Numerical study on the effect of temperature in the retention time of an inert agent

2020 ◽  
Vol 115 ◽  
pp. 103004 ◽  
Author(s):  
Goonho Kim ◽  
Ju-Hong Cha ◽  
Ho-Jun Lee
2018 ◽  
Author(s):  
Guy Malki ◽  
Sharon Zlochiver

ABSTRACTCardiac rotors are believed to be a major driver source of persistent atrial fibrillation (AF), and their spatiotemporal characterization is essential for successful ablation procedures. However, electrograms guided ablation have not been proven to have benefit over empirical ablation thus far, and there is a strong need of improving the localization of cardiac arrhythmogenic targets for ablation. A new approach for characterize rotors is proposed that is based on induced spatial temperature gradients (STGs), and investigated by theoretical study using numerical simulations. We hypothesize that such gradients will cause rotor drifting due to induced spatial heterogeneity in excitability, so that rotors could be driven towards the ablating probe. Numerical simulations were conducted in single cell and 2D atrial models using AF remodeled kinetics. STGs were applied either linearly on the entire tissue or as a small local perturbation, and the major ion channel rate constants were adjusted following Arrhenius equation. In the AF-remodeled single cell, recovery time increased exponentially with decreasing temperatures, despite the marginal effect of temperature on the action potential duration. In 2D models, spiral waves drifted with drifting velocity components affected by both temperature gradient direction and the spiral wave rotation direction. Overall, spiral waves drifted towards the colder tissue region associated with global minimum of excitability. A local perturbation with a temperature of T=28°C was found optimal for spiral wave attraction for the studied conditions. This work provides a preliminary proof-of-concept for a potential prospective technique for rotor attraction. We envision that the insights from this study will be utilize in the future in the design of a new methodology for AF characterization and termination during ablation procedures.


2014 ◽  
Vol 25 (03) ◽  
pp. 1350101
Author(s):  
Jianhua Lu ◽  
Sheng Li ◽  
Zhaoli Guo ◽  
Baochang Shi

In this paper, the 2D fluid flow pass a heated/cooled square cylinder exposed to a constant free-stream upward velocity is simulated via a multiple relaxation time (MRT) lattice-Boltzmann (LB) method. The buoyancy effect on the drag and lift coefficients as well as Nusselt number related is compared with the results in the existing literatures to validate the code used. The effect of temperature-viscosity dependence is then investigated to test whether the effect can be neglected or not for the mixed convection case. It is shown that the effect cannot be ignored when |Ri| > 0.15. Fortunately, the effect can be captured by using an effective temperature formula [J. M. Shi, D. Ferlach, M. Breuer, G. Biswas and F. Durst, Phys. Fluids16, 4331 (2004)] in a rather large range of Ri. All the numerical results, from another angle, also demonstrate that the MRT method is an efficient tool in simulating the problems such as the present one.


Author(s):  
S Belhadi ◽  
T Mabrouki ◽  
J-F Rigal ◽  
L Boulanouar

The present paper is a contribution to the investigation of physical phenomena accompanying sawtooth chip formation in the case of hard turning. The study concerns the machining with coated carbide of tempered AISI 4340 steel with a Rockwell C hardness of 47 HRC. The main idea in this paper deals with the establishment of a direct relationship between serrated-chip morphology simultaneously with force component signals derived from acquisition at high frequency and with the width of facets detected on a workpiece machined surface. This experimental work was supported by a numerical simulation based on Abaqus/ Explicit software. Numerical results dealing with effect of temperature evolution on the chip morphology show that the beginning of the sawtooth chip initiation is due to an adiabatic shear at the tool tip with propagation pathway towards the free surface. In addition, computed results have a good corroboration with those obtained experimentally.


2015 ◽  
Vol 8 (6) ◽  
pp. 780-786 ◽  
Author(s):  
Hina Rizvi ◽  
Nasir Ahmad ◽  
Farhat Abbas ◽  
Iftikhar Hussain Bukhari ◽  
Abdullah Yasar ◽  
...  

2008 ◽  
Vol 57 (11) ◽  
pp. 1713-1720 ◽  
Author(s):  
T. R. Bentzen ◽  
T. Larsen ◽  
M. R. Rasmussen

The paper presents results from an experimental and numerical study of wind-induced flows and transportation patterns in highway wet detention ponds. The study presented here is part of a general investigation on road runoff and pollution in respect to wet detention ponds. The objective is to evaluate the quality of long term simulations based on historical rain series of the pollutant discharges from roads and highways. The idea of this paper is to evaluate the effects of wind on the retention time and compare the retention time for the situation of a spatial uniform wind shear stress with the situation of a “real” spatial non-uniform shear stress distribution on the surface of the pond. The result of this paper shows that wind plays a dominant role for the retention time and flow pattern. Furthermore, the results shows that the differences in retention time between the use of uniform and non-uniform wind field distributions are not significant to this study.


2012 ◽  
Vol 1447 ◽  
Author(s):  
Ahmadreza Hajiaboli ◽  
Mark P. Andrews

ABSTRACTWe present a numerical study on effect of temperature on the performance of a waveguide luminescent solar concentrator (LSC). The purpose is to determine how changes in temperature of the ambient environment of an LSC affect device performance. The thermo-optical coefficient of the polymer waveguide is modeled using the well known Prod’homme formulation and applied in a forward Monte Carlo ray-tracing simulation. We show that the number of collected photons decreases almost linearly as the ambient temperature increases from -50 ºC to +50ºC. This behavior is associated with several competing loss mechanisms in the waveguide. For example, increases in optical confinement due to increased refractive index at low temperature are opposed by increases in cone loss (escape loss) of photons. Other competing mechanisms that exhibit temperature dependence are explained in terms of a detailed balance treatment of the LSC as a function of temperature.


2019 ◽  
Vol 12 (3) ◽  
pp. 831-843 ◽  
Author(s):  
F. Jiang ◽  
Y. Xu ◽  
J. Song ◽  
H. Lu ◽  
◽  
...  

Sign in / Sign up

Export Citation Format

Share Document