Assessment of using bentonite, dolomite, natural zeolite and manure for the immobilization of heavy metals in a contaminated soil: The Copșa Mică case study (Romania)

CATENA ◽  
2019 ◽  
Vol 176 ◽  
pp. 336-342 ◽  
Author(s):  
N.O. Vrînceanu ◽  
D.M. Motelică ◽  
M. Dumitru ◽  
I. Calciu ◽  
V. Tănase ◽  
...  
2020 ◽  
Vol 200 ◽  
pp. 06006
Author(s):  
Wawan Budianta

An experiment of the immobilization of heavy metals Pb, Cu, Zn, and Cd in contaminated soil by using the natural zeolite was performed in the laboratory. The natural zeolite was obtained from Gunungkidul, Yogyakarta, Indonesia. Artificially contaminated levels on 100, 300 and 500 mg/kg were prepared and then mixed with three different dosages of 5%, 10% and 20% of the natural zeolite. The result revealed that the addition of natural zeolite effect on reducing the heavy metal in the contaminated soil. The addition 5% dosage of the natural zeolite was sufficient to reduce the concentration of Pb, Cu and Zn from 500 mg/kg to the maximum permissible of concentration level. Finally, the natural zeolite immobilized the heavy metals in the contaminated soil by following in order: Pb2+>Cu2+>Zn2+>Cd2+.


2020 ◽  
Vol 29 (2) ◽  
pp. 1029-1036
Author(s):  
Khalid Alaboudi ◽  
Berhan Ahmed ◽  
Graham Brodie

2015 ◽  
Vol 5 (3) ◽  
pp. 1-6 ◽  
Author(s):  
Zainab Siddiqui ◽  
◽  
S.M Ali Jawaid ◽  
Sandeep Vishen ◽  
Shreya Verma ◽  
...  

2015 ◽  
Vol 2 (2) ◽  
Author(s):  
Wahyu Wilopo ◽  
Septiawan Nur Haryono ◽  
Doni Prakasa Eka Putra ◽  
I Wayan Warmada ◽  
Tsuyoshi Hirajima

Development of indusrialization and urbanization not only increase economic growth but also contribute to the environmental degradation, especially contamination of heavy metals in water. In other side, there are many geological materials have capability to immobilize heavy metals. Therefore, the objective of this research is to know the maximum capacity of natural zeolite from Trembono area, Gunung Kidul regency to immobilize copper (Cu2+) from water and to understand their mechanism. This experiment was carry out by a batch test. The result showed that the maximum capacity of zeolite to immobilize Cu (qmax) is 63,69 mmolCu/kg Zeolite according to Langmuir adsorption equilibrium model. In addition, the capability to immobilize Cu will increases due to decreasing the grain size. The result of this research can be used as an alternative for waste water treatment, especially Cu. Keywords: Removal, copper (Cu2+), natural zeolite, Langmuir isotherm


2021 ◽  
Vol 8 (1) ◽  
pp. 333-347
Author(s):  
Shahid Sher ◽  
Abdul Ghani ◽  
Sikandar Sultan ◽  
Abdul Rehman

Minerals ◽  
2021 ◽  
Vol 11 (5) ◽  
pp. 486
Author(s):  
Alcina Johnson Sudagar ◽  
Slávka Andrejkovičová ◽  
Fernando Rocha ◽  
Carla Patinha ◽  
Maria R. Soares ◽  
...  

