Effects of fuel composition and wall thermal conductivity on thermal and NOx emission performances of an ammonia/hydrogen-oxygen micro-power system

2020 ◽  
Vol 209 ◽  
pp. 106527 ◽  
Author(s):  
Tao Cai ◽  
Dan Zhao
2021 ◽  
Vol 145 ◽  
pp. 111150 ◽  
Author(s):  
Tao Cai ◽  
Dan Zhao ◽  
Yuze Sun ◽  
Siliang Ni ◽  
Weixuan Li ◽  
...  

2001 ◽  
Author(s):  
K. Bruce ◽  
R. Richards ◽  
D. Bahr ◽  
C. Richards

Abstract Work toward the development of a thin-film piezoelectric membrane generator is presented. The membrane generator is the central component of a new MEMS power generation system, the P3 micro power system. The P3 micro power system is based on a two-dimensional, modular architecture, in which the individual generic modules or unit cells each have all the functions of an engine integrated. Each unit cell is an external combustion engine, in which thermal power is converted to mechanical power through the use of a novel thermodynamic cycle that approaches the ideal vapor Carnot cycle. Mechanical power is converted into electrical power through the use of a thin-film piezoelectric membrane generator. This paper introduces the concept of the thin-film piezoelectric membrane generator, and describes its design and fabrication. Results of a study to characterize the performance of the piezoelectric membrane generator under expected operating conditions are presented. Current prototypes of the membrane generator are shown to be capable of producing a peak power of 0.1 milliWatts at a voltage of 0.5 Volts.


2008 ◽  
Author(s):  
Yongtai He ◽  
Yangqiu Li ◽  
Lihui Liu ◽  
Lei Wang

2021 ◽  
Vol 246 ◽  
pp. 114664 ◽  
Author(s):  
Jiaqiang E ◽  
Jiangjun Ding ◽  
Jingwei Chen ◽  
Gaoliang Liao ◽  
Feng Zhang ◽  
...  

2021 ◽  
Vol 12 (2) ◽  
pp. 16-35
Author(s):  
Suman Kumar Dey ◽  
Deba Prasad Dash ◽  
Mousumi Basu

This article presents a multi-objective economic environmental/emission dispatch (EED) of variable head hydro-wind-thermal power system. The combination of NOx emission, SO2 emission, and fuel cost are minimized for non-smooth hydrothermal plants while satisfying various operational constraints like non-smooth fuel cost, penalty coefficient, and wind power uncertainty. The objectives—cost, NOx emission, and SO2 emission—are optimized at the same time. In this research, the non-dominated sorting genetic algorithm-II (NSGA-II) has been employed for solving the given problem where the total cost, NOx emission level, and SO2 emission level are optimized at the same time while satisfying all the operational constraints. The simulation results that are obtained by applying the two test systems on the proposed scheme have been evaluated against strength pareto evolutionary algorithm 2 (SPEA 2).


Author(s):  
K. Boyd Fackler ◽  
Megan Karalus ◽  
Igor Novosselov ◽  
John Kramlich ◽  
Philip Malte

Gaseous fuels other than pipeline natural gas are of interest in high-intensity premixed combustors (e.g., lean-premixed gas turbine combustors) as a means of broadening the range of potential fuel resources and increasing the utilization of alternative fuel gases. An area of key interest is the change in emissions that accompanies the replacement of a fuel. The work reported here is an experimental and modeling effort aimed at determining the changes in NOx emission that accompany the use of alternative fuels. Controlling oxides of nitrogen (NOx) from combustion sources is essential in non-attainment areas. Lean-premixed combustion eliminates most of the thermal NOx emission, but is still subject to small, though significant amounts of NOx formed by the complexities of free radical chemistry in the turbulent flames of most combustion systems. Understanding these small amounts of NOx, and how their formation is altered by fuel composition, is the objective of this paper. We explore how NOx is formed in high-intensity, lean-premixed flames of alternative gaseous fuels. This is based on laboratory experiments and interpretation by chemical reactor modeling. Methane is used as the reference fuel. Combustion temperature is maintained the same for all fuels so that the effect of fuel composition on NOx can be studied without the complicating influence of changing temperature. Also, the combustion reactor residence time is maintained nearly constant. When methane containing nitrogen and carbon dioxide (e.g., landfill gas) is burned, NOx increases since the fuel/air ratio is enriched in order to maintain combustion temperature. When fuels of increasing C/H ratio are burned leading to higher levels of carbon monoxide (CO) in the flame, or when the fuel contains CO, the free radicals made as the CO oxidizes cause the NOx to increase. In these cases, the change from high-methane natural gas to alternative gaseous fuel causes the NOx to increase. However, when hydrogen is added to the methane, the NOx may increase or decrease, depending on the combustor wall heat loss. In our work, in which combustor wall heat loss is present, hydrogen addition deceases the NOx. This observation is compared to the literature. Additionally, minimum NOx emission is examined by comparing the present results to the findings of Leonard and Stegmaier.


Author(s):  
K. Boyd Fackler ◽  
Megan Karalus ◽  
Igor Novosselov ◽  
John Kramlich ◽  
Philip Malte ◽  
...  

Gaseous fuels other than pipeline natural gas are of interest in high-intensity premixed combustors (e.g., lean-premixed gas turbine combustors) as a means of broadening the range of potential fuel resources and increasing the utilization of alternative fuel gases. An area of key interest is the change in emissions that accompanies the replacement of a fuel. The work reported here is an experimental and modeling effort aimed at determining the changes in NOx emission that accompany the use of alternative fuels. Controlling oxides of nitrogen (NOx) from combustion sources is essential in nonattainment areas. Lean-premixed combustion eliminates most of the thermal NOx emission but is still subject to small, although significant amounts of NOx formed by the complexities of free radical chemistry in the turbulent flames of most combustion systems. Understanding these small amounts of NOx, and how their formation is altered by fuel composition, is the objective of this paper. We explore how NOx is formed in high-intensity, lean-premixed flames of alternative gaseous fuels. This is based on laboratory experiments and interpretation by chemical reactor modeling. Methane is used as the reference fuel. Combustion temperature is maintained the same for all fuels so that the effect of fuel composition on NOx can be studied without the complicating influence of changing temperature. Also the combustion reactor residence time is maintained nearly constant. When methane containing nitrogen and carbon dioxide (e.g., landfill gas) is burned, NOx increases because the fuel/air ratio is enriched to maintain combustion temperature. When fuels of increasing C/H ratio are burned leading to higher levels of carbon monoxide (CO) in the flame, or when the fuel contains CO, the free radicals made as the CO oxidizes cause the NOx to increase. In these cases, the change from high-methane natural gas to alternative gaseous fuel causes the NOx to increase. However, when hydrogen is added to the methane, the NOx may increase or decrease, depending on the combustor wall heat loss. In our work, in which combustor wall heat loss is present, hydrogen addition deceases the NOx. This observation is compared to the literature. Additionally, minimum NOx emission is examined by comparing the present results to the findings of Leonard and Stegmaier.


Sign in / Sign up

Export Citation Format

Share Document