Biodiesel production from crude jatropha oil catalyzed by immobilized lipase/acyltransferase from Candida parapsilosis in aqueous medium

2016 ◽  
Vol 218 ◽  
pp. 1224-1229 ◽  
Author(s):  
Joana Rodrigues ◽  
Véronique Perrier ◽  
Jérôme Lecomte ◽  
Eric Dubreucq ◽  
Suzana Ferreira-Dias
Keyword(s):  
Aqueous Medium ◽  
Candida Parapsilosis ◽  
Immobilized Lipase ◽  
Biodiesel Production ◽  
Jatropha Oil

Efficient Micromixing for Continuous Biodiesel Production from Jatropha Oil

2018 ◽  
Vol 9 (1) ◽  
pp. 133-139
Author(s):  
Waleed S. Mohammed ◽  
Ahmed H. El-Shazly ◽  
Marwa F. Elkady ◽  
Masahiro Ohshima
Keyword(s):  
Methyl Esters ◽  
Continuous Process ◽  
Sol Gel ◽  
Average Diameter ◽  
Biodiesel Production ◽  
High Mass ◽  
Molar Ratio ◽  
Jatropha Oil ◽  
Energy Deficiency ◽  
Gel Preparation

Introduction: The utilization of biodiesel as an alternative fuel is turning out to be progressively famous these days because of worldwide energy deficiency. The enthusiasm for utilizing Jatropha as a non-edible oil feedstock is quickly developing. The performance of the base catalyzed methanolysis reaction could be improved by a continuous process through a microreactor in view of the high mass transfer coefficient of this technique. Materials & Methods: Nanozirconium tungstovanadate, which was synthetized using sol-gel preparation method, was utilized in a complementary step for biodiesel production process. The prepared material has an average diameter of 0.066 &µm. Results: First, the NaOH catalyzed methanolysis of Jatropha oil was investigated in a continuous microreactor, and the efficient mixing over different mixers and its impact on the biodiesel yield were studied under varied conditions. Second, the effect of adding the nanocatalyst as a second stage was investigated. Conclusion: The maximum percentage of produced methyl esters from Jatropha oil was 98.1% using a methanol/Jatropha oil molar ratio of 11 within 94 s using 1% NaOH at 60 &°C. The same maximum conversion ratio was recorded with the nanocatalyst via only 0.3% NaOH.

scholarly journals A Robust Two-Step Process for the Efficient Conversion of Acidic Soybean Oil for Biodiesel Production

Catalysts ◽  
2018 ◽  
Vol 8 (11) ◽  
pp. 527 ◽  
Author(s):  
Gaojian Ma ◽  
Lingmei Dai ◽  
Dehua Liu ◽  
Wei Du
Keyword(s):  
Fatty Acid ◽  
Soybean Oil ◽  
Lower Cost ◽  
Immobilized Lipase ◽  
Acid Methyl Ester ◽  
Acid Value ◽  
Catalytic Performance ◽  
Raw Material ◽  
Biodiesel Production ◽  
Negative Effect

Acidic oil, which is easily obtained and with lower cost, is a potential raw material for biodiesel production. Apart from containing large quantity of FFAs (free fatty acids), acidic oil usually contains some amount of inorganic acid, glycerides and some other complex components, leading to complicated effect on lipase’s catalytic performance. Exploring the efficient process of converting acidic oil for biodiesel production is of great significance to promote the use of acidic oil. A two-step conversion process for acidic soybean oil was proposed in this paper, where sulfuric acid-mediated hydrolysis was adopted first, then the hydrolyzed free fatty acid, collected from the upper oil layer was further subject to the second-step esterification catalyzed by immobilized lipase Novozym435. Through this novel process, the negative effect caused by harmful impurities and by-product glycerol on lipase was eliminated. A fatty acid methyl ester (FAME) yield of 95% could be obtained with the acid value decreased to 4 mgKOH/g from 188 mgKOH/g. There was no obvious loss in lipase’s activity and a FAME yield of 90% could be maintained with the lipase being repeatedly used for 10 batches. This process was found to have a good applicability to different acidic oils, indicating it has great prospect for converting low quality oil sources for biodiesel preparation.

scholarly journals Studies on biodiesel produced from Jatropha oil in Cambodia by a non-catalytic using C2H5OH

2014 ◽  
Vol 17 (2) ◽  
pp. 102-108
Author(s):  
Phuoc Van Nguyen ◽  
Chhoun Vi Thun ◽  
Quan Thanh Pham
Keyword(s):  
Catalyst Deactivation ◽  
Reaction Times ◽  
Biodiesel Production ◽  
Molar Ratio ◽  
Biodiesel Fuel ◽  
Jatropha Oil ◽  
Fuel Blend ◽  
International Standard ◽  
Astm D6751

