Latent heat flux variability and response to drought stress of black poplar: A multi-platform multi-sensor remote and proximal sensing approach to relieve the data scarcity bottleneck

2022 ◽  
Vol 268 ◽  
pp. 112771
Author(s):  
Flavia Tauro ◽  
Antonino Maltese ◽  
Roberto Giannini ◽  
Antoine Harfouche
Keyword(s):  
Heat Flux ◽  
Drought Stress ◽  
Latent Heat ◽  
Latent Heat Flux ◽  
Proximal Sensing ◽  
Data Scarcity ◽  
Black Poplar ◽  
Flux Variability

scholarly journals Unrealistic Increases in Wind Speed Explain Reduced Eastern Pacific Heat Flux in Reanalyses

2018 ◽  
Vol 31 (8) ◽  
pp. 2981-2993
Author(s):  
Chunlei Liu ◽  
Richard P. Allan
Keyword(s):  
Heat Flux ◽  
Wind Speed ◽  
Latent Heat ◽  
Latent Heat Flux ◽  
Climate Model ◽  
Surface Flux ◽  
Eastern Pacific ◽  
Tropical Eastern Pacific ◽  
Flux Variability ◽  
Climate Model Simulations

Abstract Tropical eastern Pacific sea surface temperature plays a pivotal role in mechanisms that determine global mean surface temperature variability. In this study, the surface flux contribution to recent cooling of the tropical eastern Pacific is investigated using data from three atmospheric reanalyses with full assimilation of observations, an observation-based net surface energy flux reconstruction, and 15 atmosphere-only climate model simulations. For ERA-Interim, 78% of the decrease in net surface flux (−0.65 W m−2 yr−1 over 1988–2008) is explained by the latent heat flux variability. Latent heat flux variability differs between datasets, and this is investigated using a bulk formula. It is found that discrepancies in wind speed change explain contrasting latent heat flux trends across datasets. The significant increase in wind speed of 0.26 m s−1 decade−1 over the tropical eastern Pacific in ERA-Interim is not reproduced by satellite or buoy observations or atmosphere-only climate model simulations, casting questions on the reliability of reanalysis-based surface fluxes over the tropical eastern Pacific.

An analog period method for gap‐filling of latent heat flux measurements

2021 ◽  
Author(s):  
Lucas Emilio B. Hoeltgebaum ◽  
Nelson Luís Dias ◽  
Marcelo Azevedo Costa
Keyword(s):  
Heat Flux ◽  
Latent Heat ◽  
Latent Heat Flux ◽  
Gap Filling ◽  
Flux Measurements

Scanning 10-W Water Vapor DIAL for the Investigation of Atmospheric Turbulence and Land-Atmosphere Feedback

2021 ◽  
Author(s):  
Andreas Behrendt ◽  
Florian Spaeth ◽  
Volker Wulfmeyer
Keyword(s):  
Heat Flux ◽  
Water Vapor ◽  
Latent Heat ◽  
Atmospheric Turbulence ◽  
Latent Heat Flux ◽  
Climate Models ◽  
Weather Forecast ◽  
Surface Characteristics ◽  
Scanning System ◽  
Forecast Models

<p>We will present recent measurements made with the water vapor differential absorption lidar (DIAL) of University of Hohenheim (UHOH). This scanning system has been developed in recent years for the investigation of atmospheric turbulence and land-atmosphere feedback processes.</p><p>The lidar is housed in a mobile trailer and participated in recent years in a number of national and international field campaigns. We will present examples of vertical pointing and scanning measurements, especially close to the canopy. The water vapor gradients in the surface layer are related to the latent heat flux. Thus, with such low-elevation scans, the latent heat flux distribution over different surface characteristics can be monitored, which is important to verify and improve both numerical weather forecast models and climate models.</p><p>The transmitter of the UHOH DIAL consists of a diode-pumped Nd:YAG laser which pumps a Ti:sapphire laser. The output power of this laser is up to 10 W. Two injection seeders are used to switch pulse-to-pulse between the online and offline signals. These signals are then either directly sent into the atmosphere or coupled into a fiber and guided to a transmitting telescope which is attached to the scanner unit. The receiving telescope has a primary mirror with a dimeter of 80 cm. The backscatter signals are recorded shot to shot and are typically averaged over 0.1 to 1 s.</p>

The Effect of Soil on the Summertime Surface Energy Budget of a Humid Subarctic Tundra in Northern Quebec, Canada

