Trace elements in olivine: Proxies for petrogenesis, mineralization and discrimination of mafic-ultramafic rocks

Lithos ◽  
2021 ◽  
pp. 106085
Author(s):  
Jing Wang ◽  
Ben-Xun Su ◽  
Paul T. Robinson ◽  
Yan Xiao ◽  
Yang Bai ◽  
...  
2020 ◽  
Vol 105 (4) ◽  
pp. 479-497 ◽  
Author(s):  
Xie-Yan Song ◽  
Kai-Yuan Wang ◽  
Stephen J. Barnes ◽  
Jun-Nian Yi ◽  
Lie-Meng Chen ◽  
...  

Abstract Chromite is one of the earliest crystallized minerals from mafic melts and has been used as an important “petrogenetic indicator.” Its composition may be modified by interaction with intercumulate melt and adjacent minerals. Thus, chromite in mafic-ultramafic rocks contains clues to the geochemical affinity, evolution, and mantle source of its parent magmas. The Devonian Xiarihamu intrusion, located in the East Kunlun Orogenic Belt in the northern Tibet Plateau, China, hosts a very large disseminated Ni-Co sulfide deposit. This study focuses on geochemistry of the chromite enclosed in olivine of ultramafic rocks of the intrusion. Enrichments in Mg and Al in the rim of the chromite indicate only minor effects of alteration on the compositions of the chromite. The chromites enclosed in the olivines with forsterite percentage (Fo) lower than 87 are characterized by large variations in major and trace elements, such as large ranges of Cr·100/(Cr+Al) (Cr# = 15–47), Mg·100/(Mg+Fe2+) (Mg# = 41–65), and Al2O3 (= 26–53 wt%) as well as 380–3100 ppm V, 70–380 ppm Ga, and 1100–16300 ppm Zn. The chromites display positive correlations between Cr/(Cr+Al) and Ti, Mn, V, Ga, and Sc, inconsistent with fractional crystallization but indicative of an interaction between the chromites, intercumulate melts and hosting minerals. In contrast, chromites hosted in olivine with Fo > 87 in harzburgite have small variations in Cr# (ranging from 37 to 41), Mg# (48 to 51), and Al2O3 (30 to 35 wt%) as well as restricted variation in trace elements, indicating relatively weak interaction with trapped liquid and adjacent phases; these compositions are close to those of the most primitive, earliest crystallized chromites. The most primitive chromite has similarities with chromite in mid-ocean ridge basalt (MORB) in TiO2 and Al2O3 contents (0.19–0.32 and 27.9–36.3 wt%, respectively) and depletion of Sc and enrichment of Ga and Zn relative to MORB chromite. The geochemistry of the chromite indicates a partial melting of the asthenospheric mantle that was modified by melts derived from the subduction slab at garnet-stable pressures.


2020 ◽  
Vol 35 (11) ◽  
pp. 2627-2638
Author(s):  
Okina Olga Ilyinichna ◽  
Lyapunov Sergey Michailovich ◽  
Dubenskiy Alexander Sergeevich ◽  
Erofeeva Kseniya Gennadievna

A chemical treatment scheme providing complete dissolution of a 300 mg test portion of ultramafic rocks with various MgO contents is proposed.


1979 ◽  
Vol 16 (1) ◽  
pp. 80-90 ◽  
Author(s):  
T. L. Muir

The ultramafic rocks in the Shaw Dome area, southeast of Timmins, Ontario, are divided on the basis of held criteria into two groups for the purpose of comparing their chemical compositions: (1) extrusive ultramafic rocks consisting of peridotitic komatiites and (2) intrusive ultramafic rocks, consisting of dunites and lherzolites.The two groups can be distinguished on a chemical basis by graphical and statistical methods which provide accuracies of extrusive–intrusive classification of about 92 and 96% respectively. Both methods provide qualitative and quantitative aspects of discrimination.The discriminating parameters were developed using samples which show all types and degrees of alteration that are common in ultramafic rocks. Preliminary studies indicate that the genera! procedure for chemical discrimination between extrusive and intrusive ultramafic rocks may be applicable to similar Archean rocks from other areas.In addition, the separation provides an aid to exploration for minerals such as nickel sulphides, asbestos, magnesite, and gold which may be largely restricted to either extrusive or intrusive ultramafic rocks.