Different technologies are currently available for biodiesel production from various kinds of lipid containing feedstock. Among them, the alkaline-catalyzed methods are the most widely studied. However, here are several disadvantages related to biodiesel production using alkaline catalysts such as generation of wastewater, catalyst deactivation, difficulty in the separation of biodiesel from catalyst and glycerin, etc. To limit the problems mentioned above, in this study, biodiesel is produced by a non-catalytic using C2H5OH. The effect of experimental variables (the molar ratio ethanol/oil of 41.18:1 – 46.82:1, reaction times of 50 - 90 minutes and reaction temperatures of 2750C - 2950C) on the yield of biodiesel was studied. The 96% yield of Cambodia biodiesel of reaction between C2H5OH and Jatropha Oil at 46:1 at temperature 2900C at 60 minutes no using catalysts. Obtained biodiesel fuel was up to the International Standard ASTM D6751 for biodiesel fuel blend stock (B100).

scholarly journals Comparison of oil press for jatropha oil – a review

2016 ◽  
Vol 61 (No. 1) ◽  
pp. 1-13 ◽  
Author(s):  
A.N. Siregar ◽  
J.A. Ghani ◽  
C.H.C. Haron ◽  
M. Rizal ◽  
Z. Yaakob ◽  
...  
Keyword(s):  
Oil Recovery ◽  
Oil Extraction ◽  
Biodiesel Production ◽  
South East Asia ◽  
Jatropha Oil ◽  
Extraction Techniques ◽  
Advantages And Disadvantages ◽  
Jatropha Seeds ◽  
Mechanical Extraction ◽  
Near Future

As petrol will soon be exhausted in the near future, Jatropha is going to be one of the substitute candidates for future biodiesel production. Countries of South-East Asia, such as Malaysia, they are going to start the establishment of Jatropha plantations assuming that Jatropha will be the main resource for biodiesel production. A press is commonly used to extract oils from Jatropha. An oil press can be manually driven or engine-powered. In this paper, we will review some available advances focused on mechanical extraction techniques, covering three types of press for Jatropha oil extraction. We have found that major points like operating principles, oil extraction levels, advantages and disadvantages of each press and important factors to increase oil recovery. Based on the study, three types of press are: ram press, which is ineffective; strainer press, which is able to produce more oil than others and cylinder-hole press, which is the best due to its capacity in extracting oil from Jatropha seeds for about 89.4% of oil yields.

scholarly journals Lipase NS81006 immobilized on Fe3O4 magnetic nanoparticles for biodiesel production

2016 ◽  
Vol 27 (1) ◽  
pp. 13-21 ◽  
Author(s):  
Baskar Thangaraj ◽  
Zhaohua Jia ◽  
Lingmei Dai ◽  
Dehua Liu ◽  
Wei Du
Keyword(s):  
Magnetic Nanoparticles ◽  
Immobilized Lipase ◽  
Biodiesel Production ◽  
Molar Ratio ◽  
Fe3o4 Magnetic Nanoparticles ◽  
Time Duration ◽  
Fast Reaction ◽  
Functionalized Magnetic Nanoparticles ◽  
Optimized Conditions ◽  
Free Lipase

Abstract Lipase-catalyzed biodiesel production is being the object of extensive research due to the demerits of chemical based catalytic system. Lipase immobilized on Fe3O4 magnetic nanoparticles has the integrated advantages of traditional immobilized lipase and free lipase for its rather fast reaction rate and easy separation. It has been demonstrated that free lipase NS81006 has potential in catalyzing the alcoholysis of renewable oils for biodiesel preparation. In this study, Fe3O4 magnetic nanoparticles functionalized with organosilane compounds like (3-aminopropyl)triethyloxysilane (APTES) and (3-mercaptopropyl)trimethoxysilane) MPTMS were used as carriers for lipase immobilization. Lipase NS81006 was covalently bound to the organosilane-functionalized magnetic nanoparticles by using glutaraldehyde cross-linking reagent. A biodiesel yield of 89% and 81% could be achieved by lipase immobilized on APTES-Fe3O4 and MPTMS-Fe3O4 magnetic nanoparticles respectively under optimized conditions of oil to methanol molar ratio 1:3 with three step addition of methanol, reaction temperature 45°C and reaction time duration 12 h. The lipases immobilized on magnetic nanoparticles could be recovered easily by external magnetic field for further use.

Sign in / Sign up

Export Citation Format

Share Document