scholarly journals Development of an infrared laser absorption sensor for non-intrusive gas temperature measurements

2021 ◽  
Author(s):  
Kun Duan ◽  
Da-xin Wen ◽  
Yu Wang ◽  
Liu-hao Ma ◽  
Kin-Pang Cheong ◽  
...  
Keyword(s):  
Infrared Laser ◽  
Temperature Measurements ◽  
Gas Temperature ◽  
Laser Absorption

A methane telemetry sensor based on near-infrared laser absorption spectroscopy

2021 ◽  
Vol 114 ◽  
pp. 103670
Author(s):  
Haoqing Yang ◽  
Xiongzhu Bu ◽  
Yihan Cao ◽  
Yang Song
Keyword(s):  
Absorption Spectroscopy ◽  
Near Infrared ◽  
Infrared Laser ◽  
Laser Absorption Spectroscopy ◽  
Laser Absorption

scholarly journals Exhaust Gas Temperature Measurements in Diagnostics of Turbocharged Marine Internal Combustion Engines Part I Standard Measurements

2015 ◽  
Vol 22 (1) ◽  
pp. 47-54 ◽  
Author(s):  
Zbigniew Korczewski
Keyword(s):  
Internal Combustion Engines ◽  
Internal Combustion ◽  
Technical Condition ◽  
Temperature Measurements ◽  
Injection System ◽  
Exhaust Gas ◽  
Combustion Engines ◽  
Gas Temperature ◽  
Measuring Signal ◽  
Exhaust Gas Temperature

Abstract The article discusses the problem of diagnostic informativeness of exhaust gas temperature measurements in turbocharged marine internal combustion engines. Theoretical principles of the process of exhaust gas flow in turbocharger inlet channels are analysed in its dynamic and energetic aspects. Diagnostic parameters are defined which enable to formulate general evaluation of technical condition of the engine based on standard online measurements of the exhaust gas temperature. A proposal is made to extend the parametric methods of diagnosing workspaces in turbocharged marine engines by analysing time-histories of enthalpy changes of the exhaust gas flowing to the turbocompressor turbine. Such a time-history can be worked out based on dynamic measurements of the exhaust gas temperature, performed using a specially designed sheathed thermocouple. The first part of the article discusses possibilities to perform diagnostic inference about technical condition of a marine engine with pulse turbocharging system based on standard measurements of exhaust gas temperature in characteristic control cross-sections of its thermal and flow system. Selected metrological issues of online exhaust gas temperature measurements in those engines are discusses in detail, with special attention being focused on the observed disturbances and thermodynamic interpretation of the recorded measuring signal. Diagnostic informativeness of the exhaust gas temperature measurements performed in steady-state conditions of engine operation is analysed in the context of possible evaluations of technical condition of the engine workspaces, the injection system, and the fuel delivery process.

Passive Absorption/Emission Spectroscopy for Gas Temperature Measurements in Gas Turbine Engines

2011 ◽  
Author(s):  
Hejie Li ◽  
Guanghua Wang ◽  
Nirm Nirmalan ◽  
Samhita Dasgupta ◽  
Edward R. Furlong
Keyword(s):  
Gas Turbine ◽  
Emission Spectroscopy ◽  
Gas Absorption ◽  
Temperature Measurements ◽  
Turbine Engines ◽  
Gas Turbine Engines ◽  
Gas Temperature ◽  
Measurement Results ◽  
Passive Absorption ◽  
Hot Surface

A novel technique is developed to simultaneously measure hot surface and gas temperatures based on passive absorption/emission spectroscopy (PAS). This non-intrusive, in situ technique is the extension of multi-wavelength pyrometry to also measure gas temperature. The PAS technique uses hot surface (e.g., turbine blade) as the radiation source, and measures radiation signals at multiple wavelengths. Radiation signals at wavelengths with minimum interference from gas (mostly from water vapor and CO2) can be used to determine the hot surface temperature, while signals at wavelengths with gas absorption/emission can be used to determine the gas temperature in the line-of-sight. The detection wavelengths are optimized for accuracy and sensitivity for gas temperature measurements. Simulation results also show the effect of non-uniform gas temperature profile on measurement results. High pressure/temperature tests are conducted in single nozzle combustor rig to demonstrate sensor proof-of-concept. Preliminary engine measurement results shows the potential of this measurement technique. The PAS technique only requires one optical port, e.g., existing pyrometer or borescope port, to collect the emission signal, and thus provide practical solution for gas temperature measurement in gas turbine engines.