Author(s):  
L. F. Borisenko ◽  
Λ. Φ. Борисенко

SummaryThe minor elements Li, Sc, V, Cr, Co, Ni, Ga, Rb, and Sr have been determined in a number of diopsides and horneblendes from ultramafic rocks of the Gussevogorsk, Baranchinsk, and Nizhne-Tagilsk massifs in the Urals. Actinolite and anthophyllite are rare contact metamorphic products ; they too were analysed. The diopside and hornblende from the earlier-formed rocks, richer in olivine, contain more Cr and less V and Ti than those from the later-formed rocks.


2008 ◽  
Vol 255 (1-2) ◽  
pp. 143-159 ◽  
Author(s):  
Laure Pelletier ◽  
Othmar Müntener ◽  
Angelika Kalt ◽  
Torsten W. Vennemann ◽  
Tamás Belgya

Author(s):  
O.T. Woo ◽  
G.J.C. Carpenter

To study the influence of trace elements on the corrosion and hydrogen ingress in Zr-2.5 Nb pressure tube material, buttons of this alloy containing up to 0.83 at% Fe were made by arc-melting. The buttons were then annealed at 973 K for three days, furnace cooled, followed by ≈80% cold-rolling. The microstructure of cold-worked Zr-2.5 at% Nb-0.83 at% Fe (Fig. 1) contained both β-Zr and intermetallic precipitates in the α-Zr grains. The particles were 0.1 to 0.7 μm in size, with shapes ranging from spherical to ellipsoidal and often contained faults. β-Zr appeared either roughly spherical or as irregular elongated patches, often extending to several micrometres.The composition of the intermetallic particles seen in Fig. 1 was determined using Van Cappellen’s extrapolation technique for energy dispersive X-ray analysis of thin metal foils. The method was employed to avoid corrections for absorption and fluorescence via the Cliff-Lorimer equation: CA/CB = kAB · IA/IB, where CA and CB are the concentrations by weight of the elements A and B, and IA and IB are the X-ray intensities; kAB is a proportionality factor.


Author(s):  
D. A. Carpenter ◽  
Ning Gao ◽  
G. J. Havrilla

A monolithic, polycapillary, x-ray optic was adapted to a laboratory-based x-ray microprobe to evaluate the potential of the optic for x-ray micro fluorescence analysis. The polycapillary was capable of collecting x-rays over a 6 degree angle from a point source and focusing them to a spot approximately 40 µm diameter. The high intensities expected from this capillary should be useful for determining and mapping minor to trace elements in materials. Fig. 1 shows a sketch of the capillary with important dimensions.The microprobe had previously been used with straight and with tapered monocapillaries. Alignment of the monocapillaries with the focal spot was accomplished by electromagnetically scanning the focal spot over the beveled anode. With the polycapillary it was also necessary to manually adjust the distance between the focal spot and the polycapillary.The focal distance and focal spot diameter of the polycapillary were determined from a series of edge scans.


1979 ◽  
Vol 7 (6) ◽  
pp. 1330-1331
Author(s):  
E. D. WILLS

2004 ◽  
Vol 74 (4) ◽  
pp. 247-251 ◽  
Author(s):  
Lombardi-Boccia ◽  
Lanzi ◽  
Lucarini ◽  
Di Lullo

This study was undertaken to estimate the contribution of meat and meat products consumption to the daily intakes of trace elements (Fe, Zn, Cu, Se), heme iron, and selected B vitamins (thiamine, riboflavin, niacin) in Italy. Meat and meat products were selected on the basis of their consumption frequency reported by the most recent nationwide dietary individual survey carried out in Italy (INN-CA study). The daily intakes of total iron and heme iron were 1.65 and 1.13 mg/person/day. Zinc intake was 3.65 mg/person/day. Beef made the main contribution to iron, heme iron, and zinc daily intakes. Copper daily intake was 107.3 mug/person/day, with meat products provided the highest contribution (40 mug/person/day). Daily intake of selenium (7.14 mug/person/day) was provided mainly by poultry consumption. Thiamine intake was 228 mug/person/day, and meat products were the main source (110 mug/person/day). Riboflavin intake was 136 mug/person/day, with both beef and meat products as the main contributors (40 mug/person/day). Niacin intake was 7.53 mg/person/day, and poultry was the main source (2.28 mg/person/day). Meat and meat products were a valuable source of micronutrients, supplying 47, 48, and 24% of zinc, niacin, and thiamin daily requirements, respectively, and over 10% of iron, copper, selenium, and riboflavin daily average requirement values of the italian RDAs calculated for the population involved in the survey (INN-CA study).


Sign in / Sign up

Export Citation Format

Share Document