Effect of moisture content on flow behavior and resistance characteristics of dense-phase pneumatic conveying

2021 ◽  
Vol 387 ◽  
pp. 1-8
Author(s):  
Zhen Liu ◽  
Qiang Li ◽  
Jiansheng Zhang
Keyword(s):  
Moisture Content ◽  
Flow Behavior ◽  
Pneumatic Conveying ◽  
Dense Phase ◽  
Effect Of Moisture

Decoupling the joint effect of moisture and mass in dense phase pneumatic conveying

2013 ◽  
Vol 34 ◽  
pp. 168-176 ◽  
Author(s):  
Jiangtao Chen ◽  
Shi Liu ◽  
Di Wu ◽  
Zhenxing Han ◽  
Zhihong Li ◽  
...  
Keyword(s):  
Joint Effect ◽  
Pneumatic Conveying ◽  
Dense Phase ◽  
Effect Of Moisture

Effect of moisture content on dense-phase conveying of pulverized coal at high pressure

2011 ◽  
Vol 28 (10) ◽  
pp. 2086-2093 ◽  
Author(s):  
Xu Pan ◽  
Xiaoping Chen ◽  
Cai Liang ◽  
Guiling Xu ◽  
Daoyin Liu ◽  
...  
Keyword(s):  
High Pressure ◽  
Moisture Content ◽  
Pulverized Coal ◽  
Dense Phase ◽  
Effect Of Moisture

scholarly journals Effect of Moisture Content on the Processing and Mechanical Properties of a Biodegradable Polyester

Polymers ◽  
2021 ◽  
Vol 13 (10) ◽  
pp. 1616
Author(s):  
Vincenzo Titone ◽  
Antonio Correnti ◽  
Francesco Paolo La Mantia
Keyword(s):  
Mechanical Properties ◽  
Tensile Strength ◽  
Moisture Content ◽  
Mechanical Testing ◽  
Hydrolytic Degradation ◽  
Slight Reduction ◽  
Biodegradable Polyester ◽  
Molding Process ◽  
Elongation At Break ◽  
Effect Of Moisture

This work is focused on the influence of moisture content on the processing and mechanical properties of a biodegradable polyester used for applications in injection molding. The pellets of the biodegradable polyester were exposed under different relative humidity conditions at a constant temperature before being compression molded. The compression-molded specimens were again placed under the above conditions before the mechanical testing. With all these samples, it is possible to determine the effect of moisture content on the processing and mechanical properties separately, as well as the combined effect of moisture content on the mechanical properties. The results obtained showed that the amount of absorbed water—both before processing and before mechanical testing—causes an increase in elongation at break and a slight reduction of the elastic modulus and tensile strength. These changes have been associated with possible hydrolytic degradation during the compression molding process and, in particular, with the plasticizing action of the moisture absorbed by the specimens.

Sign in / Sign up

Export Citation Format

Share Document