Improvements in the Design and Operation of a Suction Pyrometer

1981 ◽  
Vol 14 (8) ◽  
pp. 301-305 ◽  
Author(s):  
M. S. Wojtan ◽  
K. A. G. Jones
Keyword(s):  
Temperature Measurements ◽  
Gas Temperature ◽  
Wide Range ◽  
Specific Project

There is a need to make reliable gas temperature measurements in combustion research. Conventional suction pyrometers and the associated methods of estimating their error do not always give satisfactory results. A new suction pyrometer has been developed to meet the requirements of a specific project at the Coal Research Establishment of the NCB. The unit incorporates a means of estimating directly the error in the pyrometer reading at the time the gas temperature is measured. The pyrometer has been used to measure gas temperatures in a wide range of environments. The results demonstrate the advantages of using the new pyrometer.

Investigation of Filtered Rayleigh Scattering Techniques for Rig Testing Diagnostics

2014 ◽  
Author(s):  
Jordi Estevadeordal ◽  
Dmitry Opaits ◽  
Chiranjeev Kalra
Keyword(s):  
Rayleigh Scattering ◽  
High Pressures ◽  
Imaging Techniques ◽  
Mixing Layer ◽  
Temperature Measurements ◽  
Temperature Fields ◽  
Gas Temperature ◽  
Iccd Camera ◽  
Gas Molecules ◽  
Combustion Tests

A laboratory investigation of Filtered Rayleigh Scattering (FRS) techniques for high-resolution and high-accuracy temperature measurements in rig tests with high pressures and temperatures and combustion is presented. Imaging techniques based on filtered Rayleigh scattering have the potential for two-dimensional (2D) and near wall measurement of gas velocity and temperature fields among other properties. For gas temperature measurements, laser Rayleigh scattering from gas molecules are typically captured with an ICCD camera and temperature can be inferred from the number density measured from the image intensities. The accuracy challenges associated with property spatial variations, gas composition, and pressure and temperature conditions are investigated for the rig test environments. Representative examples including mixing layer, jet and vortex flows and flame and combustion tests are presented.

Development of an In-Situ Laser Absorption NO/NO2 Measuring System for Gas Turbine Exhaust Jets

2006 ◽  
Author(s):  
Y. Zhu ◽  
H. Yamada ◽  
S. Hayashi
Keyword(s):  
Gas Turbines ◽  
Beam Steering ◽  
Measuring System ◽  
Gas Flows ◽  
Exhaust Gas ◽  
Gas Temperature ◽  
Laser Absorption ◽  
System A ◽  
Gas Turbine Exhaust ◽  
Exhaust Gas Temperature

A diode-laser absorption system having the potential of simultaneous determination of NO and NO2 concentrations in the exhaust jets from gas turbines has been being developed. The sensitivities of the detection units at a typical exhaust gas temperature of 800 K were estimated as 30 ppmv-m and 3.7 ppmv-m for NO and NO2, respectively. Experiments using simulated exhaust gas flows have shown that CO2 do not have any interference with the NO and NO2 measurements. The detection limits in ppm of the system were considerably lowered by using a multi-pass optical system. A pair of off-axis parabola mirrors was useful to prevent the laser beam from straying from the detection area of the sensor due to the beam steering in the exhaust gas. Furthermore, the multi-path optical duct fabricated with 14 mirrors on the inner wall was effective in the measurement of NO and NO2 in the exhaust gas from gas turbines.

Sign in / Sign up

Export Citation Format

Share Document