Modeling transport, fate, and removal kinetics of nitrate and orthophosphate using recycled adsorbents for high and low-flow stormwater runoff treatment

Chemosphere ◽  
2021 ◽  
pp. 132152
Author(s):  
Taufiqul Alam ◽  
Juan César Bezares-Cruz ◽  
Ahmed Mahmoud ◽  
Kim D. Jones
2000 ◽  
Vol 93 (4) ◽  
pp. 1085-1094 ◽  
Author(s):  
Richard N. Upton ◽  
Guy L. Ludbrook ◽  
Cliff Grant ◽  
David J. Doolette

Background Thiopental and propofol are highly lipid-soluble, and their entry into the brain often is assumed to be limited by cerebral blood flow rather than by a diffusion barrier. However, there is little direct experimental evidence for this assumption. Methods The cerebral kinetics of thiopental and propofol were examined over a range of cerebral blood flows using five and six chronically instrumented sheep, respectively. Using anesthesia (2.0% halothane), three steady state levels of cerebral blood flow (low, medium, and high) were achieved in random order by altering arterial carbon dioxide tension. For each flow state, 250 mg thiopental or 100 mg propofol was infused intravenously over 2 min. To quantify cerebral kinetics, arterial and sagittal sinus blood was sampled rapidly for 20 min from the start of the infusion, and 1.5 h was allowed between consecutive infusions. Various models of cerebral kinetics were examined for their ability to account for the data. Results The mean baseline cerebral blood flows for the "high" flow state were over threefold greater than those for the low. For the high-flow state the normalized arteriovenous concentration difference across the brain was smaller than for the low-flow state, for both drugs. The data were better described by a model with partial membrane limitation than those with only flow limitation or dispersion. Conclusions The cerebral kinetics of thiopental and propofol after bolus injection were dependent on cerebral blood flow, despite partial diffusion limitation. Higher flows produce higher peak cerebral concentrations.


2004 ◽  
Vol 25 (5) ◽  
pp. 475-478 ◽  
Author(s):  
Adey Ayalew ◽  
Fatiha Maskali ◽  
Sandra Audonnet ◽  
Pierre-Yves Marie ◽  
Patrick Menu ◽  
...  

2000 ◽  
Vol 27 (11) ◽  
pp. 1632-1640 ◽  
Author(s):  
Adey Ayalew ◽  
Pierre Y. Marie ◽  
Patrick Menu ◽  
Paul M. Mertes ◽  
Nathalie Hassan ◽  
...  

1996 ◽  
Vol 28 (2) ◽  
pp. 487-494 ◽  
Author(s):  
Rob S.B. Beanlands ◽  
Robert A. deKemp ◽  
Eef Harmsen ◽  
John P. Veinot ◽  
Neil G. Hartman ◽  
...  
Keyword(s):  
Low Flow ◽  

2005 ◽  
Vol 40 (12) ◽  
pp. 766-772 ◽  
Author(s):  
Fatiha Maskali ◽  
Adey Ayalew ◽  
Pierre-Yves Marie ◽  
Patrick Menu ◽  
Laurent Antunes ◽  
...  
Keyword(s):  
Low Flow ◽  

Author(s):  
J. F. DeNatale ◽  
D. G. Howitt

The electron irradiation of silicate glasses containing metal cations produces various types of phase separation and decomposition which includes oxygen bubble formation at intermediate temperatures figure I. The kinetics of bubble formation are too rapid to be accounted for by oxygen diffusion but the behavior is consistent with a cation diffusion mechanism if the amount of oxygen in the bubble is not significantly different from that in the same volume of silicate glass. The formation of oxygen bubbles is often accompanied by precipitation of crystalline phases and/or amorphous phase decomposition in the regions between the bubbles and the detection of differences in oxygen concentration between the bubble and matrix by electron energy loss spectroscopy cannot be discerned (figure 2) even when the bubble occupies the majority of the foil depth.The oxygen bubbles are stable, even in the thin foils, months after irradiation and if van der Waals behavior of the interior gas is assumed an oxygen pressure of about 4000 atmospheres must be sustained for a 100 bubble if the surface tension with the glass matrix is to balance against it at intermediate temperatures.


Author(s):  
R. J. Lauf

Fuel particles for the High-Temperature Gas-Cooled Reactor (HTGR) contain a layer of pyrolytic silicon carbide to act as a miniature pressure vessel and primary fission product barrier. Optimization of the SiC with respect to fuel performance involves four areas of study: (a) characterization of as-deposited SiC coatings; (b) thermodynamics and kinetics of chemical reactions between SiC and fission products; (c) irradiation behavior of SiC in the absence of fission products; and (d) combined effects of irradiation and fission products. This paper reports the behavior of SiC deposited on inert microspheres and irradiated to fast neutron fluences typical of HTGR fuel at end-of-life.


Sign in / Sign up

Export Citation Format

Share Document