Effects of carbon nanotubes on char structure and heat transfer in ethylene propylene diene monomer composites at high temperature

Author(s):  
MengFei Guo ◽  
Jiang Li ◽  
YiWei Wang
2020 ◽  
Vol 2020 ◽  
pp. 1-15
Author(s):  
Young Il Moon ◽  
Jae Kap Jung ◽  
Ki Soo Chung

The dielectric permittivity of synthetic rubber polymers, nitrile butadiene rubber (NBR) and ethylene propylene diene monomer (EPDM), with both frequency and temperature variations, was thoroughly investigated by dielectric relaxation spectroscopy (DRS). The spectrum versus frequency of DRS was analyzed with the semiempirical Havriliak–Negami formula and conductivity contribution by employing the newly developed “dispersion analyzer” analysis program. The main dielectric relaxations called the α- and β-processes, associated with the cooperative motion of chains in polymers, were discovered in the low-temperature region. In the high-temperature region, we found Maxwell–Wagner–Sillars (MWS) relaxation associated with polymer interfacing and normal-mode (α’) relaxation responsible for end-to-end dipole vector motion. The activation energies of schematic molecular chains responsible for the relaxation processes were obtained with the information about its motional mode. The glass transition temperature and dipole moment for the side group were also determined and compared with those from previous studies. In the EPDM specimen, the peaks of α- and β-relaxation merged at high temperature and were separated with decreasing temperature. The first observations of both merging and splitting were consistent with the results on the temperature dependency of the relaxation strength. Both contour mapping and three-dimensional plots for the two rubbers provide visual information for the distribution and mapping of relaxation.


2008 ◽  
Vol 1143 ◽  
Author(s):  
Paola Ciselli ◽  
Lan Lu ◽  
James JC Busfield ◽  
Ton Peijs

ABSTRACTElastomeric composites based on Ethylene-Propylene-Diene-Monomer (EPDM) filled with multi-wall carbon nanotubes (MWNTs) have been prepared, showing improved mechanical properties as compared to the pure EPDM matrix. The results have been discussed using the Guth model. The main focus of the study was on the electrical behavior of the nanocomposites, in view of possible sensor applications. A linear relation has been found between conductivity and deformations up to 10% strain, which means that such materials could be used for applications such as strain or pressure sensors. Cyclic experiments were conducted to establish whether the linear relation was reversible, which is an important requirement for sensor materials.


2012 ◽  
Vol 184-185 ◽  
pp. 1221-1225
Author(s):  
Xiao Guang Zhang ◽  
Ying Jie Ji ◽  
Shi Gang Wang ◽  
Qing Lin Hou

Multi-walled carbon nanotubes (MWNTs) were used as filler to enhance thermal conductivity of Ethylene propylene diene monomer (EPDM) polymers. In order to study the thermal conductivity of the MWNTs/EPDM composites in three different directions, an experiment was conducted by the heat probe method. The results show the general average thermal conductivity of MWNTs/EPDM composites is 0.323 W/m•K,which is significantly higher than EPDM polymers. The maximum difference of thermal conductivity between two directions is 8.7% relative to the general average, indicating obvious anisotropic behavior.


Author(s):  
Tamer Sheta ◽  
A.Hossam Gad ◽  
L.S. Nasrat ◽  
S.M. El-Debeiky

Ethylene Propylene Diene Monomer (EPDM) electrical properties are improved by adding Alumina Trihydrate (ATH) filler. Composite of EPDM with ATH filler are prepared with 10%, 20%, 30% and 40% percentages of concentration. The dielectric strength of the composite samples are tested under various thermal conditions such as (25, 70,100 and 130) ᵒC to simulate the various types of climates and clarify the effect of high temperature on the electrical properties of elastomers. Composite samples were exposed also to different climate conditions such as wet and salt. The obtained results of the composite performance are analyzed and discussed in the light of the variations of the material microscopic structure.  


Sign in / Sign up

Export Citation Format

Share Document