Metakaolins (MKs) prepared from low-grade kaolins located in the Alvarães (A) and Barqueiros (B) regions of Portugal were used as the aluminosilicate source to compare their effect on the compressive strength and heavy metal adsorption of geopolymers. Natural zeolite, an inexpensive, efficient adsorbent, was used as an additive in formulations to enhance geopolymers’ adsorption capacities and reduce MK utilization’s environmental footprint. Geopolymers were synthesized with the replacement of MK by zeolite up to 75 wt.% (A25, B25—25% MK 75% zeolite; A50, B50—50% MK 50% zeolite; A75, B75—75% MK 25% zeolite; A100, B100—100% MK). The molar ratios of SiO2/Al2O3 and Na2O/Al2O3 were kept at 1 to reduce the sodium silicate and sodium hydroxide environmental impact. Geopolymers’ crystallography was identified using X-ray diffraction analysis. The surface morphology was observed by scanning electron microscopy to understand the effect of zeolite incorporation. Chemical analysis using X-ray fluorescence spectroscopy and energy dispersive X-ray spectroscopy yielded information about the geopolymers’ Si/Al ratio. Compressive strength values of geopolymers obtained after 1, 14, and 28 days of curing indicate high strengths of geopolymers with 100% MK (A100—15.4 MPa; B100—32.46 MPa). Therefore, zeolite did not aid in the improvement of the compressive strength of both MK-based geopolymers. The heavy metal (Cd2+, Cr3+, Cu2+, Pb2+, and Zn2+) adsorption tests exhibit relatively higher adsorption capacities of Barqueiros MK-based geopolymers for all the heavy metals except Cd2+. Moreover, zeolite positively influenced divalent cations’ adsorption on the geopolymers produced from Barqueiros MK as B75 exhibits the highest adsorption capacities, but such an influence is not observed for Alvarães MK-based geopolymers. The general trend of adsorption of the heavy metals of both MK-based geopolymers is Pb2+ > Cd2+ > Cu2+ > Zn2+ > Cr3+ when fitted by the Langmuir isotherm adsorption model. The MK and zeolite characteristics influence geopolymers’ structure, strength, and adsorption capacities.


Biomolecules ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 448
Author(s):  
Mahrous Awad ◽  
Zhongzhen Liu ◽  
Milan Skalicky ◽  
Eldessoky S. Dessoky ◽  
Marian Brestic ◽  
...  

Heavy metals (HMs) toxicity represents a global problem depending on the soil environment’s geochemical forms. Biochar addition safely reduces HMs mobile forms, thus, reducing their toxicity to plants. While several studies have shown that biochar could significantly stabilize HMs in contaminated soils, the study of the relationship of soil properties to potential mechanisms still needs further clarification; hence the importance of assessing a naturally contaminated soil amended, in this case with Paulownia biochar (PB) and Bamboo biochar (BB) to fractionate Pb, Cd, Zn, and Cu using short sequential fractionation plans. The relationship of soil pH and organic matter and its effect on the redistribution of these metals were estimated. The results indicated that the acid-soluble metals decreased while the fraction bound to organic matter increased compared to untreated pots. The increase in the organic matter metal-bound was mostly at the expense of the decrease in the acid extractable and Fe/Mn bound ones. The highest application of PB increased the organically bound fraction of Pb, Cd, Zn, and Cu (62, 61, 34, and 61%, respectively), while the BB increased them (61, 49, 42, and 22%, respectively) over the control. Meanwhile, Fe/Mn oxides bound represents the large portion associated with zinc and copper. Concerning soil organic matter (SOM) and soil pH, as potential tools to reduce the risk of the target metals, a significant positive correlation was observed with acid-soluble extractable metal, while a negative correlation was obtained with organic matter-bound metal. The principal component analysis (PCA) shows that the total variance represents 89.7% for the TCPL-extractable and HMs forms and their relation to pH and SOM, which confirms the positive effect of the pH and SOM under PB and BB treatments on reducing the risk of the studied metals. The mobility and bioavailability of these metals and their geochemical forms widely varied according to pH, soil organic matter, biochar types, and application rates. As an environmentally friendly and economical material, biochar emphasizes its importance as a tool that makes the soil more suitable for safe cultivation in the short term and its long-term sustainability. This study proves that it reduces the mobility of HMs, their environmental risks and contributes to food safety. It also confirms that performing more controlled experiments, such as a pot, is a disciplined and effective way to assess the suitability of different types of biochar as soil modifications to restore HMs contaminated soil via controlling the mobilization of these minerals.


Sign in / Sign up

Export Citation Format

Share Document