Assessing the economic feasibility of regional deep saline aquifer CO2 injection and storage: A geomechanics-based workflow applied to the Rose Run sandstone in Eastern Ohio, USA

2008 ◽  
Vol 2 (2) ◽  
pp. 230-247 ◽  
Author(s):  
A LUCIER ◽  
M ZOBACK
Energies ◽  
2020 ◽  
Vol 13 (13) ◽  
pp. 3397
Author(s):  
Danqing Liu ◽  
Yilian Li ◽  
Ramesh Agarwal

As a new “sink” of CO2 permanent storage, the depleted shale reservoir is very promising compared to the deep saline aquifer. To provide a greater understanding of the benefits of CO2 storage in a shale reservoir, a comparative study is conducted by establishing the full-mechanism model, including the hydrodynamic trapping, adsorption trapping, residual trapping, solubility trapping as well as the mineral trapping corresponding to the typical shale and deep saline aquifer parameters from the Ordos basin in China. The results show that CO2 storage in the depleted shale reservoir has merits in storage safety by trapping more CO2 in stable immobile phase due to adsorption and having gentler and ephemeral pressure perturbation responding to CO2 injection. The effect of various CO2 injection schemes, namely the high-speed continuous injection, low-speed continuous injection, huff-n-puff injection and water alternative injection, on the phase transformation of CO2 in a shale reservoir and CO2-injection-induced perturbations in formation pressure are also examined. With the aim of increasing the fraction of immobile CO2 while maintaining a safe pressure-perturbation, it is shown that an intermittent injection procedure with multiple slugs of hug-n-puff injection can be employed and within the allowable range of pressure increase, and the CO2 injection rate can be maximized to increase the CO2 storage capacity and security in shale reservoir.


Energy ◽  
2017 ◽  
Vol 133 ◽  
pp. 404-414 ◽  
Author(s):  
T.D. Rathnaweera ◽  
P.G. Ranjith ◽  
M.S.A. Perera ◽  
A.S. Ranathunga ◽  
W.A.M. Wanniarachchi ◽  
...  

2008 ◽  
Vol 124 (1) ◽  
pp. 50-60 ◽  
Author(s):  
Daiji TANASE ◽  
Ziqiu XUE ◽  
Koji KANO

2019 ◽  
Vol 23 (Suppl. 3) ◽  
pp. 917-925
Author(s):  
Huimin Wang ◽  
J.G. Wang ◽  
Xiaolin Wang ◽  
Fakai Dou ◽  
Bowen Hu

This study investigated the thermal effects of thermal stress and Joule-Thomson cooling on CO2 migration in a deep saline aquifer through a hydro-thermal-mechanical model. Firstly, the temperature variation of injected CO2 was analyzed through the coupling of two-phase flow, deformation of porous medium and heat transfer with Joule-Thomson effect. Then, the effect of capillary entry pressure on CO2 plume was numerically investigated and compared. It is found that injection temperature and Joule-Thomson effect can significantly affect the distributions of CO2 mass and temperature, particularly in the upper zone near the injection well. The reduction of capillary entry pressure accelerates the upward migration of CO2 plume and increases the CO2 lateral migration distance.


2011 ◽  
Vol 5 (5) ◽  
pp. 1303-1318 ◽  
Author(s):  
Coralie Chasset ◽  
Jerker Jarsjö ◽  
Mikael Erlström ◽  
Vladimir Cvetkovic ◽  
Georgia Destouni

Author(s):  
Paul D. Mobley ◽  
Rebecca Z. Pass ◽  
Chris F. Edwards

Decarbonization of electricity production is a vital component in meeting stringent emissions targets aimed at curbing the effects of global climate change. Most projected pathways toward meeting those targets include a large contribution from carbon capture and storage. Many capture technologies impose a large energy penalty to separate and compress carbon dioxide (CO2). Also, injected neat CO2 in a deep saline aquifer is buoyant compared to the aquifer brine and requires an impermeable seal to prevent it from escaping the aquifer. An alternative technology was recently proposed by Heberle and Edwards [1] that burns coal in supercritical water pumped from a saline aquifer. The entire effluent stream is sequestered, capturing all carbon and non-mineral coal combustion products in the process. This stream is denser than the aquifer brine and therefore offers a higher level of storage security, and can utilize aquifers without suitable structural trapping. This technology also increases energy security in the U.S., allowing for the use of its coal resources while avoiding atmospheric pollution. In this paper, a complete architecture employing supercritical water oxidation is proposed, including a liquid-oxygen-pumped air separation unit and regenerator system that heats and desalinates the incoming brine. A thermodynamic model calculates the overall thermal efficiency of the plant, including all separation and storage energy penalties. In addition, an exergy analysis gives insights into the least efficient parts of the proposed system. The details and assumptions of the model are discussed. Insights from the model and these analyses elucidate how the proposed system may be operated as a zero-emission electricity source and the technical challenges that must be addressed for deployment.


Sign in / Sign up

Export Citation Format

Share Document