay have been proposed and discussed in existing literature, methodologies for estimating capacity benefits and traffic operations are not yet well defined. This paper has three primary contributions to the literature: development of a probabilistic capacity estimation model, exploration of the impact of key characteristics (e.g., cycle length, LT demand, lane selection preference) on estimated intersection capacity, and recommendations for the real-world implementation of a CLPL. The simulation results indicate that the CLPL treatment can increase a signalized intersection’s throughput up to 25% and decrease the intersection’s average delay by 35%.


Sign in / Sign up

Export Citation Format

Share Document