scholarly journals An improved specimen preparation method for marine shallow gas-bearing sand sediments and its validations

Author(s):  
Yong Wang ◽  
Lingwei Kong ◽  
Min Wang ◽  
Yanli Wang ◽  
Peng Cheng
Author(s):  
R. W. Anderson ◽  
D. L. Senecal

A problem was presented to observe the packing densities of deposits of sub-micron corrosion product particles. The deposits were 5-100 mils thick and had formed on the inside surfaces of 3/8 inch diameter Zircaloy-2 heat exchanger tubes. The particles were iron oxides deposited from flowing water and consequently were only weakly bonded. Particular care was required during handling to preserve the original formations of the deposits. The specimen preparation method described below allowed direct observation of cross sections of the deposit layers by transmission electron microscopy.The specimens were short sections of the tubes (about 3 inches long) that were carefully cut from the systems. The insides of the tube sections were first coated with a thin layer of a fluid epoxy resin by dipping. This coating served to impregnate the deposit layer as well as to protect the layer if subsequent handling were required.


Author(s):  
Toshihiko Takita ◽  
Tomonori Naguro ◽  
Toshio Kameie ◽  
Akihiro Iino ◽  
Kichizo Yamamoto

Recently with the increase in advanced age population, the osteoporosis becomes the object of public attention in the field of orthopedics. The surface topography of the bone by scanning electron microscopy (SEM) is one of the most useful means to study the bone metabolism, that is considered to make clear the mechanism of the osteoporosis. Until today many specimen preparation methods for SEM have been reported. They are roughly classified into two; the anorganic preparation and the simple preparation. The former is suitable for observing mineralization, but has the demerit that the real surface of the bone can not be observed and, moreover, the samples prepared by this method are extremely fragile especially in the case of osteoporosis. On the other hand, the latter has the merit that the real information of the bone surface can be obtained, though it is difficult to recognize the functional situation of the bone.


2010 ◽  
Vol 8 ◽  
pp. 141-144 ◽  
Author(s):  
Y. Hanaoka ◽  
S. Mikami ◽  
N. Mayama ◽  
T. Iwata ◽  
Y. Kajiwara ◽  
...  

2003 ◽  
Vol 67 (6) ◽  
pp. 1171-1182 ◽  
Author(s):  
B. A. Cressey ◽  
G. Cressey

AbstractWe have imaged the spatially-preserved microtexture of biogenic apatite, retained together with its collagen template, in non-demineralized human bone using high-resolution transmission electron microscopy. Using ion-beam thinning, a specimen preparation method generally employed for inorganic minerals rather than for biological materials, we have imaged a composite nanostructure of bone not previously reported, and we propose a model for this nano-architecture that involves a boxconstruction of apatite plates and apatite sheets. This observation provides a new understanding of bone strength at the nanometre scale and suggests how post mortem enhancement of this texture by recrystallization probably accounts for the durability of ancient bone. Modern sheep bone (a close analogue for recently dead human bone) imaged in the same way also shows evidence of this composite architecture.


2016 ◽  
Vol 22 (S3) ◽  
pp. 132-133 ◽  
Author(s):  
Qingxiao Wang ◽  
Jinguo Wang ◽  
Moon J. Kim

Author(s):  
Vera Bolis ◽  
Claudia Busco ◽  
Gianmario Martra ◽  
Luca Bertinetti ◽  
Yuriy Sakhno ◽  
...  

The affinity towards water of a selection of well-defined, nanostructured hydroxyapatite (HA) samples was investigated by H 2 O vapour adsorption microcalorimetry and infrared (IR) spectroscopy. A large hydrophilicity of all investigated materials was confirmed. The surface features of hydrated HA were investigated on the as-synthesized samples pre-treated in mild conditions at T =303 K, whereas dehydrated HA features were characterized on samples activated at T =573 K. The relatively large hydrophilicity of the hydrated surface (−Δ ads H∼100–50 kJ mol −1 ) was due to the interaction of water with the highly polarized H 2 O molecules strongly coordinated to the surface Ca 2+ cations. At the dehydrated surface, exposing coordinatively unsaturated ( cus ) Ca 2+ cations, H 2 O was still molecularly adsorbed but more strongly (−Δ ads H∼120–90 kJ mol −1 ). The use of CO adsorption to quantify the Lewis acidic strength of HA surface sites revealed only a moderate strength of cus Ca 2+ cations, as confirmed by both microcalorimetric and IR spectroscopic measurements and ab initio calculations. This result implies that the large HA/H 2 O interaction energy is due to the interplay between cus Ca 2+ sites and nearby hydrophilic PO 4 groups, not revealed by the CO probe. The lower density of cus Ca 2+ cations at the 573 K activated HA surface with respect to the pristine one did not affect the whole hydrophilicity of the surface, as the polarizing effect of Ca sites is so strong to extend up to the fourth hydrated layer, as confirmed by both high-coverage microcalorimetric and IR spectroscopic data. No specific effects due to the investigated specimen preparation method and/or different morphology were observed.


2007 ◽  
Vol 22 (2) ◽  
pp. 152-155 ◽  
Author(s):  
Christopher G. Worley ◽  
Lisa P. Colletti

A novel method for preparing thin films was investigated for quantifying gallium and iron in plutonium solutions using WDXRF. This technique was developed to eliminate the potential for radioactive liquid to leak into the spectrometer, decrease specimen preparation time, and minimize waste. Samples were cast in μL quantities onto Kapton, and a surfactant was added to disperse the solution uniformly across the Kapton. After drying the specimens, they were sealed in a cell for analysis. Results to date indicate the method can provide a relative precision of ∼0.5% for gallium and ∼2% for iron, which is more than sufficient for routine sample analyses.


Sign in / Sign up

Export Citation Format

Share Document