Identification of Factors Affecting SEM/EDS Analysis for Discrimination and Classification among Common Items of Evidence using Particle Combination Profiles

2021 ◽  
pp. 111125
Author(s):  
David A. Stoney ◽  
Paul L. Stoney
Keyword(s):  
Factors Affecting ◽  
Eds Analysis ◽  
Common Items

Progress In The Practical Application Of Automated Image Analysis To Tem Negatives

1977 ◽  
Vol 35 ◽  
pp. 214-217
Author(s):  
F. A. Heckman ◽  
E. Redman ◽  
J.E. Connolly
Keyword(s):  
Image Analysis ◽  
Image Quality ◽  
Exposure Time ◽  
Image Contrast ◽  
Automated Image Analysis ◽  
Practical Application ◽  
Factors Affecting ◽  
High Image Quality ◽  
Qualitative Evidence ◽  
Comprehensive Study

In our initial publication on this subject1) we reported results demonstrating that contrast is the most important factor in producing the high image quality required for reliable image analysis. We also listed the factors which enhance contrast in order of the experimentally determined magnitude of their effect. The two most powerful factors affecting image contrast attainable with sheet film are beam intensity and KV. At that time we had only qualitative evidence for the ranking of enhancing factors. Later we carried out the densitometric measurements which led to the results outlined below.Meaningful evaluations of the cause-effect relationships among the considerable number of variables in preparing EM negatives depend on doing things in a systematic way, varying only one parameter at a time. Unless otherwise noted, we adhered to the following procedure evolved during our comprehensive study:Philips EM-300; 30μ objective aperature; magnification 7000- 12000X, exposure time 1 second, anti-contamination device operating.

A correlation of CL emissions from Penrith sandstone with elemental distributions obtained by simultaneous SEM-CL and EDS analysis

1995 ◽  
Vol 53 ◽  
pp. 392-393
Author(s):  
Paul J. Wright
Keyword(s):  
Optical Microscope ◽  
Electron Gun ◽  
High Electron ◽  
Collection System ◽  
Electron Hole ◽  
Depositional Processes ◽  
Eds Analysis ◽  
Distribution Mapping ◽  
Backscattered Electron ◽  
Electron Imaging

Most industrial and academic geologists are familiar with the beautiful red and orange cathodoluminescence colours produced by carbonate minerals in an optical microscope with a cold cathode electron gun attached. The cement stratigraphies interpreted from colour photographs have been widely used to determine the post depositional processes which have modified sedimentary rock textures.However to study quartzose materials high electron densities and kV's are necessary to stimulate sufficient emission. A scanning electron microscope with an optical collection system and monochromator provides an adequate tool and gives the advantage of providing secondary and backscattered electron imaging as well as elemental analysis and distribution mapping via standard EDS/WDS facilities.It has been known that the incorporation of many elements modify the characteristics of the CL emissions from geological materials. They do this by taking up positions between the valence and conduction band thus providing sites to assist in the recombination of electron hole pairs.

Factors affecting microstructural scale in liquid crystalline polymers

1990 ◽  
Vol 48 (4) ◽  
pp. 220-221
Author(s):  
Christine M. Dannels ◽  
Christopher Viney
Keyword(s):  
Liquid Crystalline ◽  
Liquid Crystalline Polymers ◽  
Factors Affecting ◽  
Crystalline Polymers ◽  
Thermal Expansion Coefficients ◽  
Low Thermal Expansion ◽  
Lower Viscosity ◽  
Fine Microstructure ◽  
Planar Orientation ◽  
Strength And Stiffness

Processing polymers from the liquid crystalline state offers several advantages compared to processing from conventional fluids. These include: better axial strength and stiffness in fibers, better planar orientation in films, lower viscosity during processing, low solidification shrinkage of injection moldings (thermotropic processing), and low thermal expansion coefficients. However, the compressive strength of the solid is disappointing. Previous efforts to improve this property have focussed on synthesizing stiffer molecules. The effect of microstructural scale has been overlooked, even though its relevance to the mechanical and physical properties of more traditional materials is well established. By analogy with the behavior of metals and ceramics, one would expect a fine microstructure (i..e. a high density of orientational defects) to be desirable.Also, because much microstructural detail in liquid crystalline polymers occurs on a scale close to the wavelength of light, light is scattered on passing through these materials.

Sampling and analysis of the air-water interface with SEM and EDS of microlayers

1989 ◽  
Vol 47 ◽  
pp. 1004-1005
Author(s):  
Randall W. Smith ◽  
John Dash
Keyword(s):  
Heavy Metals ◽  
Surface Microlayer ◽  
Surface Films ◽  
Water Interface ◽  
Physical Processes ◽  
Infrared Spectroscopic Analysis ◽  
Eds Analysis ◽  
Air Water Interface ◽  
Significant Area ◽  
Bulk Chemical