2021 ◽  
Vol 22 (10) ◽  
pp. 2547-2564
Author(s):  
Georg Lackner ◽  
Daniel F. Nadeau ◽  
Florent Domine ◽  
Annie-Claude Parent ◽  
Gonzalo Leonardini ◽  
...  
Keyword(s):  
Heat Flux ◽  
Latent Heat ◽  
Latent Heat Flux ◽  
Land Surface ◽  
Sensible Heat Flux ◽  
Arctic Region ◽  
Heat Fluxes ◽  
Surface Energy Budget ◽  
Turbulent Heat ◽  
Turbulent Heat Fluxes

AbstractRising temperatures in the southern Arctic region are leading to shrub expansion and permafrost degradation. The objective of this study is to analyze the surface energy budget (SEB) of a subarctic shrub tundra site that is subject to these changes, on the east coast of Hudson Bay in eastern Canada. We focus on the turbulent heat fluxes, as they have been poorly quantified in this region. This study is based on data collected by a flux tower using the eddy covariance approach and focused on snow-free periods. Furthermore, we compare our results with those from six Fluxnet sites in the Arctic region and analyze the performance of two land surface models, SVS and ISBA, in simulating soil moisture and turbulent heat fluxes. We found that 23% of the net radiation was converted into latent heat flux at our site, 35% was used for sensible heat flux, and about 15% for ground heat flux. These results were surprising considering our site was by far the wettest site among those studied, and most of the net radiation at the other Arctic sites was consumed by the latent heat flux. We attribute this behavior to the high hydraulic conductivity of the soil (littoral and intertidal sediments), typical of what is found in the coastal regions of the eastern Canadian Arctic. Land surface models overestimated the surface water content of those soils but were able to accurately simulate the turbulent heat flux, particularly the sensible heat flux and, to a lesser extent, the latent heat flux.

scholarly journals Numerical simulation of extreme snow melt observed at the SIGMA-A site, northwest Greenland, during summer 2012

2015 ◽  
Vol 9 (1) ◽  
pp. 495-539
Author(s):  
M. Niwano ◽  
T. Aoki ◽  
S. Matoba ◽  
S. Yamaguchi ◽  
T. Tanikawa ◽  
...  
Keyword(s):  
Heat Flux ◽  
Grain Size ◽  
Latent Heat ◽  
Latent Heat Flux ◽  
In Situ Measurements ◽  
The Arctic ◽  
Snow Surface ◽  
Near Surface ◽  
Surface Snow

Abstract. The surface energy balance (SEB) from 30 June to 14 July 2012 at site SIGMA (Snow Impurity and Glacial Microbe effects on abrupt warming in the Arctic)-A, (78°03' N, 67°38' W; 1490 m a.s.l.) on the northwest Greenland Ice Sheet (GrIS) was investigated by using in situ atmospheric and snow measurements, as well as numerical modeling with a one-dimensional, multi-layered, physical snowpack model called SMAP (Snow Metamorphism and Albedo Process). At SIGMA-A, remarkable near-surface snowmelt and continuous heavy rainfall (accumulated precipitation between 10 and 14 July was estimated to be 100 mm) were observed after 10 July 2012. Application of the SMAP model to the GrIS snowpack was evaluated based on the snow temperature profile, snow surface temperature, surface snow grain size, and shortwave albedo, all of which the model simulated reasonably well. However, comparison of the SMAP-calculated surface snow grain size with in situ measurements during the period when surface hoar with small grain size was observed on-site revealed that it was necessary to input air temperature, relative humidity, and wind speed data from two heights to simulate the latent heat flux into the snow surface and subsequent surface hoar formation. The calculated latent heat flux was always directed away from the surface if data from only one height were input to the SMAP model, even if the value for roughness length of momentum was perturbed between the possible maximum and minimum values in numerical sensitivity tests. This result highlights the need to use two-level atmospheric profiles to obtain realistic latent heat flux. Using such profiles, we calculated the SEB at SIGMA-A from 30 June to 14 July 2012. Radiation-related fluxes were obtained from in situ measurements, whereas other fluxes were calculated with the SMAP model. By examining the components of the SEB, we determined that low-level clouds accompanied by a significant temperature increase played an important role in the melt event observed at SIGMA-A. These conditions induced a remarkable surface heating via cloud radiative forcing in the polar region.

Sign in / Sign up

Export Citation Format

Share Document