A quasi in-situ EBSD study of the nucleation and growth of Goss grains during primary and secondary recrystallization of a strip-cast Fe-6.5 wt% Si alloy

2021 ◽  
Vol 861 ◽  
pp. 158550
Author(s):  
Haijie Xu ◽  
Yunbo Xu ◽  
Youliang He ◽  
Haitao Jiao ◽  
Steve Yue ◽  
...  
Keyword(s):  
Secondary Recrystallization ◽  
Nucleation And Growth ◽  
Strip Cast

Role of boundaries in the crystallization of amorphous films

1988 ◽  
Vol 46 ◽  
pp. 626-627
Author(s):  
D. A. Smith
Keyword(s):  
Low Temperature ◽  
Amorphous State ◽  
Nucleation And Growth ◽  
Amorphous Films ◽  
Island Nucleation ◽  
Surface Steps ◽  
Transmission Electron ◽  
Component Systems ◽  
Temperature Deposition

The nucleation and growth processes which lead to the formation of a thin film are particularly amenable to investigation by transmission electron microscopy either in situ or subsequent to deposition. In situ studies have enabled the observation of island nucleation and growth, together with addition of atoms to surface steps. This paper is concerned with post-deposition crystallization of amorphous alloys. It will be argued that the processes occurring during low temperature deposition of one component systems are related but the evidence is mainly indirect. Amorphous films result when the deposition conditions such as low temperature or the presence of impurities (intentional or unintentional) preclude the atomic mobility necessary for crystallization. Representative examples of this behavior are CVD silicon grown below about 670°C, metalloids, such as antimony deposited at room temperature, binary alloys or compounds such as Cu-Ag or Cr O2, respectively. Elemental metals are not stable in the amorphous state.

A TEM study of the microstructure of avian eggshells

1992 ◽  
Vol 50 (2) ◽  
pp. 1102-1103
Author(s):  
S. Q. Xiao ◽  
S. Baden ◽  
A. H. Heuer
Keyword(s):  
Electron Microscope ◽  
Calcium Carbonate ◽  
Nucleation And Growth ◽  
Growth Mechanisms ◽  
Shell Surface ◽  
Thin Sections ◽  
Polycrystalline Metals ◽  
Transmission Electron ◽  
Nucleation And Growth Mechanisms

The avian eggshell is one of the most rapidly mineralizing biological systems known. In situ, 5g of calcium carbonate are crystallized in less than 20 hrs to fabricate the shell. Although there have been much work about the formation of eggshells, controversy about the nucleation and growth mechanisms of the calcite crystals, and their texture in the eggshell, still remain unclear. In this report the microstructure and microchemistry of avian eggshells have been analyzed using transmission electron microscope (TEM) and energy dispersive spectroscopy (EDS).Fresh white and dry brown eggshells were broken and fixed in Karnosky's fixative (kaltitanden) for 2 hrs, then rinsed in distilled H2O. Small speckles of the eggshells were embedded in Spurr medium and thin sections were made ultramicrotome.The crystalline part of eggshells are composed of many small plate-like calcite grains, whose plate normals are approximately parallel to the shell surface. The sizes of the grains are about 0.3×0.3×1 μm3 (Fig.l). These grains are not as closely packed as man-made polycrystalline metals and ceramics, and small gaps between adjacent grains are visible indicating the absence of conventional grain boundaries.

In situ observation of the martensitic transformation in (Mg,Y)-PSZ

1986 ◽  
Vol 44 ◽  
pp. 500-501
Author(s):  
R-R. Lee
Keyword(s):  
Martensitic Transformation ◽  
High Strength ◽  
Nucleation And Growth ◽  
In Situ Observation ◽  
Considerable Potential ◽  
Transmission Electron ◽  
Structural Applications ◽  
Applied Stresses ◽  
Kinetics Of

Partially-stabilized ZrO2 (PSZ) ceramics have considerable potential for advanced structural applications because of their high strength and toughness. These properties derive from small tetragonal ZrO2 (t-ZrO2) precipitates in a cubic (c) ZrO2 matrix, which transform martensitically to monoclinic (m) symmetry under applied stresses. The kinetics of the martensitic transformation is believed to be nucleation controlled and the nucleation is always stress induced. In situ observation of the martensitic transformation using transmission electron microscopy provides considerable information about the nucleation and growth aspects of the transformation.