The structure of the air-water interface forms a boundary layer that involves biological ,chemical geological and physical processes in its formation. Freshwater and sea surface microlayers form at the air-water interface and include a diverse assemblage of organic matter, detritus, microorganisms, plankton and heavy metals. The sampling of microlayers and the examination of components is presently a significant area of study because of the input of anthropogenic materials and their accumulation at the air-water interface. The neustonic organisms present in this environment may be sensitive to the toxic components of these inputs. Hardy reports that over 20 different methods have been developed for sampling of microlayers, primarily for bulk chemical analysis. We report here the examination of microlayer films for the documentation of structure and composition.Baier and Gucinski reported the use of Langmuir-Blogett films obtained on germanium prisms for infrared spectroscopic analysis (IR-ATR) of components. The sampling of microlayers has been done by collecting fi1ms on glass plates and teflon drums, We found that microlayers could be collected on 11 mm glass cover slips by pulling a Langmuir-Blogett film from a surface microlayer. Comparative collections were made on methylcel1ulose filter pads. The films could be air-dried or preserved in Lugol's Iodine Several slicks or surface films were sampled in September, 1987 in Chesapeake Bay, Maryland and in August, 1988 in Sequim Bay, Washington, For glass coverslips the films were air-dried, mounted on SEM pegs, ringed with colloidal silver, and sputter coated with Au-Pd, The Langmuir-Blogett film technique maintained the structure of the microlayer intact for examination, SEM observation and EDS analysis were then used to determine organisms and relative concentrations of heavy metals, using a Link AN 10000 EDS system with an ISI SS40 SEM unit. Typical heavy microlayer films are shown in Figure 3.

Electron-Probe Quantitative Energy-Dispersive Analysis of Trace Magnesium Concentrations in Ag-Mg Alloys

1996 ◽  
Vol 54 ◽  
pp. 510-511
Author(s):  
R. B. Marinenko
Keyword(s):  
Electron Probe ◽  
Energy Dispersive Spectrometry ◽  
Mg Alloys ◽  
Energy Dispersive ◽  
Energy Dispersive Analysis ◽  
High Tc ◽  
Alloy Wire ◽  
High Tc Superconductor ◽  
Eds Analysis ◽  
Superior Mechanical Properties

Internally oxidized Ag-Mg alloys are used as sheaths for high Tc superconductor wires because of their superior mechanical properties. The preparation and characteristics of these materials have been reported. Performance of the sheaths depends on the concentration of the magnesium which generally is less than 0.5 wt. percent. The purpose of this work was to determine whether electron probe microanalysis using energy dispersive spectrometry (EDS) could be used to quantitate three different Ag-Mg alloys. Quantitative EDS analysis can be difficult because the AgL escape peak occurs at the same energy (1.25 keV) as the Mg Kα peak. An EDS spectrum of a Ag-Mg alloy wire is compared to a pure Ag spectrum in Fig. 1.

Factors affecting dentist participation in a state Medicaid program

1990 ◽  
Vol 54 (11) ◽  
pp. 638-643 ◽  
Author(s):  
PC Damiano ◽  
ER Brown ◽  
JD Johnson ◽  
JP Scheetz
Keyword(s):  
Medicaid Program ◽  
Factors Affecting

Speech Therapy Services in a Large School System: A Six-Year Overview

1976 ◽  
Vol 7 (4) ◽  
pp. 207-219 ◽  
Author(s):  
Constance P. DesRoches
Keyword(s):  
School System ◽  
Speech Therapy ◽  
Factors Affecting ◽  
Case Load ◽  
Number Of Children ◽  
School Population ◽  
System A ◽  
Therapy Services ◽  
And Shifts ◽  
Selection Factors

A statistical review provides analysis of four years of speech therapy services of a suburban school system which can be used for comparison with other school system programs. Included are data on the percentages of the school population enrolled in therapy, the categories of disabilities and the number of children in each category, the sex and grade-level distribution of those in therapy, and shifts in case-load selection. Factors affecting changes in case-load profiles are identified and discussed.

Assessing the Link Between Perception and Production in Cantonese Tone Acquisition

2019 ◽  
Vol 62 (5) ◽  
pp. 1243-1257 ◽  
Author(s):  
Peggy Pik Ki Mok ◽  
Holly Sze Ho Fung ◽  
Vivian Guo Li
Keyword(s):  
Language Acquisition ◽  
General Principle ◽  
Choice Task ◽  
Factors Affecting ◽  
Tone Pair ◽  
Tone Production ◽  
Monosyllabic Words ◽  
Early Production ◽  
Forced Choice Task ◽  
Production Accuracy

Purpose Previous studies showed early production precedes late perception in Cantonese tone acquisition, contrary to the general principle that perception precedes production in child language. How tone production and perception are linked in 1st language acquisition remains largely unknown. Our study revisited the acquisition of tone in Cantonese-speaking children, exploring the possible link between production and perception in 1st language acquisition. Method One hundred eleven Cantonese-speaking children aged between 2;0 and 6;0 (years;months) and 10 adolescent reference speakers participated in tone production and perception experiments. Production materials with 30 monosyllabic words were transcribed in filtered and unfiltered conditions by 2 native judges. Perception accuracy was based on a 2-alternative forced-choice task with pictures covering all possible tone pair contrasts. Results Children's accuracy of production and perception of all the 6 Cantonese tones was still not adultlike by age 6;0. Both production and perception accuracies matured with age. A weak positive link was found between the 2 accuracies. Mother's native language contributed to children's production accuracy. Conclusions Our findings show that production and perception abilities are associated in tone acquisition. Further study is needed to explore factors affecting production accuracy in children. Supplemental Material https://doi.org/10.23641/asha.7960826

Sign in / Sign up

Export Citation Format

Share Document