A comparative study of the thermal decomposition of pyrite under microwave and conventional heating with different temperatures

2019 ◽  
Vol 138 ◽  
pp. 41-53 ◽  
Author(s):  
Xiaoliang Zhang ◽  
Jue Kou ◽  
Chunbao Sun
2013 ◽  
Vol 770 ◽  
pp. 68-71 ◽  
Author(s):  
Supphadate Sujinnapram ◽  
Uraiphorn Termsuk ◽  
Atcharawan Charoentam ◽  
Sutthipoj Sutthana

The nanocrystalline ZnO powders were synthesized by a direct thermal decomposition using zinc nitrate hexahydrate as starting materials. The precursor was characterized by TG-DTA to determine the thermal decomposition and crystallization temperature which was found to be at 325 oC. The precursors were calcined at different temperatures of 400, 500, and 600°C for 4 h. The structure of the prepared samples was studied by XRD, confirming the formation of wurtzite structure. The synthesized powders exhibited the UV absorption below 400 nm (3.10 eV) with a well defined absorption peak at around 285 nm (4.35 eV). The estimated direct bandgaps were obtained to be 3.19, 3.16, and 3.14 eV for the ZnO samples thermally decomposed at 400, 500, and 600°C, respectively.


Energies ◽  
2021 ◽  
Vol 14 (5) ◽  
pp. 1316
Author(s):  
Daniel Mahon ◽  
Gianfranco Claudio ◽  
Philip Eames

To improve the energy efficiency of an industrial process thermochemical energy storage (TCES) can be used to store excess or typically wasted thermal energy for utilisation later. Magnesium carbonate (MgCO3) has a turning temperature of 396 °C, a theoretical potential to store 1387 J/g and is low cost (~GBP 400/1000 kg). Research studies that assess MgCO3 for use as a medium temperature TCES material are lacking, and, given its theoretical potential, research to address this is required. Decomposition (charging) tests and carbonation (discharging) tests at a range of different temperatures and pressures, with selected different gases used during the decomposition tests, were conducted to gain a better understanding of the real potential of MgCO3 for medium temperature TCES. The thermal decomposition (charging) of MgCO3 has been investigated using thermal analysis techniques including simultaneous thermogravimetric analysis and differential scanning calorimetry (TGA/DSC), TGA with attached residual gas analyser (RGA) and diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS) (up to 650 °C). TGA, DSC and RGA data have been used to quantify the thermal decomposition enthalpy from each MgCO3.xH2O thermal decomposition step and separate the enthalpy from CO2 decomposition and H2O decomposition. Thermal analysis experiments were conducted at different temperatures and pressures (up to 40 bar) in a CO2 atmosphere to investigate the carbonation (discharging) and reversibility of the decarbonation–carbonation reactions for MgCO3. Experimental results have shown that MgCO3.xH2O has a three-step thermal decomposition, with a total decomposition enthalpy of ~1050 J/g under a nitrogen atmosphere. After normalisation the decomposition enthalpy due to CO2 loss equates to 1030–1054 J/g. A CO2 atmosphere is shown to change the thermal decomposition (charging) of MgCO3.xH2O, requiring a higher final temperature of ~630 °C to complete the decarbonation. The charging input power of MgCO3.xH2O was shown to vary from 4 to 8136 W/kg with different isothermal temperatures. The carbonation (discharging) of MgO was found to be problematic at pressures up to 40 bar in a pure CO2 atmosphere. The experimental results presented show MgCO3 has some characteristics that make it a candidate for thermochemical energy storage (high energy storage potential) and other characteristics that are problematic for its use (slow discharge) under the experimental test conditions. This study provides a comprehensive foundation for future research assessing the feasibility of using MgCO3 as a medium temperature TCES material. Future research to determine conditions that improve the carbonation (discharging) process of MgO is required.


1998 ◽  
Vol 12 (11) ◽  
pp. 433-441 ◽  
Author(s):  
P. S. Rama Sastry ◽  
T. Bhimasankaram ◽  
G. S. Kumar ◽  
G. Prasad

Complex impedance spectra of ferroelectric mixed ceramic system ( Na 0.5 Bi 0.5)1-x Ca x Bi 4 Ti 4 O 15 with x=0, 0.1, 0.3, 0.5, 0.7 and 1 was studied as a function of frequency and temperature in the range 1 KHz to 10 MHz and 30°C to 620°C respectively. Equivalent circuits involving resistive and capacitive elements at different temperatures, activation energies of relaxations and conduction were evaluated using impedance plots. A comparative study of impedance and conductivity facilities an insight in understanding the electrical nature of these electroceramics.


2012 ◽  
Vol 562-564 ◽  
pp. 188-191
Author(s):  
Keh Moh Lin ◽  
Yang Hsien Lee ◽  
Wen Yeong Huang ◽  
Po Chun Hsu ◽  
Chin Yang Huang ◽  
...  

To find out the important factors which decisively affect the soldering quality of photovoltaic modules, solar cells were soldered under different conditions (different temperatures, PbSn vs. SnAgCu solder, manual vs. semi-automatic). Experimental results show that the soldering quality of PbSn under 350°C in the semi-automatic soldering process was quite stable while the soldering quality of lead-free solder was generally unacceptable in the manual or semi-automatic process under different temperatures. This result indicates that the soldering process with lead-free solder still needs to be further improved. It was also found that most cracks were formed on the interface between the solder and the silver paste and then expanded outwards.


1992 ◽  
Vol 269 ◽  
Author(s):  
Edmund H. Moore ◽  
David E. Clark ◽  
Ronald Hutcheon

ABSTRACTCompact samples of alumina and polymethyl methacrylate have been heated in a 2.45 GHz microwave cavity and by conventional heating in an electric furnace. Various heating schedules have been used to effect the removal of the polymeric binder by thermal decomposition. Dielectric properties, porosity and other physical properties have been investigated in order to better understand the binder removal process in a microwave field. Results of the study emphasize the amount of carbon residuals remaining in the bulk.


Sign in / Sign up

Export Citation Format

Share Document