Theoretical and experimental study of excess quantities in glass-forming systems

2009 ◽  
Vol 355 (52-54) ◽  
pp. 2634-2639
Author(s):  
S. Magazù ◽  
F. Migliardo
Keyword(s):  
Experimental Study ◽  
Glass Forming ◽  
Excess Quantities

Experimental Study of the Liquid-Glass Transition in an Inorganic Polymer Li0.5Na0.5PO3

1995 ◽  
Vol 407 ◽  
Author(s):  
B. Rufflé ◽  
S. Beaufils ◽  
Y. Délugeard ◽  
G. Coddens ◽  
J. Etrillard ◽  
...  
Keyword(s):  
Experimental Study ◽  
Glass Transition ◽  
Raman Scattering ◽  
Viscous Flow ◽  
Liquid Glass ◽  
Low Frequency ◽  
Glass Forming ◽  
Scattering Spectra ◽  
Temperature Ranges ◽  
Raman Scattering Spectra

ABSTRACTNew experimental results obtained with various techniques on a less-studied glass-forming system are presented. At low frequency, a secondary βslow-process, decoupled from the viscous flow, is observed by 3 1P NMR. Raman scattering spectra and coherent neutron scattering spectra has been obtained in wide frequency and temperature ranges showing the same qualitative features for the Boson peak while the quasielastic contribution seems to differ markedly.

Experimental study of bubble formation in a glass‐forming liquid doped with cerium oxide

2019 ◽  
Vol 103 (4) ◽  
pp. 2453-2462 ◽  
Author(s):  
Luiz Pereira ◽  
Olivier Podda ◽  
Barbara Fayard ◽  
Annabelle Laplace ◽  
Franck Pigeonneau
Keyword(s):  
Experimental Study ◽  
Cerium Oxide ◽  
Bubble Formation ◽  
Glass Forming

scholarly journals Theoretical and Experimental Study of Compression Effects on Structural Relaxation of Glass-Forming Liquids

ACS Omega ◽  
2020 ◽  
Vol 5 (19) ◽  
pp. 11035-11042 ◽  
Author(s):  
Anh D. Phan ◽  
Agnieszka Jedrzejowska ◽  
Marian Paluch ◽  
Katsunori Wakabayashi
Keyword(s):  
Experimental Study ◽  
Structural Relaxation ◽  
Glass Forming ◽  
Compression Effects

Electron Microscopy of Silicon Nitride-Based Ceramics

1991 ◽  
Vol 49 ◽  
pp. 926-927
Author(s):  
Gareth Thomas
Keyword(s):  
Electron Microscopy ◽  
High Temperature ◽  
Silicon Nitride ◽  
World Wide ◽  
Sintering Temperature ◽  
Liquid Phase Sintering ◽  
High Temperature Strength ◽  
Sintering Additives ◽  
Glass Forming ◽  
Dense Product

Silicon nitride and silicon nitride based-ceramics are now well known for their potential as hightemperature structural materials, e.g. in engines. However, as is the case for many ceramics, in order to produce a dense product, sintering additives are utilized which allow liquid-phase sintering to occur; but upon cooling from the sintering temperature residual intergranular phases are formed which can be deleterious to high-temperature strength and oxidation resistance, especially if these phases are nonviscous glasses. Many oxide sintering additives have been utilized in processing attempts world-wide to produce dense creep resistant components using Si3N4 but the problem of controlling intergranular phases requires an understanding of the glass forming and subsequent glass-crystalline transformations that can occur at the grain boundaries.

Experimental study on the restoration from a tilt-azimuth series for improvement in resolution

1995 ◽  
Vol 53 ◽  
pp. 636-637
Author(s):  
Norio Baba ◽  
Norihiko Ichise ◽  
Syunya Watanabe
Keyword(s):  
Experimental Study ◽  
Spherical Aberration ◽  
Incident Beam ◽  
Optical Parameters ◽  
Beam Tilting ◽  
Illumination Method ◽  
Restoration Method ◽  
Illumination Mode

The tilted beam illumination method is used to improve the resolution comparing with the axial illumination mode. Using this advantage, a restoration method of several tilted beam images covering the full azimuthal range was proposed by Saxton, and experimentally examined. To make this technique more reliable it seems that some practical problems still remain. In this report the restoration was attempted and the problems were considered. In our study, four problems were pointed out for the experiment of the restoration. (1) Accurate beam tilt adjustment to fit the incident beam to the coma-free axis for the symmetrical beam tilting over the full azimuthal range. (2) Accurate measurements of the optical parameters which are necessary to design the restoration filter. Even if the spherical aberration coefficient Cs is known with accuracy and the axial astigmatism is sufficiently compensated, at least the defocus value must be measured. (3) Accurate alignment of the tilt-azimuth series images.

The effect of an aluminum heat-sink layer on the laser-induced amorphization of SiOx/TeGeSn/SiOx phase-change recording films

1989 ◽  
Vol 47 ◽  
pp. 574-575
Author(s):  
Matthew R. Libera ◽  
Martin Chen
Keyword(s):  
Thin Film ◽  
Phase Change ◽  
Heat Sink ◽  
Multilayer Film ◽  
Glassy Phase ◽  
Film Structure ◽  
Glass Forming ◽  
Active Storage ◽  
Dielectric Layers ◽  
Amorphous States

Phase-change erasable optical storage is based on the ability to switch a micron-sized region of a thin film between the crystalline and amorphous states using a diffraction-limited laser as a heat source. A bit of information can be represented as an amorphous spot on a crystalline background, and the two states can be optically identified by their different reflectivities. In a typical multilayer thin-film structure the active (storage) layer is sandwiched between one or more dielectric layers. The dielectric layers provide physical containment and act as a heat sink. A viable phase-change medium must be able to quench to the glassy phase after melting, and this requires proper tailoring of the thermal properties of the multilayer film. The present research studies one particular multilayer structure and shows the effect of an additional aluminum layer on the glass-forming ability.

An Experimental Study of Some Properties of Stuttered Words

1962 ◽  
Vol 5 (4) ◽  
pp. 387-394 ◽  
Author(s):  
Bruce Quarrington ◽  
Jerome Conway ◽  
Nathan Siegel
Keyword(s):  
Experimental Study
Sign in / Sign up

Export Citation Format

Share Document