Chemical composition and structure characterization of distillation residues of middle-temperature coal tar

2017 ◽  
Vol 25 (6) ◽  
pp. 815-820 ◽  
Author(s):  
Zhihui Sun ◽  
Weihong Zhang
2014 ◽  
Vol 782 ◽  
pp. 603-606 ◽  
Author(s):  
Ondrej Milkovič ◽  
Karel Saksl ◽  
Mária Hagarová ◽  
Štefan Michalik ◽  
Jana Gamcová

This paper is focused to structure characterization of two differently electrodeposited Ni-Co alloys on the copper surface. The chemical composition of the layers was determined by the EDX analysis in the scanning electron microscope. Phase analysis was realized by diffraction in the transmission mode using synchrotron radiation. Diffraction patterns also show the preferred orientation in the coating with saccharine addition.


Author(s):  
A.I. Gónzalez ◽  
R. Alvarez ◽  
M. Granda ◽  
R. Menéndez ◽  
M.A. Díez ◽  
...  

2006 ◽  
Vol 135 (2) ◽  
pp. 108-112 ◽  
Author(s):  
I. Balchev ◽  
N. Minkovski ◽  
Ts. Marinova ◽  
M. Shipochka ◽  
N. Sabotinov

2017 ◽  
Vol 121 (43) ◽  
pp. 23886-23895 ◽  
Author(s):  
Negar Ashari-Astani ◽  
Simone Meloni ◽  
Amir Hesam Salavati ◽  
Giulia Palermo ◽  
Michael Grätzel ◽  
...  

2010 ◽  
Vol 636-637 ◽  
pp. 556-563
Author(s):  
A. Ciocan ◽  
F. Potecasu ◽  
E. Drugescu ◽  
Simona Constantinescu

The paper presents the results of theoretical and experimental research regarding the establishing of some chemical positions of the bearing alloy and of cladding technology. The final properties of the materials depend on the kinetics and thermodynamics of the interface processes. In the paper the diffusion zone developed between the two bimetal materials is revealed and characterized under the aspect of chemical composition and structure. An application for this research that could lead to increasing the endurance of the steel products cladded through welding is the case of boring bits with three cones, which work under short oiling conditions and variations of the contact pressure.


2012 ◽  
Vol 27 (1) ◽  
pp. 108-117 ◽  
Author(s):  
Quan Shi ◽  
Na Pan ◽  
Haiyan Long ◽  
Dechun Cui ◽  
Xiaofen Guo ◽  
...  

RSC Advances ◽  
2015 ◽  
Vol 5 (90) ◽  
pp. 73820-73826 ◽  
Author(s):  
Yu. V. Kulvelis ◽  
S. S. Ivanchev ◽  
V. T. Lebedev ◽  
O. N. Primachenko ◽  
V. S. Likhomanov ◽  
...  

Perfluorinated short side chain membranes synthesized by novel aqueous emulsion method demonstrate specific structure dependent on the chemical composition.


1990 ◽  
Vol 187 ◽  
Author(s):  
Dongliang Lin ◽  
Bewda Yan ◽  
Weili Yu

AbstractWNx film is one of the most promising materials for self-aligned GaAs NASFET because of its low electrical resistivity and high Schottky Barrier Height at the WNx /GaAs contact.In this paper, the effect of the sputtering conditions and the annealing environment on the chemical composition and structure of the WNx films deposited on Si and GaAs by RF reactive sputtering are studied.The results show that with the increase of the partial pressure ratio of nitrogen gas or decrease of the working pressure, deposition rate of WNx film decreases, whereas the atomic percentage of N in the deposited film increases before approaching saturation. The WNx films formed at high working pressure (≈5 × 10−2 torr) consist of W, WN or W2N phases depending on the nitrogen partial pressure ratio. Whereas the films formed at low working pressure (≈ 3 × 10−3 torr) are usually amorphous. Annealing in a flowing N2 gas causes the crystallization of the amorphous films, which mainly consist of W+W2N. There is no change for the crystalline films. However, annealing in H2 gas causes severe loss of nitrogen of the film, the film becoming single W phase eventually.


Sign in / Sign up

Export Citation Format

Share Document