In Situ Observation of Nucleation and Growth of Carbon Nanotubes from Iron Carbide Nanoparticles

2008 ◽  
Vol 1142 ◽  
Author(s):  
Hideto Yoshida ◽  
Seiji Takeda ◽  
Tetsuya Uchiyama ◽  
Hideo Kohno ◽  
Yoshikazu Homma
Keyword(s):  
Carbon Nanotubes ◽  
Iron Carbide ◽  
Bulk Diffusion ◽  
Chemical Vapor ◽  
Nucleation And Growth ◽  
Atomic Scale ◽  
In Situ Observation ◽  
Transmission Electron ◽  
Cvd Growth

ABSTRACTNucleation and growth processes of carbon nanotubes (CNTs) in iron catalyzed chemical vapor deposition (CVD) have been observed by means of in-situ environmental transmission electron microscopy. Our atomic scale observations demonstrate that solid state iron carbide (Fe3C) nanoparticles act as catalyst for the CVD growth of CNTs. Iron carbide nanoparticles are structurally fluctuated in CVD condition. Growth of CNTs can be simply explained by bulk diffusion of carbon atoms since nanoparticles are carbide.

Direct in situ observation of ZnO nucleation and growth via transmission X-ray microscopy

Nanoscale ◽  
2016 ◽  
Vol 8 (4) ◽  
pp. 1849-1853 ◽  
Author(s):  
S. E. R. Tay ◽  
A. E. Goode ◽  
J. Nelson Weker ◽  
A. A. Cruickshank ◽  
S. Heutz ◽  
...  
Keyword(s):  
Functional Properties ◽  
Nucleation And Growth ◽  
In Situ Observation ◽  
X Ray ◽  
Size And Morphology

The nucleation and growth of a nanostructure controls its size and morphology, and ultimately its functional properties.

Nanoscale Mechanical Properties of In-Situ Tribofilms Generated from ZDDP and F-ZDDP with and without Antioxidants

2007 ◽  
Vol 7 (12) ◽  
pp. 4378-4390 ◽  
Author(s):  
Anuradha Somayaji ◽  
Ramoun Mourhatch ◽  
Pranesh B. Aswath
Keyword(s):  
Electron Microscopy ◽  
Wear Debris ◽  
Surface Region ◽  
Nucleation And Growth ◽  
Near Surface ◽  
Transmission Electron ◽  
Dialkyl Dithiophosphates ◽  
Wear Tests ◽  
Diphenyl Amine

Tribofilms with thickness ranging from 100–200 nm were developed in-situ during wear tests using a zinc dialkyl dithiophosphates (ZDDP) and fluorinated ZDDP (F-ZDDP). The influence of the antioxidant alkylated diphenyl amine on the formation and properties of these tribofilm is examined. Results indicate that the thickness of the tribofilms formed when F-ZDDP is used is always thicker than the tribofilm formed with ZDDP. In addition, in the presence of antioxidants the tribofilm thickness is increased. The hardness of these tribofilms in the absence of the antioxidants is significantly higher at the near surface region (0–30 nm) when compared to the films formed in the presence of antioxidant. Nanoscratch tests conducted to examine the abrasion resistance of the tribofilms also indicate that the tribofilms formed by F-ZDDP are more resistant to scratch compared to films formed by ZDDP. In the presence of antioxidant, tribofilms formed by F-ZDDP are significantly thicker while both films behave in a similar fashion in nanoscratch tests. Transmission electron microscopy of the wear debris formed during the tests were examined and results indicate the nucleation and growth of nanoparticles of Fe3O4 with an approximate size of 5–10 nm embedded within an otherwise amorphous tribofilm.

Grain Nucleation and Growth in Deformed NiTi Shape Memory Alloys: An In Situ TEM Study

2017 ◽  
Vol 3 (4) ◽  
pp. 347-360 ◽  
Author(s):  
J. Burow ◽  
J. Frenzel ◽  
C. Somsen ◽  
E. Prokofiev ◽  
R. Valiev ◽  
...  
Keyword(s):  
Shape Memory Alloys ◽  
Shape Memory ◽  
Nucleation And Growth ◽  
In Situ Tem ◽  
Niti Shape Memory Alloys
Sign in / Sign up

Export Citation Format

Share Document