Pollutant emissions from vehicles with regenerating after-treatment systems in regulatory and real-world driving cycles

2008 ◽  
Vol 398 (1-3) ◽  
pp. 87-95 ◽  
Author(s):  
Robert Alvarez ◽  
Martin Weilenmann ◽  
Philippe Novak
Keyword(s):  
Real World ◽  
Pollutant Emissions ◽  
Driving Cycles

A fleet-prediction oriented catalyst model for highly transient driving in cold and hot mode conditions

2012 ◽  
Vol 13 (5) ◽  
pp. 497-513 ◽  
Author(s):  
Martin Weilenmann ◽  
Dimitrios N Tsinoglou
Keyword(s):  
Real World ◽  
Catalytic Converter ◽  
Cold Start ◽  
Catalyst Design ◽  
Pollutant Emissions ◽  
Oxygen Storage ◽  
Catalytic Converters ◽  
Driving Cycles ◽  
Wide Range ◽  
Oxidation Catalytic Converter

Various models for simulating catalytic converters are given in the literature. They deal with a wide range of different aspects. In addition to the type of catalytic converter (three-way catalytic converter, diesel oxidation catalytic converter, etc.), the aspect of complexity versus accuracy and speed can be tackled using different approaches. Moreover, the desired use has an influence on the model structure: optimization of catalyst design or prediction of emissions from real-world traffic situations or optimization of air–fuel ratio control? The model described here has been developed to predict emissions in arbitrary real-world driving patterns, both for hot driving as well as for cold-start situations. As these tests mainly last over 30 minutes (real time), the calculation effort should be small. The model should be easy to parameterize, as it should be applicable to vehicles from traffic. A model with a reduced set of chemical reactions has been developed with a particular focus on the thermal balance for cold-start cycles. Its outputs are the pollutant emissions at the tailpipe if the emissions, exhaust mass flow and temperature from the engine are given. It is applied to three-way catalytic converters. It models the chemical phenomena almost entirely based on oxygen storage and release reactions, which dominate highly transient situations. The model has been validated against a large database of measured driving cycles, carried out using different types of cars. It presents an acceptable degree of correlation between simulated and experimental results.

Effects of biodiesel on passenger car fuel consumption, regulated and non-regulated pollutant emissions over legislated and real-world driving cycles

Fuel ◽  
2009 ◽  
Vol 88 (9) ◽  
pp. 1608-1617 ◽  
Author(s):  
Georgios Fontaras ◽  
Georgios Karavalakis ◽  
Marina Kousoulidou ◽  
Theodoros Tzamkiozis ◽  
Leonidas Ntziachristos ◽  
...  
Keyword(s):  
Fuel Consumption ◽  
Real World ◽  
Pollutant Emissions ◽  
Passenger Car ◽  
Driving Cycles

Real-world European driving cycles, for measuring pollutant emissions from high- and low-powered cars

2006 ◽  
Vol 40 (31) ◽  
pp. 5944-5953 ◽  
Author(s):  
Michel André ◽  
Robert Joumard ◽  
Robert Vidon ◽  
Patrick Tassel ◽  
Pascal Perret
Keyword(s):  
Real World ◽  
Pollutant Emissions ◽  
Driving Cycles

Modeling the emissions of rural vehicles based on real-world driving cycles

2021 ◽  
pp. 148380
Author(s):  
Yi Li ◽  
Di Peng ◽  
Lei Zu ◽  
Mingliang Fu ◽  
Yao Ma ◽  
...  
Keyword(s):  
Real World ◽  
Driving Cycles

Comparative study of real-world driving cycles, energy consumption, and CO2 emissions of electric and gasoline motorcycles driving in a congested urban corridor

2019 ◽  
Vol 45 ◽  
pp. 619-627 ◽  
Author(s):  
Triluck Koossalapeerom ◽  
Thaned Satiennam ◽  
Wichuda Satiennam ◽  
Watis Leelapatra ◽  
Atthapol Seedam ◽  
...  
Keyword(s):  
Energy Consumption ◽  
Comparative Study ◽  
Co2 Emissions ◽  
Real World ◽  
Driving Cycles ◽  
Urban Corridor

Assessment and design of real world driving cycles targeted to the calibration of vehicles with electrified powertrain

2021 ◽  
pp. 146808742110387
Author(s):  
Stylianos Doulgeris ◽  
Zisimos Toumasatos ◽  
Maria Vittoria Prati ◽  
Carlo Beatrice ◽  
Zissis Samaras
Keyword(s):  
Real World ◽  
Simulation Models ◽  
Cost Effective ◽  
Operational Parameters ◽  
Virtual Design ◽  
Passenger Cars ◽  
Real World Data ◽  
Vehicle Simulation ◽  
Driving Cycles ◽  
The Impact

Vehicles’ powertrain electrification is one of the key measures adopted by manufacturers in order to develop low emissions vehicles and reduce the CO2 emissions from passenger cars. High complexity of electrified powertrains increases the demand of cost-effective tools that can be used during the design of such powertrain architectures. Objective of the study is the proposal of a series of real-world velocity profiles that can be used during virtual design. To that aim, using three state of the art plug-in hybrid vehicles, a combined experimental, and simulation approach is followed to derive generic real-world cycles that can be used for the evaluation of the overall energy efficiency of electrified powertrains. The vehicles were tested under standard real driving emissions routes, real-world routes with reversed order (compared to a standard real driving emissions route) of urban, rural, motorway, and routes with high slope variation. To enhance the experimental activities, additional virtual mission profiles simulated using vehicle simulation models. Outcome of the study consists of specific driving cycles, designed based on standard real-world route, and a methodology for real-world data analysis and evaluation, along with the results from the assessment of the impact of different operational parameters on the total electrified powertrain.

Sign in / Sign up

Export Citation Format

Share Document