Plasma-assisted chemical vapor deposited silicon oxynitride as an alternative material for gate dielectric in MOS devices

2006 ◽  
Vol 37 (1) ◽  
pp. 64-70 ◽  
Author(s):  
A. Szekeres ◽  
T. Nikolova ◽  
S. Simeonov ◽  
A. Gushterov ◽  
F. Hamelmann ◽  
...  
1995 ◽  
Vol 387 ◽  
Author(s):  
S. V. Hattangady ◽  
H. Niimi ◽  
S. Gandhi ◽  
G. Lucovsky

AbstractThin film dielectrics have been prepared in a cluster processing system with chambers for plasma-assisted, rapid-thermal processing, and on-line Auger electron spectroscopy (AES). A low-thermal budget process for the formation of homogeneous silicon oxynitride (OXN) alloy films is presented. This Na2-based plasma-CVD process has (i) increased process latitude for the formation of N-rich alloys, and (ii) results in lower bonded-H concentrations, in comparison with a similar NH3-based process. Gate dielectric formation consists of (i) a 300°C plasma-assisted oxidation for removal of residual hydrocarbons, and formation of an Si-SiO2 interface protected by ∼0.5-0.6 nm of oxide, (ii) a 300°C plasma-assisted CVD of oxynitride films from N2O, N2, and SiH4, and (iii) a 30 s, 900°C post-deposition rapid-thermal anneal in an ambient that contains sufficient oxygen to prevent decomposition of the Si/SiO2 interface. On-line AES and off-line infrared (IR) spectroscopy have been used to characterize chemical bonding, showing that the deposited films are pseudo-binary alloys lying on a join-line from SiO2 and Si3N4 in a ternary composition diagram. Electrical characterization of MOS capacitors, consisting of O-OXN-O structures, using C-V techniques is discussed.


1988 ◽  
Vol 131 ◽  
Author(s):  
Aubrey L. Helms ◽  
Robert M. Havrilla

ABSTRACTThe properties of Plasma Enhanced Chemical Vapor Deposited (PECVD) silicon oxynitride thin films were determined for a variety of deposition conditions. The films were characterized with respect to stress, refractive index, deposition rate, hydrogen content, dielectric constant, and uniformity. The films were deposited in an Electrotech ND6200 parallel plate reactor using a silane - ammonia - nitrous oxide process gas chemistry. Deposition parameters which were investigated include process gas flow rate, power, and total pressure. The possible application of these films as both inter-layer and final passivation layers for use on GaAs ICs will be discussed.


1987 ◽  
Vol 62 (11) ◽  
pp. 4538-4544 ◽  
Author(s):  
Y. Cros ◽  
J. C. Rostaing ◽  
J. Peisner ◽  
G. Leveque ◽  
C. Ance

2001 ◽  
Vol 08 (05) ◽  
pp. 569-573
Author(s):  
R. LIU ◽  
K. H. KOA ◽  
A. T. S. WEE ◽  
W. H. LAI ◽  
M. F. LI ◽  
...  

As the gate dielectric for ULSI MOS devices scales in the ultrathin regime, it is fabricated increasingly with silicon oxynitride instead of silicon dioxide films. One way to obtain silicon oxynitride films is the rapid thermal oxidation of silicon in NO (RTNO). Earlier RTNO growth studies were not sufficiently comprehensive as well as limited by temperature uncertainty and nonuniformity across the wafer. Using a state-of-the-art rapid thermal processing (RTP) system, RTNO growth characteristics at oxidation pressures of 100 and 760 Torr, oxidation temperatures from 900 to 1200°C and oxidation times from 0 to 480 s were obtained and investigated. Anomalies in the growth characteristics were observed. It was also demonstrated that secondary ion mass spectrometry (SIMS) using the MCs + method could be used to accurately determine the depth distribution of N in ultrathin silicon oxynitride films.


Sign in / Sign up

Export Citation Format

Share Document